Find experienced local tradies in Melbourne

Rendered wall needs rendering and painting to match extension wall

We’re looking for a professional tradesperson to install glass walls, plaster partitions, and an entry door in an existing office located in Melbourne CBD. The exact area and measurements can only be confirmed after an on-site inspection. Please include in your quote: Labour and materials (if available) Estimated timeframe for completion Availability for site visit Experience with commercial office fit-outs will be highly regarded. 📍 Location: Melbourne CBD 📅 Inspection: Required before final quotation

I can come to you with van l have roof racks and awning in boxes ready to be fixed to teardrop caravan.

I need a professional to wall-mount a 65-inch TV on a plasterboard wall in my living room. The bracket is already provided. The wall requires a stud finder to ensure secure mounting. Details: • TV Size: 65 inches • Wall Type: Plasterboard (stud finder required) • Bracket: I will provide the wall mount bracket • Location: [Insert your suburb or area] • Parking Available: [Yes/No] • Preferred Date & Time: [Insert your preferred time frame]

I have a first-floor timber awning window that isn’t sealing properly. The left side closes fully, but the right side has a small gap. The paint is flaking and the timber is weathered in places. Ideally: Fix/Service the Winder: Lubricate the winding mechanism. If needed, replace the winder. Repair & Repaint Timber: Remove loose/flaking paint. Sand smooth. Fill cracks or damaged timber (timber bog for deep damage, caulk for small gaps). Prime exposed timber and repaint with exterior-grade paint. Requirements: Must have experience with timber window repair and painting. Please bring your own tools and materials or advise if you need a materials list.

Its a motor and remote operated Awning and extends full. It just needs to be realigned and adjusted to the correct position as one side is tilted downword and its too low on full extension.

We have built a 2-room workshop in a brick factory. Builder will hang plaster sheeting, we need it stopped up. Stopped and sanded ready for painting. Clean up your own mess, skip available. Site inspection available. Measurements: 43m2 of ceiling (8.4 x 3.6 and 3.6 x 3.6) with joins and screws 15 lm sq set against old brick (vertical) 16 lm sq set against old brick (horizontal) 2.7 lm of external corner 4.8 lm of internal corner 30 lm of horizontal wall joins 20 lm of vertical wall joins We need this done next week.

Goal: widen a recessed pelmet within a plasterboard bulkhead so it extends to the wall. Task includes: • Inspect area for electrical wiring or structural framing before cutting • if no issues found, cut back and widen the bulkhead/pelmet section to extend the window opening to the wall edge • Patch and plaster for a smooth, paint-ready finish Apartment in Brunswick East. Flexible timing — please include inspection and quote (labour + materials).

Hole in plaster wall. We tried to fix, cover over and sanded but still sticking out

My retractable awning appears imbalanced when opening, with the right side hanging lower than the left. I’ve noticed that the metal pin on the right-side handle is loose and doesn’t seem to be installed properly. I need someone to come and fix it for me. You will need a ladder to reach out to the awning.

Need someone to assist with wall plastering base coat + top coat in 4 areas as shown in the photos

Need 2x 1m curved areas re plastered after they were ripped out with the skirting boards. Need the plastering to be secure as new skirting boards will be attached on the area later

Hi we have a hole that’s needing patched up in a gyprock sliding door it’s pretty thin but need the best job possible done, and also a couple of holes from screws from wall mounts and a bracket taken down. Thanks

Replace a double GPO in bathroom

Screw and secure one x power point

Rebuild timber frame and plastering for two walls. The back of the wall is shown in the photo. Removing the rubbish.

I have eight nails fixed into internal walls which need to be removed and the hole filled in. There are also four very small indentations on the wall (x2) and on an internal door (x2) which need to be filled in and smoothed over.

I need some basic plastering. I also need a bit of stud wall built 77cm x 268cm. The plastering can be quoted alone. See the attached images

I have an older tradie trailer that needs a repair to one of the hinges (see pictures). The hinge has rusted away.As a result, there's a small hole and the door doesn't shut properly. I am looking for someone to repair the broken bit.

Hi! I’m looking to get a 10amp outdoor weatherproof power point installed in my car port, to slow-charge my e-Bike/car. The previous owner also left some questionable wiring in the adjacent shed area (looks like a permanently wired in extension cord) - it’s probably not compliant. I’d like to get rid of this. Quote for supply and install please.