Find experienced local tradies in West Melbourne

We'd like to lower a small bulkhead (1350mmW x 1000mmL x 350mmD) in preparation for the installation of an AC unit. Looking for someone to complete the carpentry and plastering for this mini-project.

Hole in bathroom drywall

I need a quick repair on a damaged drywall corner in my apartment in West Melbourne. The corner was bumped, and the plaster has chipped off, exposing the metal corner bead underneath (see attached photo). Looking for an experienced handyman or plasterer who can fix this neatly. The previous contractor who fixed this did a bad job resulting in bad patchwork. Please let me know your availability!

Noticed water damage at bottom half of cupboard, not sure how best to fix whether it can be resealed or the damage cut out

hi there, i need someone to remove one side of the original plasterboard wall between 2 bedrooms so i can put in acoustic batts for soundproofing, then you have to replaster the wall. - ill need you to replaster with 2 layers of Gyprock CSR 13mm Soundchek™ Plasterboard RE from bunnings (i will reimburse you the cost of this) -repaint not required -you may need to come twice as the first time you come perhaps you can remove the wall so i can calculate how much acoustic batt is required, or can do it all at one time up to u (i will buy the acoustic batts) price is just random, pls provide me with your quote of removing and replastering wall ... wall is 3.5mx2.55m tall thx

I need to put a power point behind the range-hood. There is a junction box prepped in the wall

Require plastering repair to wall

Sand base coat, put on top coat

1 sheets plaster on ceiling. Easy access and i will assist hanging the sheet.

install double power point (you to provide) Replace existing ceiling exhaust fan with larger unit, (provided by customer) Install light dimmer switch. (you to provide)

Fix the wall with gyprock and paint the wall

I need plasterboard panels put on 2 walls in my studio. The longest wall measure 2420mm high x 5500mm wide. Next wall measures 2420mm high x 3800mm wide. Joints need to be sealed/smoothed over so the overall walls are smooth. Studio is located on second floor of a warehouse so the materials will have to be taken up some flights of stairs. The job would need to be completed on a Saturday. I’ll be onsite to let you in/help out if you need.

Scope of work: Replace 7 small bulbs with LED downlights Rough-in + fit off 1 new powerpoint

I need three areas of plasterboard and skirting board to be patched and repainted following recent mould remediation work.

There is chase already on concrete floor and need to make 3 power points using 25mm conduit. Power line can connect from the wall powerpoint

I need the mirrors fitted back into the aluminium (with rubber inserts) door frames on two wardrobe doors. The frames have separated from the mirrors along the vertical edges.

We have a built in wardrobe with extra storage above. Will need a shelf installed and a new opening above preferably with sliding door like doors. We want to use the extra storage. Happy to negotiate.

Looking for a plasterer to help with some renovations in my garage. The 2 walls are cement and I’m looking to have the utilities covered. See images below. Looking to have a wall built (1st) image to cover the entire wall. On the other wall I’m looking for a cover over the pipe. This would be partial cover (to measurements provided). I’m looking to have some cabinets made to cover the rest of the pipe.

2 power point switches not working and need replacing

We have tried to mount the TV ourselves, but we are having trouble with the metal stud locations. We have drilled a few holes into the wall but some of the holes seem to have not gone through studs despite triple checking with a stud finder and magnets. We are quite confused and at this point would like some help. If the holes we have drilled end up not being used, it would be great if you could plaster over those holes as well if needed. We already have the TV mount.