Find experienced local tradies in Coburg

Internal renovation, plasterboard has been roughed in, needs final float, patch , sand and finish

We are renovating an old garage and need some plastering done. Existing plaster wall needs patching in a few places (see photos) sanded and ready for painting. Some damage holes, some from the sparky. Damage has been cut out from the wall so we need board hung and troweled in. Size is 1040 x 610 A long strip has been removed of the ceiling to allow for new framing and we need that section replaced and troweled in for panting. Size is 4700 x 600. Is also like insulation put back in (supplied) There is also some patching needed on the ceiling, where a narrow support timber column was for a now removed mezzanine, and some holes also where the old light and fan were; this is on the photos. I can only add 5 photos, I’ve tried to add in the best ones

Need to replace circuit on sauna. Looking for a reliable electrician who can service around Coburg area

I need one 11 kg Globe West mirror hung on a plasterboard wall in Coburg. The mirror has two D-rings on the back. Please supply suitable heavy-duty wall fixings and ensure the mirror is level.

Looking for a rendering worker

Plastering for all walls and ceiling of an outbdoor office specs can be found here www.stilla.com.au/products/peppertree-9x6?_pos=2&_sid=1b219fdee&_ss=r

Need a second hand oven to get the cut cables wired to be plugged on existing wall power point. Photos are of the existing wall plug with old oven and photo of the new oven wire that was cut. Not sure why it has two cables in it

I have an awning that I want installed on the wall of my house I have assembled it, but its too large to manage on my own. The awning is 3.6m long. I'm happy to assist with lifting it to mark up and then mount as required. The wall of the house is Hebel. I have a selection of fittings that should be enough for the install.

There is a hole in the wall from a damage behind the front door. Looking for someone experienced who can assist with doing a clean up and plastering job including sanding down to fix up/restore the wall. No re-painting required. It is close to the ground and around 10-15cm wide.

Looking for a quote for a domestic timber balustrade and handrail. The balustrade would have 3 sides to enclose a stairwell opening on the second story of a townhouse (3.2m x 1m, 1.1m x 1m, 2m x 1m approx). Handrail would be approx 2.4m long. Thanks

I need 4 x plasterboard approx 100mm holes patched. I need a section of approx 500x500 plasterboard that has warped from moisture damage to be cut out and replaced. All patches need to be finished flush for painting.

Fix awning window winder not closing properly Handle makes clicking noise and window won’t fully close. Likely needs winder repair or replacement.

We have a very cute wooden shed in our backyard but it’s just gathering dust. We’d love it to turn it into a home sauna. We have done lots of research, however don’t have the building skills to DIY this ourselves. we need to : - Seal the eaves/roof of the current shed - remove some of the shelves, etc that are in there already.( hopefully some of these materials can be used to build the seats.) - maybe replace 2 existing windows, unless we can get the glass replaced with tempered glass. - line the interior with special insulation and heat reflective foil - line with wooden planks - Remake the seats We will do all the sanding and painting, etc and organise the electrician separately. Would hopefully love to find someone who has ever made a sauna before if that’s at all possible! Otherwise we anticipate it would be about three-four full days work all things going well Budget $10 for a quote

Hi, I need to repair a damaged awning at my barbershop. Scope of work: - Remove broken/damaged section of the awning - Reinforce or rebuild the front structure if needed - Install a new metal sheet (simple and strong finish) Important: I don’t need a full replacement or aesthetic finish. Just need it safe, solid and functional. This area will be covered with signage later. Location: 112 Bell St, Coburg Looking for someone experienced in metal, roofing or handyman work. Please send your quote 👍

Install a bulkhead over kitchen cupboards to hide rangehood exhaust Length approx 2.4 metres and from ceiling to cupboards around 510mm

Looking for a quote to replace x2 power points at a residential home in Coburg. -Replace existing damaged outlets -Testing and compliance checks -Certificate of Electrical Safety provided Power point units will be supplied. Must be a Licensed electrician and fully insured. Clean and careful installation with removal of any waste or debris.

20sqm of walls needing to be set, angled and cornice. Jointing to older plaster in some spots. 5sqm of ceiling as well. All in prep for paint. Also potential for more work upon inspection of the job

Looking for a licensed electrician to do a full electrical inspection of a 3 bed, 1 bath, 1 dining/kitchen, 1 lounge house. Old house so not that many sockets. About one socket and one ceiling light per room. + Relocate a power point 2/3 meter from existing socket. Existing socket is in the skirting board. Please see photo. Please provide quote. Thank you!

We need a small wall to be plastered before our vanity can be installed on Thursday.

The existing render on our capped brick chimney is starting to crack and let water in. Need somebody to re-do it to keep things watertight. Would also be great if you could remove the old TV aerial while you’re up there.