Find trusted local electricians in Coburg

Replace existing lights with 3 pendants lights, and swap existing light switches with dimmers. Pictures of 2 lights supplied, one will need a ladder as it's on stairs

Need a licensed electrician to: * Redirect the ceiling light-switch wiring and install the switch on the nearby wall. * Move the exposed switch shown in the second photo to the opposite side of the wall. Wall framing is open for easy access. Quote must include labour, basic materials, testing and safety certificate. Location: Coburg Budget: $350

Install downlights in bedrooms to replace old lights as shown in picture. Installed on same, existing switch where possible. Looking at installing 4-8 lights. Licensed/certified professionals only.

Hi, I need a licensed electrician (REC) to install a GWM 7kW home wall charger that came with my car. The Setup Switchboard: Located at the front entrance of the house.Garage/Charger Location: Located at the back of the property. Cable Run: Will require running a heavy-duty cable from the front switchboard to the back garage (happy to discuss the best route via roof, underfloor, or external conduit during quoting) Future Proofing: I plan on installing solar panels in the future. I need advice on whether my current switchboard has enough space or if we should install a small sub-board in the garage now to make future solar hookup easier. Requirements:Must be a fully Registered Electrical Contractor (REC). Must provide a signed Certificate of Electrical Safety (CES) upon completion. Please include the cost of materials (cable, conduit, circuit breakers/RCD) or let me know if you need to inspect first. Please reply with your REC number and how you would prefer to handle the cable run. Thanks!

Need a licensed electrician to supply and install a smart EV charger at my home in Coburg for a 2023 Hyundai Ioniq 5. The property is above a restaurant and the car is parked at the rear car port (ground level) Its about 20+ metres from the switchboard to the location of the charger. Wiring can run internally along an existing duct/conduit. I'm looking for a charger that can: Schedule charging during off-peak electricity hours

9 downlights need replacing

Looking for a licensed electrician to connect our internally illuminated LED signage to power at our martial arts academy in Coburg. * Connect LED sign to existing power * Install/connect transformer if required * Neatly secure wiring * Test and ensure everything is working safely Please only apply if you’re a licensed electrician with commercial signage experience. Location: 293–295 Sydney Road, Coburg Budget: $220

Need 2 power points installed around the house. - front room: 1x recess power point for tv - kitchen: 1x power point dropped below another for dishwasher installation. - other power points located close by - walls are plasterboard - double storey house (only at rear/kitchen) front room there’s nothing above.

Hi I need a few odd jobs done that I'm not confident in doing myself. I have a few covers that need to be looked at. Please note all the electricity is working. The covers just need to be replaced. A fan unit in the bathroom needs to be replace as it's extremely noisy and hanging off. I have ordered the clipsal unit so it's already to go I have a globe to be put in as well. My bathroom is a big old mess due to someone that smashed it up so need someone that is non judgemental that can look past that also! Please note the 3rd last photo - I tried to screw this one back in but there was nothing to screw back into so need someone with know how to fix this. I have ordered a new light fitting to replace the last photo. Not arrived yet but should be coming any day. Happy to answer questions!

Looking to install a new feed for an electric oven (15 amp) & an induction hob (32 amp) so I can remove gas appliances.

Looking for a licensed electrician to install three pendant lights in a single-storey home in Coburg/Brunswick. Scope of works: * Bedroom 1: Remove the existing ceiling light and install a new pendant light in a different ceiling location (wiring to be relocated). * Bedroom 2: Remove the existing ceiling fan/light and install a pendant light in its place. * Kitchen: Install a new pendant light in a new location where there is currently no light fitting (new wiring required). Additional information: * All three lights are to be installed on dimmer switches (existing switches are standard switches and will need to be replaced). * Single-storey house with good roof access above all three locations. * Plasterboard ceilings. * Pendant lights have not yet been purchased, so the installation will take place once fittings have been selected. * Please remove and dispose of the existing light fitting and ceiling fan. * All work to be tested and completed by a licensed electrician. Please provide an indicative quote for the installation and any assumptions made. Happy to provide photos or arrange a site visit if required. See images below: Switchboard Bedroom one existing ceiling fan and switch/dial for fan (new pendant installed in same location as fan) Bedroom two existing pendant (new pendant to be installed in different location)

Looking for a licensed electrician to replace the light switches and power plugs in our house. I have the plugs and switches already (Clipsal Iconic), so just just need direct replacement of existing with the new ones. 20x power plugs - Clipsal iconic (supplied) 16x light switches - Clipsal iconic + LED modules to be installed. (Supplied) COES needs to be supplied for works. Looking to get them done this week or next week, whenever suits.

I have purchased 4x power outlets with inbuilt USB sockets. 3 of them are to replace existing simpler outlets, and one of them is to replace an existing light socket (I'll be replacing the light with a USB powered light here utilising the new outlets). No new wires need to be run. Need to be a licensed electrician as I'll need a work certificate. Price negotiable.

Qualified A Grade electrician with a valid REC required to: 1) relocate/move 2 existing power points higher on the wall/plaster board, around 240mm from the floor. The power points are currently on the skirting board which will be getting replaced. 2)Install a new power point with USB C & A in another room, the closest power point to the 'new' power point is about 3m away. Must provied a COES.Note- It is an older house on stumps and is very low to the ground. Refer to circled area in the images for the ‘new’ power point locations

Need electric connection to two light boards, possibly with timer to ON and OFF Light boards are existing

Wire a scone onto wall and add a switch with dimmer. Wall is plaster.

Wanting to replace inline electronic dimmer switch with inline mechanical on/off switch in 2 pendant light fixtures. Do not have the mechanical switches.

We require a number of electrical jobs completed at our house, as follows: * Install 4 new downlights in bedroom (supplied), including measuring and cutting new holes in ceiling. * Disconnect/remove existing pendant light in bedroom * Replace pendant light in living room (supplied) * Install new data port between NBN access point and bedroom (~15m) Flexible on date/time but want this done fairly soon. More details provided on request!

Wire pendant between two existing downlights. I can install hook and reinforcement to mounting in plaster. I need someone to: -run cable presumable from exisiting down light same switch -wire pendant -provide electrical certificate for work done

Need to keep wiring clear from branches