Find trusted local electricians in Port Melbourne

I have a mounted ceiling fan externally wired in conduit on ceiling that needs power hooked in. It is operated by remote control. Switchboard in bedroom. No ceilings in bathroom as the slab is the ceiling. Then I have a four gang bathroom switch that operates a main light. I need it wired to also operate a fan and a separate heat lamp. 2.5mm calling has been roughed in. I have new gangs, 12 meters of extra 3 core 2.5mm, conduit and clamps hangiyogf of ceiling. Full access as bathroom is waiting for cabinets for walls and bulk head. Full access non time restricted parking.

3 smoke alarms in 3-storey townhouse (one on each level) need replacing by an electrician. Alarms (same or equivalent to picture attached) need to be purchased/supplied and installed by certified electrician as they are hard wired. Old (current) alarms to be disposed of.

Need 1 power point and 1 antenna moved to middle of the wall. Tv mounted with bracket (already have) Tv hung

Install 2 new outdoor outlets, replace overhead lighting, replace 2 ceiling fan, replace motion detection light.. I will be able to assist

Bathroom Exhaust fan in apartment building not working after 24 years

My Airbnb house at Port Melbourne has oven issues. It's warming but not getting to high temperature. I need someone to inspect it and repair if it needs be.

Need help asap to connect TV and nbn. Have coaxial cable which connects to ANT input from TV to walk but TV is showing no signal.

Replace broken switch and changeover 3 power points

Eelectrician to provide electrical tag testing compliance for using some table lamps lighting TV and someone for Expo

Doing a campervan conversion and need to mount solar panel on roof racks - no electrical required just mount solar panel and feed cables through to van interior.

The front passenger electric window won’t go up.

SCOPE HAS BEEN UPDATED, no longer a full rewire. Electrcian needed this week to; 1. Run 9 circuits from new sub board to kitchen / living room. Holes have been cut in ceiling to check route, will need hole cut through 1 floor joist otherwise route from sub-board to kitchen is clear. Client will repatch holes in ceiling. Circuits are; - 4 power circuits 7m in length - 2 lighting circuits 7m in length - 1 power circuit 13m in length - 1 x 15amp pool heater circuit 13m in length - 1 x 32amp car charger 20m in length to be run but not commissioned (will be done later by others). 2. Run new circuit from sub board and install new IXL tastic in bathroom. Will need to cut hole in wall. 2m run. 3. Install 3 new ceiling fans / lights (fans provided by by client). 4. Install 2 new smoke detectors (supplied by client) 5. Install 1 new GPO with 2m surface conduit. 6. Changeover 10 light switches and 11 GPOs to new faceplates supplied by client. Electrician to supply cabling, surface conduit. client to supply fans, GPOs, light switches and 3in1. Layout and pictures attached. - Due date: Before Thursday, 15 February 2024

New LED bulb not connecting - Due date: Needs to be done on Sunday, 4 February 2024

Rear passenger electric window will not go up or down - Due date: Needs to be done on Saturday, 3 February 2024

I am looking to change 9 dimmable and 5 non dimmable down lights from the old type with transformer to the simple switch type. - Due date: Flexible

Need someone to assemble the electronic desk we have 6 of these desks to be assembled - Due date: Before Sunday, 4 February 2024

I have few plug to move or remove, and maybe some extra job after this job - Due date: Needs to be done on Thursday, 4 January 2024

I purchased this lamp and realised that the ends are misaligned. - Due date: Before Thursday, 21 December 2023

Suspect there is either a short in the wiring in the chair or a component has blown. The power cable works okay with the other chair - Due date: Flexible

This is all is my home Studio, in my living room in an apartment. I need 3-4 power points. Run cable across room, over the ceiling . - Due date: Before Monday, 11 December 2023