Find experienced local fencing contractors in Coburg

On our existing boundary fence, two posts have started to lean. These need to be replaced with new fence posts, concreted in. The first fence post shown in the photos is full height. Here, it would be acceptable to fit a new fence post close to the existing one, eliminating the need to remove the existing post. The second post is shorter and close to the front boundary. Here, it will be necessary to remove the existing post and replace it with a new one. Posts need to be hardwood of the same size as those posts being replaced. The postholes will need to be dug to at least 600mm below ground. Looking for a quote including materials and all labour required to finish the job, and removal of old materials.

Looking to get a fence installed as well as a motorised gate. I’ve included a photo of the type of look/ finish we’re looking for. We have a certain budget in mind but are flexible.

Replace posts and realign or replace bottom timber piece on 5.3m picket fence.

Our fence is currently leaning. Only the back section with three posts are affected. need three posts replaced as they are coming out of the ground. They will need to be concreted and with standard minimum depths.

We need a section of this timber fence removed at the back of our property, which faced onto a laneway. Gate must open inwards. Looking for a secure, lockable privacy gate in monument grey colorbond with steel frame, concreted in. Just a pedestrian gate, just next to the shed we are modifying in the photos. . Gate to be 1800 x 1200 wide Access is easy from the laneway. this is both to supply and install.

Need to either improve the anchors / support for existing timber fence posts (2m high and about 20m. In length) or build support trusses to avoid the fence collapsing in the short term. Likely to Replace the fence in 1-2 years so need an interim solution. Suggested rate is labour only - willing to provide materials or pay in addition. Looking for a qualified individual only

Need some repairs done to the front fence. We have purchased some pickets but need them replaced. Also interested in a quote to re do the whole lot.

Boundary brick and steel fence is leaning and may require repair or partial rebuild. If rebuilding is required, it would apply to the brick section only; the steel fence section would require repair. The first two photos show the section that needs attention. The third photo shows the longer fence for reference, so you can see how the repaired section should match (this section is outside the small gate). Please provide a quote for repair/rebuild and advise whether repair is feasible or if partial rebuild is recommended. Licensed bricklayer or experienced fencing contractor only. Thank you.

I am attaching some pickets to an old steel gate. I have neither the time, patience or skill to get it right I do have is the pickets, self tapping screws washers for someone else to complete the job for me. It should be pretty straightforward for someone that can confidently drill pilot holes and accurately lineup the pickets across both gates

Install a new gate latch and lock (provided) on a metal gate and wooden post. Metal gate will need some new holes drilled.

Remove existing timber fence and install new timber fence using same or similar timber. Fence size is roughly 10m x 5m, and 6ft tall.

Need a 10.5m, a 3m and a 5m timber fence replaced at my property after fire destroyed old fence. Standard height. Need three separate quotes.

Looking for someone to demolish/remove and dispose of an old 23-metre timber paling fence (approx. 2 m high) as shown in the photo. The fence is leaning and needs to be completely taken down and taken away. I’ll be building a new one myself afterward. Please provide two quotes 1. Full job: Removal and disposal of all fence materials. Thanks Michael

4 posts in particular are leaning from the neighbouring property. Hoping to get it back upright and sturdy.

Move a fence post and make it look nice in keeping with the rest of the fence. There will need to be some concrete cut to make way for the new post. I’ve had to put $50 as it doesn’t allow me to put 0. Please reach out and quote me on what it’ll cost. I can get the post.

Approx 5m fence requires removal and replacement, good access on both sides. Replace with timber

The fence I share with my neighbour is leaning into their property. I need someone to remove the 4 or 5 fence panels, dig up the exisiting post and concrete them back in straight then reinstall the panels.

Hi, we need a temporary cover installed over our pool while some building works take place, so that it is not a safety risk. It will need to be a sturdy cover and secure so that no one can fall in the pool. Size is 2.4m x 4m. Photos attached.

I need the removal and disposal of a brick fence and the foundation / footing. This includes 2 metal gates (see photos) Brick fence - approx. 9m x 1.3m Two Steel gates - approx. 2m wide Footing/foundations- not sure how deep, but was built in the 1960's if that helps, ready to install a new fence. **Apologies as I posted this but had to cancel as I forgot to add photos and additional info. Please resend quotes if you sent through yesterday

i want to remove the current pickets and replace with new ones. My front fence is about 12 m long. The pickets are currently different heights and i want them to be all the same height as the current tallest picket 150cm. I don't care if the the pickets have a rounded top instead of current pointed top. This includes the small gate that is in the fence, which may need to be adjusted . I will paint it myself, but if you can supply primed pickets that would be great. I need this done fairly soon if at all possible.