Find experienced local roofers in Inner South Melbourne

Clean gutter 2 bedroom single level unit. Easy ground level ladder access Mostly pine needles in gutter Last cleaned in February 2026 Mow Small backyard - patchy grass 10m x 3m

Water balloons have melted onto the outdoor tiles. Need to remedy to remove and clean

Roof painting in Monument Likely needs pressure wash then 2 coats of paint Gutters and windows have already been completed.

Looking for an experienced and insured gutter cleaner to clean the gutters and downpipes across the entire multi-unit property, as shown in the attached roof plan. Scope of work: Remove all leaves, dirt, debris and built-up sediment from all accessible gutters. Clean gutters across all roof sections and units, including connecting sections and lower roof areas. Clear accessible rainwater heads (RWH) and downpipe inlets (DP). Check that downpipes are flowing freely and flush with water where practical. Remove all collected debris from the property and leave the site clean. Notify me of any blocked outlets, damaged gutters, leaking joints or other issues identified. Provide before-and-after photos of completed work. Requirements: Suitable equipment and safe access for multi-level and interconnected roofs. Experience with gutter cleaning on multi-unit properties. Public liability insurance and appropriate working-at-heights safety measures. Please provide your fixed price, availability and details of any access equipment included. The attached roof plan shows the approximate roof layout and marked drainage points. Please inspect the scope carefully before quoting. Please quote for the complete job, including labour, equipment, debris removal and GST where applicable. No repairs or replacement work required unless separately approved.

I have a patio that has a Perspex/plastic shade/rain protection sheets as a ceiling between timber supports. I would like 6 of them removed. I am away and my wife tried to remove one using a jigsaw. It was easy to cut but made a mess and she doesn’t have time to the Job and to make it neat and more worryingly she doesn’t know how to use power tools safely 😬 You can either unfasten it and pull them out or cut them out. I would expect someone knowing what they are doing to take about an hour to do it. Sheets are made of hollow rectangular prisms about 7mm in diameter. The sheets are about 1m wide and 4-5m long. They can be left onsite in the garage shed. Patio is getting renovated after summer so doesn’t need to be perfect. Must take out via dissembling or cutting and then making the edges neat. Must vacuum afterwards if you cut them out as the plastic sheets are brittle and splinter everywhere. 2 ladders there to do the job.

I have a single story house in Chelsea Heights. 3 bedroom 1 bathroom. I need the roof cleaned for the main house and pergola. Id also like to get the main house roof painted

replace valley, rebed and point ridge capping

Install a roof anchor, see the photo attached. Labour only, anchor is ready.

Need clearing nest under solar panels. Supply and install bird proof mesh for solar panels. Double storey house, metal roof

Cleaning of gutter for a double story house

Looking for an experienced roofer to inspect a small single-storey garage roof, approximately 3.5m × 6.1m. The garage currently has an exposed ceiling/roof structure, so the underside of the roof and timber framing is easily visible. I am planning to install insulation and a plasterboard ceiling and would like the roof inspected first to confirm that it is watertight. Please check the roof sheets, fixings, flashings, gutters and any potential water-entry points, particularly around areas where some timber has dark staining. This task is for inspection and diagnosis only. If repairs are required, please provide a separate quote before carrying out the work.

Roof is leaking, the metal has corroded in parts, it has been siliconed but still leaks. Some panels will need replacing. The garage is 9m x 3m

Supply and install roofing seal paint to the allocation box gutter around 8m in length 3-4 coats - see photo 2. Supply and install additional flashing to the water collection box gutter to allow water to fall correctly see photo with the down pipe - plus do whatever will bring this box gutter up to code see photo 3. Supply and install new downpipe spreader to allocated rainhead - it’s a little short see photo 6.

Few roof tiles broken need to be fixed asap

to install starlink on the roof of my house

I have an upstairs tiled balcony with a large aluminium sliding door. There is a visible gap and deterioration along the bottom of the door frame/threshold only, and I believe water is getting through this area and leaking into the ceiling downstairs. I’m looking for someone experienced in balcony waterproofing, sliding door thresholds and water ingress repairs to properly diagnose and repair the issue. There have been previous attempts to seal the bottom of the frame with silicone or similar material, which has now deteriorated and separated. This old material will likely need to be removed and the area properly cleaned back before repairing it. I do not want another layer of silicone applied over the existing problem. I’m looking for a proper long-term repair that addresses how water is getting underneath the bottom of the frame. I would strongly prefer the door and frame to remain in place if possible. The frame is solidly plastered into the wall internally and the external render finishes directly against it, so removing the whole frame would create considerable additional work. Job to include: * Inspect the bottom threshold/frame only and identify where water is entering * Remove failed silicone/sealant and previous repair material as required * Inspect the junction between the frame, balcony tiles and waterproofing * Repair/reinstate suitable waterproofing, flashing, membrane or sealing as required * Neatly finish the area and water test if practical There are no known issues with the top or sides of the door. Photos are attached and I can provide additional photos, video, measurements or details if required. Location: Carrum, VIC Please respond if you have experience with balcony door threshold leaks and waterproofing, rather than general silicone/caulking work.

We’ve recently noticed some water staining/discolouration on the ceiling in our front living area near an external wall/window. Looking for an experienced roofer/roof plumber who may be available today to inspect and identify the source of the water ingress. Ideally looking for someone who can: * Inspect the roof, tiles, flashing and guttering above the affected area * Identify the likely cause/source of the water ingress * Take a few photos of what is found before carrying out any work * Repair the source on the spot if it’s reasonably straightforward * Provide a brief description of what was found/repaired and an invoice The gutters and some of the roof area were pressure washed approximately two weeks ago. I’m not sure whether this is related, but mentioning it as part of the history. Photos of the ceiling staining attached. Bentleigh East. Ideally today if availability permits. Please let me know your availability and relevant roofing/roof plumbing experience.

I’m looking for an experienced renderer to repair and re-render part of an exterior wall on an upstairs balcony in Carrum. Recent roof and gutter repairs around this wall have left some of the foam backing exposed near the top. The wall is approximately 3.2m high. The left section is about 97cm wide and has foam backing behind the render, while the adjoining section to the right has brick backing. There was previously a crack in the foam-backed section as the house settled, around the point where the different substrates meet. This was temporarily patched and painted, but I would now like the area properly repaired and re-rendered. My preference is to: 1) Re-render just the foam-backed section on the left, from top to bottom, rather than the entire wall if practical 2) Properly repair the exposed foam and previous cracked area 3) Include an expansion/control joint where the foam-backed and brick-backed sections meet if this is the appropriate way to prevent future cracking 4) Match the existing rendered texture and Colorbond Monument colour as closely as possible The entire two-storey wall is likely to be repainted shortly afterwards, so an absolutely perfect colour match isn’t essential. Access is from the upstairs balcony. Photos show the wall, exposed foam, previous repair and approximate dimensions. Please include all materials and let me know your proposed repair/rendering method when quoting. I can provide more photos if needed.

Fix the gutter metal so it goes flat across my driveway and permanent

Seeking a painter for a roof-only job — specifically the area marked in pink. There is furniture on-site; I'm fine with it being covered in plastic for protection during the work.