Find experienced local roofers in Inner South Melbourne

Clean all gutters around house particularly above garage and pipes for debris take before and after pics

Repair a leak in the roof of an outdoor sauna ( corrugated iron )

Looking for an experienced and properly equipped person to clean the roof, gutters and downpipes of our double-storey home. The property has a metal roofing system, and the job would include: Cleaning leaves, dirt and debris from the roof Cleaning all gutters Clearing and flushing downpipes Checking that gutters and downpipes are draining properly Removing and disposing of all debris from the property As this is a double-storey home, please only apply if you have the appropriate equipment and experience working safely at height. Please include in your offer what is covered and whether you have insurance.

Need gutters cleaned single storey 2 bedroom house. 1950s brick with terracotta tiled roof

Few roof tiles broken need to be fixed asap

Scope of Work: 1) Rear Timber Fascia: Prep and apply 2 coats of low-sheen exterior paint to the back timber fascia board (approx. 13m L × 40cm H). Paint to be colour-matched to existing timber finish. (Refer to attached photo highlighted in red). 2) PVC Downpipe: Prep and apply 2 coats of matching exterior paint to the newly installed PVC downpipe at the rear alfresco. (Refer to attached photo). 3) Materials & Surface Prep: Includes standard surface preparation (cleaning/light sanding where required) and all necessary paint/materials. The quote should cover both labor and material costs. I don't have the exact color code, but you are welcome to inspect the property in person to match it.

I need 5 downpipes connected. The downpipes are already in place they just need connecting to an already in place stormwater pipe. 1 of the downpipes needs fitting to the connection approx. 1m away and has another temporary down pipe already going into the same connection

Assemble and install a 3.0 m × 3.0 m gable-roof EasyShed kit (product link provided). Kit will be on-site. Required work: unpack and assemble full kit per manufacturer instructions; bolt/anchor shed to existing concrete slab (see photo) using suitable anchor system into concrete (bolt or chemical anchors as quoted); remove and dispose of packaging and offcuts; ensure shed is levelled and sealed to prevent water ingress. Site notes: concrete slab in photo is approx 3.0x3.0 m with timber garden edging around one side; Access: standard backyard access; some vegetation and fence near slab - see photo. I have already ordered the anchors for concrete. Customer requests installer to remove packaging and take away waste. Product link: https://easyshed.com.au/products/ gable-roof-garden-shed-3m-w-x-3m-d-classic? variant=***94239.

I have an upstairs tiled balcony with a large aluminium sliding door. There is a visible gap and deterioration along the bottom of the door frame/threshold only, and I believe water is getting through this area and leaking into the ceiling downstairs. I’m looking for someone experienced in balcony waterproofing, sliding door thresholds and water ingress repairs to properly diagnose and repair the issue. There have been previous attempts to seal the bottom of the frame with silicone or similar material, which has now deteriorated and separated. This old material will likely need to be removed and the area properly cleaned back before repairing it. I do not want another layer of silicone applied over the existing problem. I’m looking for a proper long-term repair that addresses how water is getting underneath the bottom of the frame. I would strongly prefer the door and frame to remain in place if possible. The frame is solidly plastered into the wall internally and the external render finishes directly against it, so removing the whole frame would create considerable additional work. Job to include: * Inspect the bottom threshold/frame only and identify where water is entering * Remove failed silicone/sealant and previous repair material as required * Inspect the junction between the frame, balcony tiles and waterproofing * Repair/reinstate suitable waterproofing, flashing, membrane or sealing as required * Neatly finish the area and water test if practical There are no known issues with the top or sides of the door. Photos are attached and I can provide additional photos, video, measurements or details if required. Location: Carrum, VIC Please respond if you have experience with balcony door threshold leaks and waterproofing, rather than general silicone/caulking work.

We’ve recently noticed some water staining/discolouration on the ceiling in our front living area near an external wall/window. Looking for an experienced roofer/roof plumber who may be available today to inspect and identify the source of the water ingress. Ideally looking for someone who can: * Inspect the roof, tiles, flashing and guttering above the affected area * Identify the likely cause/source of the water ingress * Take a few photos of what is found before carrying out any work * Repair the source on the spot if it’s reasonably straightforward * Provide a brief description of what was found/repaired and an invoice The gutters and some of the roof area were pressure washed approximately two weeks ago. I’m not sure whether this is related, but mentioning it as part of the history. Photos of the ceiling staining attached. Bentleigh East. Ideally today if availability permits. Please let me know your availability and relevant roofing/roof plumbing experience.

I’m looking for an experienced renderer to repair and re-render part of an exterior wall on an upstairs balcony in Carrum. Recent roof and gutter repairs around this wall have left some of the foam backing exposed near the top. The wall is approximately 3.2m high. The left section is about 97cm wide and has foam backing behind the render, while the adjoining section to the right has brick backing. There was previously a crack in the foam-backed section as the house settled, around the point where the different substrates meet. This was temporarily patched and painted, but I would now like the area properly repaired and re-rendered. My preference is to: 1) Re-render just the foam-backed section on the left, from top to bottom, rather than the entire wall if practical 2) Properly repair the exposed foam and previous cracked area 3) Include an expansion/control joint where the foam-backed and brick-backed sections meet if this is the appropriate way to prevent future cracking 4) Match the existing rendered texture and Colorbond Monument colour as closely as possible The entire two-storey wall is likely to be repainted shortly afterwards, so an absolutely perfect colour match isn’t essential. Access is from the upstairs balcony. Photos show the wall, exposed foam, previous repair and approximate dimensions. Please include all materials and let me know your proposed repair/rendering method when quoting. I can provide more photos if needed.

Fix the gutter metal so it goes flat across my driveway and permanent

Seeking a painter for a roof-only job — specifically the area marked in pink. There is furniture on-site; I'm fine with it being covered in plastic for protection during the work.

Hi, I have one roof tile that needs to be cut and refitted. It’s a small job—just one tile—and I’m offering $100 for the cut and installation. If you’re available, please let me know when you could come by. I work Monday to Friday, so I’d need the job done before 8am or after 5.30pm. If you prefer Saturday or Sunday, I can be flexible. Thanks, Sonia

I need a 2000L water tank and pump disconnected and removed, and the existing roof gutter downpipes reconnected to the stormwater drainage system. Details: - 2000L S-Line water tank - Zenox ZPS800 pump with Hyjet Controller - Both the water tank and pump are currently in working order - The tasker is welcome to keep/reuse the water tank and pump after removal - Very easy removal access — the tank is approximately 5 metres from the front driveway, with access through the garage - Reconnect the roof guttering/downpipes to the existing stormwater drain after the tank is removed

I need a 360 litre roof pod put on my roof racks with 4 x U bolts, I can help, it needs a spare pair of hands, the pod is super light and easily lifted by one person. I also have a set of window deflectors to put on, they come with their own tool. May need a spanner for the roof box to tighten the nuts and a foot stool to easily access the top. Happy to come to you if near Moorabbin. These are to go on my small Fiat Doblo van. I imagine all up it will be half hour to under an hour to do.

Looking for an experienced roofer to supply and install a new roof for a L-shaped pergola structure. Current Status: • The timber framing and posts are fully built and ready for roofing sheets/battens/ flashings. • Site is located in Hampton Pergola Dimensions (L-Shape): • Main long edge: 9,910 mm • Side long edge: 7,400 mm • Depth/Widths: 2,550 mm & 2,500 mm (Please refer to the dimension sketch attached). Scope of Work: • Supply and install roof purlins/battens (if required). • Install roofing sheets + wall apron flashings + capping. • Supply and install guttering and downpipe setup. Roofing Preference: • We are currently deciding between Full Polycarbonate Sheets (e.g., Laserlite 3000) vs A Combination of Colorbond + Polycarbonate skylight strips. • We would welcome your professional advice on site regarding light, heat insulation, and aesthetics. Requirements: • Experienced with outdoor pergola roofing, flashing, and gutter installation. • Must have own tools, safety equipments, ladder/scaffolding Image 1 is rough sketch of the size Image 2-3 are current structure Image 4-5 are what kind of effect I want (welcome your expert opinion) This is a task to look for the right person to come onsite to provide quote based

I have a skylight in my kitchen which is not really good for anything except leaking when it rains. I need someone to remove the skylight and the walls of the vent that go down to the ceiling. Then I need you to re-tile the space where it was, leaving it waterproof. I have spare matching tiles and can provide these if it makes the job easier to quote. The size of the skylight would be about 900x900 and the space requires about 12 tiles to be installed. See photo. The re-plastering of the internal ceiling in the kitchen is not part of the job. It's a single story roof with decent access using an extension ladder.

There is a leak when raining - causes a leak in the kitchen / bedroom. Investigate and fix