Find experienced local tradies in Fitzroy North

Plaster in the fireplace to prepare for painting. The second area is a brick chimney wall that needs cleaning and the plaster removed at the top near ceiling neatly finished and all prepped for painting

Hi just after a power point change over, you need to supply the power point

I need someone to mount a sensory swing onto the high awning outside for kids to play. The person needs to be able to make sure it is secure and weight bearing (ie on a support beam). I have the mounting plate and fabric swing. See link here: https://myneurocalm.com.au/products/swing-ceiling-mount I also included an AI image of where I want the swing.

After a renovation a couple of years ago, we altered the balustrades to accommodate a new nib wall. Since then they have been unstable and recently a section of the balustrades collapsed and need to be securely reinstated. I haven't measured the affected area but I think it's 1.5-2 metres long. All the existing balustrades are in tact so replacements pieces are not required.

I need someone to carfully dismantle a sauna (which came in flat panels) and stack down stairs in the carpark (I have trolley and lift). I have a cordless drill. Here’s the usual order: 1. Turn off and unplug * Disconnect the power. * Remove any loose items (floor mat, backrests, accessories). 2. Access the electrical connections * Most infrared saunas have quick-connect plugs between panels. * Remove the roof panel first (or lift it slightly) to expose the wiring. * Unplug the connectors—don’t pull on the wires. 3. Remove the roof * Many roofs simply lift off once any retaining screws or clips are removed. * It helps to have a second person. 4. Remove the glass door * Open it to about 90°. * Support the weight while removing the hinge screws. * Set it somewhere safe on a blanket. 5. Remove the front glass panel(s) * If there is a fixed glass side panel beside the door, remove any brackets or screws holding it. * Lift it straight up if it’s sitting in a channel. 6. Remove the timber wall panels * The side and rear panels are usually held together with external clips or cam locks. * Release these one at a time. * Lift each panel vertically to disengage it from the base. 7. Lift off the base (if needed) * Once the walls are removed, the base can usually be carried separately.

I need two walls plastered. One has a thin steel floating shelf and the other has an extractor fan.

I need an experienced plasterer to re-plaster two big holes in the laundry in preparation for some cabinets to be installed. There are also a few small holes in the roof that need to be patched and one near the front door. The areas need to be prepared for future painting but painting is not required for this job. Please let me know if you have questions.

Repair ceiling plasterboard around light fitting after water damage . Light fitting will need to be sat back in place, plaster stopped and sanded ready for paint. No painting required.

We require a glass cutter to be mounted onto the wall in our studio. The wall it drywall, there are no studs, and just concrete/brick underneath, so it will need long masonry screws for it to go through the plaster and well into the brick wall behind. The mortar seems pretty soft in some areas so we just want someone who will be able to do this properly as it’s a heavy item (approximately 25-30kg) and there will be someone to help also. We have all the fixings and braces ready to go, it just requires holding and drilling in to make secure. Expect it to take no longer than an hour I hope!

Need someone to remove the render on this low brick fence, looking to refrain from any damage to the bricks underneath. Fence is 6m long and 400mm wide at pillars.

I have two built in robes in downstairs bedrooms that I would like extended upwards, so I can store bags / suitcases.

Fill in screw holes where curtain pole was hung. 6 sections where pole was hung along wall. Patch and paint

We need sandblasting of 18 steps, treads and associated balustrade. No idea about pricing, so please ignore the budget and quote as needed. Happy to do an onsite quote and go from there too.

Awning appears to have wound up incorrectly and now will not drop and lift as it should. It is 5 mtrs wide and runs in two vertical rails/channels

Disassemble an ihealth (found space) inferred sauna :)

Weekend thunderstorm led to leaky roof - will require a plasterer, roofer to come inspect, quote and repair ASAP please.

Areas on ceiling for plastering

My dad has an issue with his verandah. . The gutter has unclipped from the beam , and the beam has rotted in one section. Seeking repair of beam and reinstall gutters

Plaster 2x square holes in the drywall (approx 20cmx30cm). Plaster 2x holes in the drywall where lights used to be (approx 3cm diameter) Plaster and cover one rectangle hole in the drywall where light switch used to be (approx 5cmx10cm)

Rendering repairs to outside walls required. I need to talk to a renderer and then we can get a quote