Find an experienced handyman in Clifton Hill

Assemble Easyshed 3m x 1.5m Skillion Roof Shed Recommends 2 people Shed arrives 21 Oct Instructions recommended 2 people for assembly Instructions here https://3650449.app.netsuite.com/core/media/media.nl?id=1781537&c=3650449&h=yZ9lviwic4b_pl5S0L0PX6HIi_vrsoJSx2eyqnIWT_10R--E&_xt=.pdf

Looking for someone experienced in woodworking or MDF fabrication to measure, template and cut a set of boot lining panels for my 1978 Leyland Mini (single left-hand fuel tank). I'm after a complete set of panels, including the boot floor, sides, rear bulkhead and fuel tank cover. Ideally, the panels would be made from approximately 6mm MDF, accurately cut to fit the contours of the boot. I'm only after the bare MDF panels, as I'll be carpeting and finishing them myself. I can bring the vehicle to you for measuring and test-fitting if required. Located in Melbourne. Happy to discuss materials, pricing and availability. I am okay if you buy the material and include it in cost or I buy and give it to you I have some plans and have attached a picture where the panels will go after I carpet them

Install Perma timber swing baby gate at top of stairs.

We have installed new carpet in 2 rooms and need to have the bedroom doors shortened by less than 5mm -10mm. We work so will need to arrange a time that works, but generally Fridays from 8.30am to 9.30am work. Other days by agreement. There is parking in front of the house.

Render Job: - Repair damaged render edging. - Apply a new coat of render to all pillars and base on the front wall of the house. (Colour match to existing render and house) - 6 Brick pillars to be re-rendered - Plus base of fence (approx. 10 m long) - Please supply materials needed (Render, New edging/support for the render on the corners) Notes: - Likely need to remove and re-install the metal components of the fence. - Will need to detach and later re-attach the front gate in order to render the pillars that the gate attaches to. - Remove and re-install the front house number + letterbox facia on the main/letter box pillar. - We can move the plants out of your way. - Please advise if you would like me to pressure wash the render to remove algae before starting ?

the grab rail is to be mounted on one stud behind bathroom wall tiles

Replace internal door handles with new, already purchased handles

Instal dog door into our glass back door. Dog door supplied.

Broken blind mechanism needs fixing

We have an Edwardian solid-brick house in Clifton Hill where an area of internal concrete render has fallen away, exposing the brickwork (see photos). We need an experienced solid plasterer/renderer to: * Prepare/remove any loose material (it’s been temporarily covered with filler) * Repair/re-render over the exposed brickwork * Match the existing wall surface as closely as possible * Leave the surface smooth and ready for painting * Supply materials and clean up afterwards

Hello, I need this hole plastered / covered in my wall. Ideally tomorrow before 2pm or possibly some time on Friday afternoon. I will have to find out the colour of the paint to have it painted separately.

The front door and gate to our house are very stiff to open. We're not sure what the issue with the gate is but we suspect the issue with the frontdoor is that it swells during winder and it was recently painted during the summer and now it's a little too big for the frame. We can see points near the top and bottom on the long edge of the door that are having their paint rubbed off.

Repairs to two areas of external render. One area is at the top of the second storey.

I had an Airtasker handyman install curtain rails but did not quite understand the intent- two ikea units pictured have been installed to the ceiling (3.5m high) but they do not connect. I have included an image in red mark up with how the rails are installed now and don’t let a curtain go from side to side of the room. Green mark up shows my intended use- just to be able to pull the curtain and stop it wherever. The curtain is also ready to be hooked on. May required some funky solution as the rails are already secured but sit as two separate unit, independent and disconnected. Happy and keen to chat on thoughts, the installer that did the work has ghosted me :(

Install 2x steadyrack bicycle wall mounts onto front verandah wall

Glass shower screen has been knocked and silicone has broken. Go to site. Scrape off existing silicone. Place shower screen in place. Re-silicone. Hold in place till new bond has dried

Hello, I’ve got the power drill, a ladder and the right screws for installing the rails- my ceiling is 3.5m high on carpet and I’m 160cm tall and not comfortable on the highest rung on the ladder… Product is Vidga rail, to be attached to the ceiling, wall to wall. Pretty simple! The recommended screws from Bunnings are based on not knowing what the ceiling is like to drill into. Happy for offers. Just the rail instal, I’ll do the Curtain another time 👍 Preference is this evening! Or later on a weekday evening. Thanks!

We need this awning down as it is no longer needed, and must be gone for us to have new windows installed. It is high, and roof access is minimal as our roof is curved. There is a small flat space on top. Access is difficult, I believe.

Take off, slightly shave down, and rehang original door (no longer closers due to movement in the floor)

Repair plaster damage in 3 locations