Find experienced local tradies in Sydney

I need a safe, compliant hardwired connection run from the switchboard to the sauna heater location. The heater is 9kw 220v. The main breaker board is almost right on top of where the sauna will be located but on ground level. The sauna is in the basement below. There is electrical conduit running down the wall below the breaker and there is a power point down in the basement, also very close to where the sauna is.

Professional handyman needed to repair a small impact hole in a drywall/gyprock wall. This needs to be a seamless "bond back" quality job. Must be done tomorrow (Saturday, Nov 29) or Worst case Sunday. Flexible with time. Location: Ultimo (Apartment building with lift). Parking available nearby (Broadway shopping centre). Please only offer if you can finish seamless and are ready to go for tomorrow, thanks.

Disassemble a built in wardrobe and move pieces outside house. Wardrobe is 2m wide and about 2.5m high. Comprises 4 large doors, interior shelving and 4 drawers on 1 side and hanging space on the other side. Attached to a masonry wall.

Hi, I need this drywall primed and painted with high quality indoor paint, matched to the white colour of the existing drywall on the lower third of the walls (see attached images). Dimensions are in the images too. I also need the ceiling beams to be painted white, and the door frame too.

I would like to get 3 ceiling fans (remotely operated with lights) installed where oysters lights are currently installed, all gyprock .One power point is lose in gyprock, needs repair/replacement. One light switch needs to be moved by about 40cm to a different position in wall.

Our sunroom doesn't have a powerpoint so we need to add one. the closest powerpoint is 3.5 meters away

Need to mound a 42 inch on a gyprock wall, I have purchased the Wall mount from bunnings

Our awning wont retract. I believe its electric and something to do with the motor. Looking for quotes

Paint small backyard wall (undercoat and then topcoat). Paint supplied. Wall has been cleaned

I have a damaged gyprock wall around a service shaft in a bathroom that needs to be repaired. Using aqua check as it’s in a bathroom

Have removed tiles from a shower recess and need the wall rerendered to prepare for the new tiles.

Need 85 inch tv mounted to plasterboard wall tomorrow at 1pm

Hi, I’ve just demolished an internal wall and now need a gyprocker or plasterer to: • Patch and repair wall and ceiling gaps • Re-sheet and flush joins • Sand and prepare for painting There are some areas with exposed brick and framing that need neat finishing. I can send through photos for reference. Please let me know your availability, quote, and if you can come by this week for an inspection. Location: hillsdale

We need to have a 2.1m half wall plaster repaired at the edges and raised by about 5 cm, so it lines up with our kitchen cabinets for the upcoming stone benchtop installation

Jobs 1 and 2 are simple. Fill the holes with plaster and then paint over. Job 3 is more complex. Cut out the gyprock (may be fire rated gyprock, am not sure), replace-gyprock that square, plaster and paint. We will provide paint. Other materials provided by you.

ofter pulling a 3M sticker off the wall I removed the layers of paint - roughly 1 x 2 inches and two small pin holes need filling and painting

I need gyprock installed to the lower third of an exposed brick wall to prepare the wall for installation of wainscotting. The section of wall to be covered is 270*90cm You will need to include all materials in the quote.

I need an experienced person (or team) to carefully dismantle and reassemble a 3-person Found Space sauna and move it literally next door — about 20 steps away. The job needs to be done ASAP. Here’s what’s involved (essentially the reverse of this video: YouTube link): https://www.youtube.com/watch?v=jgsmWnB5Xfc Steps: • Remove the glass door first (must be done before anything else) • Disconnect all cables from the control box that run through wall cavities • Unscrew the roof • Unscrew and remove front heaters • Lift off the roof • Remove the glass panels • Disassemble the bench and under-bench heaters • Unscrew and separate the back panel You’ll then need to reassemble it in the adjacent room, ensuring it’s level, stable, and the electrical components are correctly reconnected. Requirements: • Must have experience assembling or moving infrared or similar saunas • Must have your own tools and basic electrical understanding • Ability to handle glass safely This is a quick but delicate job — ideal for someone who’s handy with furniture or appliance assembly and available immediately.

Put together a Serenity Full Sprectrum 2P sauna that came in a kit. Instructions on their website.

Job: Cut approx 1m (or less) Channel in Brick Wall + Install Conduit + Render Back to Smooth Finish Hey everyone Always had a good Airtasker experience Just had my TV hung on the wall I’d love an approx 1 metre vertical chase (channel) cut into an internal wall (brick) to run TV cables (sealed power/AV leads) from the floor up to a wall-mounted TV. Scope of Work: • Cut a neat 1m channel into brick wall (approx. 20–25mm wide, 20–25mm deep). • Supply and install PVC conduit for the wires • Secure conduit with saddles/clips inside channel. • Patch and render back over channel so the wall is flush and ready for paint. Happy to do the painting myself :-) • Finish should match existing wall as close as possible please (smooth render, not a lumpy patch job). I’m happy to handle final painting, I just need it rendered smooth and ready. Job Location : Surry Hills