Find experienced local tradies in Marrickville

Built in Wardrobe Sliding Door needs realigning. It’s come off the track and the rubber seal has popped out. It needs to be realigned. The glass is in tact/not broken. As shown in photos

Lay some bricks within the gap in the brick fence and finish the edge of brick wall with cement render. I recently cut the fence to widen the driveway. The cut section you can see in the photo now needs to be cement rendered to square it off. I expect it to be approx 25mm

Our electricians forgot to install power to our extractor fan during our renovations and had to add it in after our renderer had finished Have some small areas to fill in + skim - see photos for the areas

Sauna sanding works at XtraClubs using 120–180 grit sandpaper. The job will include: An initial site visit during operational hours to assess the saunas, identify the areas that need sanding and discuss the works with the Club Leader on site. Returning after hours, from 11:00pm, to complete the sanding works in multiple areas Cleaning up the work area thoroughly once completed. Please factor the initial site visit into your quote, as this may add approximately an extra hour of labour with actual sanding taking up to 2-3 hours based off previous handymen Could you please provide a quote for the above works? Thanks!

Looking for a licensed electrician to install approximately 10 new power points at my property. The property will need to be inspected first to assess the existing electrical setup and proposed locations before the scope of work and cost can be confirmed. Approximately 10 new power points are required, but the exact number and locations will be confirmed after the inspection. Please provide a quote based on the required work. Licensed electricians only.

One of my awnings got blown off by wind and I had to throw it away. The bars are still attached and in place, so I’m guessing a new shade is can be fixed on the existing bar. I have new cloth to be fixed on site. This task was accepted by another tasker and the shade was ordered by their recommendation, however due to some personal circumstances they couldn’t come out to do the job, hence reposting this task to find someone to fix it. Thanks. Measurements are width: 3650mm Height:1100mm Depth: 1100mm Shade length: 1550mm (approx)

Render 1 wall approx 2m long and 2.5m high

Hello, We have an approximately 50cm x 50cm hole in the drywall that requires fixing. Completion of the job would include restoring the wall to its original condition. If possible, we would love to have this done prior to Monday.

The job is to fix/replace the switches of two power points and a flickering down light.

Light switch has fallen into wall

Install new power point in existing room that has one power point already installed on another wall. House is single story, double brick.

Bathroom Window Modification – Brick Up Existing Window + Install Narrow Highlight Window Description Looking for an experienced and licensed tradesperson to modify an existing bathroom window. Scope of works: Remove existing bathroom window Brick up/render lower section of wall Create new opening higher up near ceiling level Supply and/or install a long narrow horizontal bathroom-style window (highlight/awning style) External patching/weather sealing Looking for someone experienced in: Masonry/brickwork Small structural alterations Bathroom window installation Rendering and patch finishing Please include: Relevant experience/photos Whether you can supply the window Approximate timeframe Licensing details if applicable

Require rendering patch work

Looking for an experienced handyman, plasterer or remedial repair person to inspect and repair localised damage near a sliding door in a Townhouse in Marrickville. Issue: * Skirting/render area below and beside sliding door has deteriorated/blown out over time. * Likely due to moisture exposure around the sliding door area. * No active leaking, pooling water or major ingress noticed internally. * No soft flooring or widespread damage. Looking for someone who can: * Inspect the area and assess likely cause * Remove loose/damaged material * Check for moisture * Re-seal around sliding door/frame if required * Patch/rebuild render/plaster/skirting section * Sand, seal and paint for a neat finish Would prefer someone experienced with: * moisture-related repairs, * remedial patching, * skirting/render repairs, * sliding door sealing.

Bathroom walls and kitchen splash back have both recently been prepared for rendering. Bathroom walls have been taken back to brickwork requiring approximately 10-20cm of render.

Fix plasterboard wall hole (~20cm) + stop air draft + paint to match. Marrickville.

one part broke (new part arrived ) just needs to be put back together

We are going pressure clean the front of this old house and there will some patch rendering off a scaffold

Install a 2m x 3m vehicle awning on existing roofracks on a Mazda CX-5. Must be a professional installer who can guarantee their work

Install a power point into my bedroom wall. Please send your best offer