Find experienced local tradies in Sydney

Meed a gyprock wall floor to ceiling

Need a small box built to cover an exposed pipe. The box will have two 90° corners, a vertical bulkhead to run around, and needs to join the bottom of the bulkhead. Photos of the piping are provided. The other part is a gap in the bulkhead that was an access point needs covering ready for painting. Approx. size for gap in bulkhead: 600–500mm. It’s not the one in the picture. Forgot to get a picture of this. Requirements: • Material: MDF preferred (gyprock may be needed for bulkhead section) • Smooth, paint-ready finish • Screw/fill and sand holes Skills needed: Carpenter / Drywaller with experience in small boxing or feature walls. Happy to pay for materials separately upon receipt.

approx. 360 x 420 cm new ceiling required

Insert three small pieces of gyprock that were cut for air conditioner installation. Repair gyprock pieces, sand and paint wall.

Render inside or cupboard cavity that is being renovated into a bar area. Currently exposed brick Photo of space plus vision for finished space below

Remove retractable arm motorised awning from side of house. - 5.4m x 2m

There is a gyprock wall, need to patch and paint a cut out of 50 mm x 50mm. Need to be done today before 5 pm. Paint available on site. The card reader will be moved, hence we need to patch

We are moving floors this weekend, we require three power points to be set up. There seems to be covered over access points. We need a licensed electrician. I’ll be available to allow access thisSunday and next Monday if easier as well.

We’re moving out of a rental after 8 years and are looking for an experienced painter and wall patcher / plasterer to help get the walls back to a good, presentable condition. There are various marks, small holes, dents, and scuffs across the house from general wear and tear, hanging items, and a dog (some scratching on doors). This is very much an end-of-lease tidy-up, not a full repaint. The job is for 8 hours total, focusing on getting as much done as possible in that time rather than aiming for perfection. Property details: • 3-bedroom house • House will be completely empty • Walls + some doors need attention What’s included / not included: • ✅ Paint will be supplied (matched and ready) • ✅ Drop sheets provided • ❌ You’ll need to bring your own tools (brushes, rollers, buckets, sanding tools, etc.) • I will patch what I can the day before so it has time to dry Timing: • Monday 2nd February • Ideally 9:00am – 5:00pm (or as close as possible) Important notes: • This job is based on time, not a fixed outcome • We understand that repairs and painting don’t always go perfectly from A → B • Photos of example damage will be attached to give a clear idea of the work involved Looking for someone reliable, efficient, and experienced with end-of-lease repairs.

Remove 2x built in robes - not built into an alcove, but fixed to floor and walls. Dispose of waste.

We have a small 1m awning and wall hung bike rack that needs to be hung on an exterior brick wall. Also a mirror to be hung in a bedroom. Needs someone professional as we don’t want the walls damaged. Thank you.

Need a labourer to help with putting up gyprock. Just someone that can pass tools, boards etc to a builder - 2 days

Experienced plasterer required for Garage ceiling and walls that have just been gyprocked. Needs to be plastered and base coat done to prepare for painting. Square set finish sufficient. Estimate a day's work

Power point came off - needs a new power board. Cables are exposed so needs to be done today. Shouldn’t take more than 10 mins. Electricians only please

👋 hello, I've recently accidentally damaged the mid shelf of my built in wardrobe, I hope the pictures helps, basically the screws are still in place within the built in frame, is maybe anyone here able to help replacing a same-size board? Measurements are 45x58x1.5cms I'm also open to suggestions for any solution that can ultimately make it easier or better, Thank you

I’ve purchased a new tv and Sonos sound bar. Tv and sound bar need to be wall mounted and power points installed that are concealed

Structual engineer to certify that my balcony can support a small sauna weighing 300KG. Strata has advised this certification is required to be approved for install. Balcony is located top level of block on an area of around 15m2.

Need to mound a 42 inch on a gyprock wall, I have purchased the Wall mount from bunnings

I have a damaged gyprock wall around a service shaft in a bathroom that needs to be repaired. Using aqua check as it’s in a bathroom