Find an experienced plumber in Petersham

screed, waterproof and tile approx 6-8sqm in Shower wall and floor. Tiles etc will be stripped already. Waterproofing certification, insurance and warranty required. Listing price is based on what Internet suggested per sqm tiling cost is but feel free to submit a reasonable offer.

Need a brass bath spout tail replaced on a wall-mounted bath. The existing tail is a push-fit O-ring style; needs to be swapped for a standard 1/2” BSP male threaded tail so a new diverter spout can be fitted. New diverter spout is on hand ready to install. Estimated 30–60 min job. Must be licensed plumber (NSW). Available for same-day or tomorrow. Property is tenanted so prompt turnaround appreciated. Please quote for supply and fit of tail fitting plus installation of diverter spout.

I am looking for an experienced and reliable handyman to set up a temporary bath-over-shower arrangement for tenants in a unit. No plumbing work involved. The job requires: • Stabilising the freestanding bath (is on rubberised feet, currently is rocking away from the wall when climbed into) • Measuring and positioning a suction-mount shower head bracket • Measuring and marking placement for a curved curtain rod (supplied) then drilling into tiled walls to install it (2 drill points into tiled short-end walls) and attaching curtain and liner • Unscrewing the existing bath spout (see photo), and attaching a diverter (supplied) to the existing bath tap/spout • Connecting the shower hose to the diverter and attaching the shower head, then measuring and mounting onto the suction mounted holder • Full setup and test to confirm everything is functional and ready for use This appointment cannot be rescheduled - the tenants are only available at this time - so reliability is essential. Please only apply if you can fully commit to the agreed time. I am looking for someone with strong practical problem-solving skills, a can-do attitude, and experience drilling into tiles. (Please do not apply if you do not have the correct tile drill bit). I will be on-site to assist with lifting and setup

I need three things done: 1. I have a hot water meter under my sink that is leaking from the connections to the pipe on both sides. I need these connections fixed so it stops leaking. 2. There are two taps that handle the mixing of the water that are also a bit leaky too so I need them either repaired or replaced. 3. I have a laundry sink that I never use. I would like someone to put blank caps on the two taps and the faucet so that I can put a fridge on top of the old sink.

A previous installation added an L-shaped pipe (tight bend) running from a lower level (bathroom/kitchen) up to the upstairs bathroom. Since this was installed, the water pressure upstairs has been significantly reduced. Scope of work: - Repalce the L-shaped section to improve flow downstairs (and test improved flow) - Open wall and re-patch after plumbing

Suspected incorrect fitting / length of pipe installed currently. The pipe collects underneath the sink and doesn’t drain but there may also be a slight leak from the fitting contributing to the issue?

We’ve got a leaking bathroom tap. It looks like the washers needs to be replaced.

Have an Airbnb apartment in Petersham, guest is reporting a mixer with water not coming out well, They have tried to move tap side - side, and adjust tap under sink. Need someone to go out and have a look. Would love someone i can use for other tasks too!

Hi Margot, Offer is to repair/replace trap. Just need a pic of what has been taken off and the underside of the plug/waste. Can come early tomorrow or Sunday morning if that suits.

Looking for some one who can come straight after work today. Latest 4pm Cabinet needs to be removed today at 4-4.30

We moved house and can't quite get cold water feed connected.

Under my bathroom sink is leaking. I haven’t been able to isolate where the leak is coming from

I am doing my kitchen and need to disconnect/re--commect copper water pipes to fit base cabinet. If we organise the day I can cut pipes and fit cabinet so will just need to reconnect. Pipes will need to be re soldered. The sink down pipe wont need to be touched as I will connect later on so just need to re-cinnect the hot and cold water copper pipes Thanks

Help fix a leaking kitchen sink

Hi there, looking for someone to install our washing machine - looks like the job will require sourcing a longer drainage pipe that will fit our outlet, as current set up is leaking. Will require assistance placing machine into its nook once installed. Machine is Kogan, 10kg front loader. Would be grateful to find someone who could pop by either today or tomorrow.

I need someone to help me fix my toilet seat it is very loose

Need plumber for two bathroom renovations. Bathroom fixtures will be provided.

Hi! I need a plumber to add a sewer pipe. Ceiling is exposed and ready to go.

My tap for my bath/shower can’t be fully turned off so is leaking water

We have just moved in and the washing machine pipe doesn’t quite reach the outlets to connect to.