Find an experienced plumber in Mascot

Remove laundry sink and simplify plumbing for future cabinetry and bench top installation.

Shower tap is dripping when turned off. Looking for someone to diagnose and repair, likely washer/seal/cartridge replacement. Please bring required tools and parts. Looking for a licensed/experienced plumber

Water keeps leaking/running after I flush the toilet. Looking for someone to inspect the toilet, identify the cause and fix the issue as soon as possible.

Looking for someone experienced to fix a small leak on a hot water pipe/fitting near the hot water unit. See photo attached. The leak appears to be around the copper pipe/union fitting. Budget is $150 total including labour, call-out, Airtasker fee, and any small parts needed such as washers, thread tape, seals or standard fittings. Please only offer if you can complete the repair for the fixed price. Please bring your own tools and parts. Please include when you can come and your experience with similar hot water pipe/fitting repairs.

I’m looking for an experienced plumber to inspect and repair a toilet in Mascot The toilet flush is very weak, and the cistern takes around 20 minutes to fill up again after flushing. It may need a new inlet valve or another internal part. Its Meriton buiding ( photo attached) Please bring your own tools and let me know your availability and estimated cost.

Qualified Plumber / Licensed Tradie / Experienced Handyman Required I'm looking for a qualified plumber, licensed tradie, or experienced handyman to supply and install a new bathroom vanity. Requirements: - Valid ABN. - Current public liability insurance. - Relevant plumbing licence (where required by law). - Must have all necessary tools and equipment to complete the job. - Previous experience with vanity installations is preferred. Scope of Work (including but not limited to): - Supply and install a waterproof vanity as per the attached picture. - Vanity dimensions: 43cm (D) × 76cm (W) × 87.5cm (H). - Remove the existing vanity and dispose of it. - Install the new vanity level, securely fixed, and properly sealed against the wall. - Connect all hot and cold water supply lines and reconnect the waste pipe to suit the new vanity. - Supply all required plumbing fittings, connectors, valves, silicone, brackets, fixings, and any other materials necessary to complete the installation. - Make minor adjustments to the plumbing, waste pipe, or water connections if required to ensure the vanity fits correctly. - Test all plumbing connections thoroughly and ensure there are no water leaks. - Ensure all drawers, doors, and fittings operate correctly. - Clean the work area and remove all installation debris upon completion. Important: - The installation must comply with all relevant Australian Standards and plumbing regulations. - All workmanship must be of a high professional standard. - The completed installation must be fully functional, watertight, and leak-free. - Please provide your quote, earliest availability, and confirm your licence, insurance, and ABN when responding.

Water flow from the hand Shower head becomes really small when it comes to hot water, unlike the flow coming from the overhead shower

Replace the current mixer sink tap with a new one that you can pull down and get better coverage

Supply and install new 900mm freestanding waterproof bathroom vanity with inclusion of disposing the old vanity, fitting, adjustment, silicon sealant to avoid leaks and gaps also all the necessary parts and materials etc with warranty to get the job done from start to finish

Shower dripping, 7 years old

Need a twin sinks and taps plumbed, originally a single sink setup so will need a T piece to join to origanal water inlets, and install new p traps for sink wastes, theres an AC drain pipe to connect into waste also. Vanity is driled for waste pipe already T pieces and conducts and p trap needs to be suppled. Might need a 90 degrees fitting on water outlets to avoid drawers and one tap will need water pipes extended

Licensed Plumber required to install 3 x bathroom mixer taps (supplied). Please see photos attached. Please remove all 3 x bathroom mixer taps. Please replace them with the new supplied mixer taps. Location: Mascot Thank you :)

A plumber needed to install bidets at 2 bathrooms. Bidet will be provided. Parking is available.

Our toilet is not flushing properly, no water coming out when pressing the buttons. Need to fix asap hopefully today otherwise we have no toilet to use.

Location near mascot station. Toilet flush no longer works need to be fixed asap thanks!

Need lienced plumber to inspect and advise on drainage solution and water supply to new ensuite and create a basic report for Strata approval. Will attach drawings for reference

There is no hot water in the bathroom ,kitchen ,the laundry room

Supply and replace two stop valves under bathroom sink and replace bathroom sink mixer tap (tap supply not required).

In built cistern filling up very slowly, takes an hour. Gotten worse/longer over time. Include supply of any parts if required.

Hi there, I’m looking for a plumber or handyman to help with a small job in the kitchen. I need: 1. A 2-way splitter installed at the water inlet under the kitchen sink, so that it can supply water to both the sink and a washing machine. 2. A 2-way drain connector added to the sink’s drainage, to handle wastewater from the washing machine. Please let me know if you’re available and provide a rough quote if possible. Location is Mascot