Find an experienced handyman in Glebe NSW

Fixing the door of the frame

Drill two holes into rendered concrete for a dartboard

The removal of a burn mark on the kitchen bench and would like the surface restored back to its original color.

Need this door re installed and also need the 2x timbers replaced behind the door

The handle on both clotheslines at our apartment block are broken so cannot raise/ lower the clotheslines. Looking to either have them repaired, or if not possible, replaced

New double doors leading into courtyard and new timber awning needs painting

- Remove and replace bathroom & kitchen fixtures - Hang up a tv - Hang up curtains - Connect door slower to door + more

I have one venetian blind I need put up for a window. The box says the tools required are a drill, phillips head, level and pencil. I have a tape measure.

Render all the walls outside

Need help fixing a hose reel to a concrete wall.

Small render job. Old render removed.

Need a handyman to fix rodent entry points in our Glebe terrace house: 1) Gap underneath kitchen cabinets #1: - Note this gap is under the kitchen cabinetry 2) Gap underneath kitchen cabinets #2: - Note this gap is under the kitchen cabinetry 3) Gap in skirting board 4) Gap in roof eaves #1 - This may be remedied with stainless steel mesh and the wood does not need repairing 5) Gap in roof eaves #2

I need a handy person to install 2 floating shelfs. One in the study, 180cm and one in a bedroom , 120cm. Walls are concrete. Shelfs are like the one in the picture which was recently installed by someone else. Task to be completed on Friday afternoon or Monday.

I need an experienced handy person to install my new skylight blinds in the living area. They are from blinds online (please see link for instructions below and pics) They have a click lock no drill mechanism and installation should be easy. Skylights are 60 x 104 cm each and 2 mts high (see picture) so need someone with a ladder and the right tools and that has installed similar blinds in the past. They have no wiring as they come with 2 small solar panels. Posting with the recommended price by the seller. Installation date can be tomorrow Tuesday 17/03 or Friday 20/03. Cheers https://www.blindsonline.com.au/content/instructions/TBOAU-fitting-skylight.pdf

Hey mate, Do you fix these? Job located in glebe. The power is tripping randomly the powerboard circuit not always but say once or twice a day from this unit

Looking to have a damaged section of gyprock cut out and new gyprock installed inside my bedroom storage cupboard (sorry for my terrible photo! But it is the bottom corner). All materials and tools to be supplied by the AirTasker

Mount two IKEA ‘Lack’ shelves on brick wall (we already have correct screws and anchors if needed) and a coat rack in the hall (needs screws). All brick walls so will need a hammer drill etc.

Need help from experienced carpenter to figure out how to remove this fixture from wall. I have removed all the screws but fixture is still firmly attached to wall. I believed it may have nails embedded in it securing it to wall. After removal, help to load onto car. Fixture is MDF so it is heavy, I think it requires at least 2 persons to remove it.

Install blocking between joists for ceiling fan hanging, and install approx 200mm dia blocking in centre of ceiling rose. Use appropriate treated pine

Install 2 ceiling fans with light. We have one already done, we want to add 2 rooms to do the same thing (see photos).