Find an experienced flooring expert in Melbourne

Lay approximately 20m2 of vinyl flooring in 3 rooms (kitchen, laundry, bath) and hall way as pictured and shown in floor plan. Please include two quotes: 1) supply & install 2) install only (I will purchase flooring) Thanks, Colin

***$10 is just to get quotes*** Needing 49.5m2 hybrid flooring installed Last minute cancellation

Removal of old pulled up carpet (approx 90m2) and underlay- currently in large pieces will need minimum 2 people

Carpet is at Fowles Auction Centre in Clayton and would need to be collected. I’m not sure if new underlay is needed, l haven’t purchased this as yet. Two bedroom apartment which is around 11-15 BLM. Thank you

Supply and install approx 50sqm of hybrid floating floorboards - 3 rooms and a hallway. Concrete base.

SUBURB: Melbourne CBD (parking provided) SIZE: Approx. 65-70 sqm SCOPE OF WORK: •Remove & dispose all existing carpet and underlay •Prep concrete subfloor (fill small gaps/cracks if needed) •Install supplied hybrid flooring (floating, click-lock) •Reinstall skirting boards •Clean up after completion IMPORTANT BUILDING REQUIREMENTS (MUST COMPLY): •Floating installation only (nothing glued or attached to the slab) •Resilient acoustic underlay is required •Work limited to building-approved hours •All rubbish removed off-site •Care taken with common areas WHAT WE PROVIDE: •Skirting boards will already be removed •Hybrid flooring (boards) •Underlay •Trims & scotia •On-site parking •We will move furniture before installation and put it back after •Access to apartment + lift booking with building manager PLEASE INCLUDE IN YOUR QUOTE: •Labour cost •Estimated time for completion •Proof of experience with apartment hybrid flooring installs •Availability

Yellow area to be replaced with hybrid flooring.

About 11 sq metres of carpet to be laid in small room. Good access - existing underlay and hard edge. Room will be clear of furniture.

Rip up carpet in small 2bdr apartment. Install hybrid flooring in both bedrooms and living area space (not bathroom).

Trying to remove odor from previous tenant. If it fails, would like to know a quote from you. One 3.6 x 3.6m room. Removal and Install. Square Room.

Hi, I’m moving into a new apartment at the end of January and would like to replace the existing carpet with timber flooring. The property is currently tenanted, so I will need to coordinate a short access inspection through the agent. I’m planning to install hybrid (SPC) flooring in two bedrooms (total ~25 m²) to replace carpet. Could you please quote for: - Supply of a mid‑range hybrid board (similar to Bunnings SPC) - Underlay (if needed) or confirm if the boards have attached backing - Subfloor preparation / levelling (if required) - Removal and disposal of the old carpet - Installation (labour) - Skirting / trims / transition strips Please provide an itemised quote so I can compare with other installers. Please let me know your availability for a site visit and whether you charge for the measurement/quote. Thank you!

I want to change flooring in my bedrooms from carpet to timber. Happy to have someone to visit for getting me the quote and what will be required from my end in its preparation. Thanks.

Hello there! Looking for someone who can remove existing carpet and install vinyl planks in an apartment ( roughly 30sqm ) We can provide planks, or if you have an offer that comes with planks and installation we can work around that as well. Price is negotiable, please ask if there's anything that's unclear. Thanks!

Install vinyl sheet flooring (vinyl supplied) Description: Need a handyman/flooring installer to install sheet vinyl in a small kitchen and laundry/toilet area. Vinyl will be supplied (Senso DIY Practica Concrete Grey, 2m-wide roll). Job involves: Cleaning existing vinyl floor Light scuff if needed Cutting and laying new vinyl over existing vinyl Gluing edges where appropriate Neat trimming around edges, doorways, and cabinets No removal of old vinyl required Kitchen size: approx 3.15m × 3.5m Laundry + toilet: approx 2.4m × 2.5m Must bring own tools (knife, straight edge, adhesive, roller). Prefer someone with experience laying vinyl sheets. This needs to happen before Monday 10th November

Looking for vinyl floating floor boards to be installed in a small kitchen over existing tiling. Approximately 6 square metres. Flooring already provided. Floor is already level. Might need to even out some imperfections.

I need an experienced floating floor board installer to lay boards & quad that we will supply. Appx 32 sqms. We will remove the existing flooring & dispose of it. Job is in Richmond.

Need to remove old carpet and install laminate flooring in a 1 bedroom apartment in Southbank. See the attached floorplan. Kitchen, bathroom and balcony has marble floor. Only living and bedroom flooring need to change. Please offer supply and install per sqm.

I am looking for someone to glue, nail, lay hardwood Tasmanian Oak flooring

Need 150sqm of hybrid laminate laid in a studio space Floorboards are ready to go in the space

Howdy. I need someone experienced to lay a floating floor. Area is 7 x 5.4 metres. I have the the 5.5mm hybrid boards already purchased. The room won't be completely vacant. We thought we could shove all the furniture (that we cant put elsewhere cos it's too big) into one half of the room, lay half the floor then when it's done, move the furniture to the other side of the room and lay the second half. Happy to pay the going rate.

75 sqm excellent floorboards to be sanded and polished by experienced specialist. Black butt timber less than 10 years old hallway (1 * 12)+ 2 bedrooms (approx 4*4) kitchen/living (6*4) + single stairs + landing (7*1)

Got a Level 1 space in Brunswick East that needs a proper polished concrete makeover. We want the full grind down + high-gloss finish. No shortcuts, no “surface polish.” What we need: • Grind & polish approx. 180sqm • Aim: shiny, reflective, warehouse-style finish • Floor condition: some dents/patches, nothing crazy • Access: Level 1 • Timing: ASAP or before Christmas • Bonus: If the price is right, we may extend to the full 250sqm (quote 180sqm first) What to include in your quote: • Total price for the 180sqm • How long the job will take • Availability to start • Any equipment/access requirements • Experience/photos of past polished concrete jobs Photos attached in the listing. Looking to lock someone in fast — need this done properly and professionally.

Hi all, Keen to get a quote pls for sanding + polishing 80 sqm of pine floorboards across 4 rooms + 1 hallway. Floors are in reasonably good period condition (Victorian weatherboard) but have an orange tint to them. Would like them finished to a clear matt finish. Pls see images of current floors (1st photo) and what I'd like them to look like (2nd photo) Thank you!

Sand and polish floorboards. One bed ground floor apartment. I have a gap in air bnb and would like to have the job done Sunday and Monday. It’s a small place with lounge/kitchen area and 1 bedroom with boards. Bedroom boards are in good condition some patches in lounge and kitchen are more worn

Fix cigarette burns on floor boards

3 burn on the floor that needs to be fixed

Hi all, Keen to get a quote pls for sanding + polishing 80 sqm of pine floorboards across 4 rooms + 1 hallway. Floors are in reasonably good period condition (Victorian weatherboard) but have an orange tint to them. Would like them finished to a clear matt finish. Pls see images of current floors (1st photo) and what I'd like them to look like (2nd photo) Thank you!

Need floor boards polished

I need someone to lightly sand and repolish 3 boards under the sink. They are not damaged just lost polish. 3 metres in total

Require 38 sqm grind and polish clear

Keen to have my floorboards vacuumed, mopped, and polished, and in particular — need help with some strong carpet tape residue left on the timber. We’ve removed most of the actual tape, but there’s still a fair bit of stubborn sticky residue left that’s proving tricky to remove. Looking for someone with experience in floor cleaning and gentle adhesive removal who can get the boards looking clean again without damaging the varnish or timber. Ideally you’ll bring your own supplies (e.g. mop, polish, adhesive remover, scraper, cloths, etc.). I have a vacuum for use. The job covers around 50m² of floorboards across the dining, lounge, hallway, kitchen and entrance areas. 📷 photos of the rug tape residue

Existing garage floor is smooth and intact. No repairs necessary. The epoxy coating is peeling and needs to be removed through grinding. Exposed concrete should be polished to shine. Work site is covered and enclosed. Water and power available.

140 sqm of showroom floor to be sanded. I don't want this cut right back, but rather remove current coatings enough to stain 2 X coasts of Japanese black and then finish with 2 X matte protective coats. Wood is Jarrah. All furniture has been removed and ready to go. Need done by end of month please.

Sand and polish floorboards 11.2 square meters

Minor sand and polish. Solvent based polish. Mostly just to remove/replace existing polish that is peeling. 6.7sqm

Need timber floors sanded and polished in house, approx 70m2 space **This job would not be until first week of November**

Hello, Anyone know how to professionally polish concrete floors? Ive had quotes for but let me know yours please Not sure on the desired finish - open to suggestions ! 3 bedrooms 3x3m each Photos to follow

I’ve had marble flooring scratched and I would like to get them polished

I need to add a small section of polished concrete floor to match existing. We are removing the fireplace and plinth in the photos attached. There is a section of floor underneath the plinth that is missing. The floor is a concrete screed over joists, on the first floor of a warehouse in Richmond. The section required is approx 3300mm x 1100mm x 40mm and is edged with steel strips. The surface is polished and looks like it has a varnished finish. The old fireplace is being removed on Monday 29 September. The work could be commenced on Mon 29 afternoon or Tue 30.

Polish concrete in 80 or so square meter area

Open plan Living Kitchen Hallway -- wood flooring - needs sanding back and then varnished again

We’re moving into a new office space that has 110m2 of existing engineered timber flooring. The current finish is too dark so we would like the floor sanded back to oak and then re-stained in a light lime wash finish. All existing furniture items in the space will be removed prior to works commencing.

Require sand refinish with satin varnish 80sqm of timber flooring

Urgent time sensitive. Need asap start. Just bought house, have 10 days before need to move in. Floors need work. Description of task: EXISTING FLOOR: - have 46 square meters of chevron timber floor in apartment. Don’t like the colour - need floor sanded and refinished to match lighter Color of timber flooring in bedroom Install New Timber Floors in Bedrooms - have all materials purchased - would like to remove carpet in each bedroom (each room is 10 square meters) and install new timber flooring (materials provided) - the living room refinishing of floor should match the new floors for the bedroom as close as possible - plank installation concrete stick - linear pattern (not chevron) Whoever can start first is who I will book Cost being offered based on what I have been quoted by a company but they can’t start until later New floor installation: 50 per square meter - 20 square meters = approx 1000 AUD Existing floor sand and refinish 34 per square meter - 46 square meters = approx 1,500 Happy to negotiate Need someone who can start asap

25sqm living room area timber floor. There are stains soaked in so it needs sanding + staining + coating. Maybe just half of the area as the rest are covered by sofa and carpet.

Recently entered into contract for 2 bed apartment and preparing for the impending renovations/touch ups required before I can move in. Currently tenant in place for next 45 days so trying to secure everything in advance. Would like to have the carpet in the bedrooms removed and replaced with chevron engineered timber flooring (to match the living room). Also need to have the entire floor refinished. Its currently a dark brown/wood colour and I would like to change it to be like a grey frost. - Due date: Before Thursday, 2 May 2024

We require ~65sqm of vic-ash floorboards to sanded in a 2-bedroom house (with vic-ash stairs also needing refinishing). The wood has discoloured orange so we'd like to use a water-based finish eg. Bona traffic HD I have calculated floor areas (excluding bathroom & balcony and kitchen joinery) as follows; Ground Floor: 31m2 Upper Floor: 30m2 Stairs: 4.5m2 Total: 65.5m2 Start date: 01 February 2023