Find an experienced flooring expert in Melbourne

Laying of new timber floorboards over existing floor in home. 19mm solid spotted gum flooring, 3 bed unit 100m2. Lay over existing timber pine floor boards, sitting in concrete stump foundations.

I had engineered timber flooring (floating floors) put into my two-bedroom apartment about six years ago. In the summer it lays flat, but in winter when I'm running the heat it swells up and creates hill-like bumps in the floor in several places. I need to get some of the ends of the flooring trimmed so that it has enough space to expand in winter. Skirting boards will need to be taken up and put back down in the relevant areas. Looking for an experienced flooring expert. Happy for you to inspect.

Flooring total: approx. 53m² + quads where required Skirting total: approx. 29lm Kitchen kickboards: approx. 7lm + Gable/end panels: up to 6x Remove/reinstall engineered floorboards (glued down), skirting and kitchen kickboards/panels; check/treat mould and moisture, mould spray/dry exposed areas, then install and finish. Material order & delivered like following: https://diyfloorboards.com.au/genuine-oak-260x20mm-white-wash https://diyfloorboards.com.au/prestige-21mm-oak-semillon We need quote breakdown for - Removal + Tipping - Installation (Glued Engineered timber + Skirting + Kickboard) - Mold spray & Treatment - Materials (Timber floor, Skirting, Kickboard)

3 bedroom apartment needs kitchen and hallway and 3 bedrooms. Need to remove tiles and carpet to install floorboards

Supply and install new floor trim to fit perfectly Approx 900 wide and roughly 60mm wide. Requires custom cutting to ensure fit around grooves

Cut and install approx 2 sqm of floorboard for edge of room. Floorboards SUPPLIED. See photos for areas that need to be covered. NO SKIRTING REQUIRED

Laying 37sqm of pre finished flooring

4x4 room (16sqm) 1.8x2.2 laundry (4msq) 2.3x2.3 walk way (6sqm) 3.7x3 kitchen (11sqm)

Remove carpet and install wooden floors

Vinyl plank and sheet installer needed to assist with upcoming jobs which include floor preparation and installing vinyl. Need someone with experience and day rate will depend on experience. Please advise what you are able to do. Thank you

Need to change from carpet to hybrid with 6 acoustic rated for body corporate approval for my apartment. Will have to move some furnitures around in the living room (sofa, tv and dining table) to install. Looking to have the pure oak colour and only in the living/dining area.

Hi there , I need 46.64sqm of Hybrid Flooring installed. We will pull up the carpets and if floor needs screeding we will get that done. We have the floorboards . Thank you

Supply and install roughly 50-55sqm of vinyl sheet flooring. It’s for a storeroom for a cafe so it needs to be non stick. I need a wood grain like in the photo supplied. Current floors are mostly exposed wood floors (unsure if additional flooring on top is needed) In the bathroom I’d like it going up the walls 100mm

Need to remove and install hybrid floor board, at least 9mm 25 sqm apartment unit, 5th floor

Labour only: Install hybrid/laminate flooring in small apartment(21.5 m²). Floorboards supplied. Need existing carpet and underlay removed and disposed of, then flooring installed. Property is in Carlton. Looking for an experienced installer with references. Ready to start ASAP.

Looking for one or two reliable people to help set up our 4x4 show stand. The main job is laying approximately 156 m² of interlocking plastic exhibition flooring (12 m × 13 m), then assisting with positioning display equipment and general stand setup. All materials are supplied. Experience with exhibition or trade show setups is preferred.

Install hybrid flooring, including all finishings trim, edgings 16 treads

I need somebody who has previous experience to install hybrid clip in floorboards to the ground of my yoga studio. As you can see in the photo we have the floorboards lay out- there’s more to complete the space.

I want to install HYBRID flooring in my apartment living room + bedroom area. I have also given the exact dimensions of the area in the attachment. Need someone to do the complete job including the flooring and installation and removal of old carpet and disposal. The apartment is on Level 5 with lift access. Parking I can provide inside the building parking premises. Dont want any hidden costs so need somebody to do the complete job. And especially who has experience in doing such work in strata buildings to follow the norms. Price should also include the cost of floating tiles. As per my estimation the area is 34sqm. Also uploaded a bunnings flooring for reference only.

Install floor trim under front door to ensure door doesn’t get caught on floating floorboards when they swell with heat and moisture.

Some minor scratches in a few different areas. The floorboards timber is 12 years old. I need it professionally. Done to look like new.

cleaning and polishing 200sq metres of timber flooring

I’m looking for a professional floor sander to try and sand back and polish 2 section of damaged flooring for a property that’s going to be sold. I understand it won’t be 100% just need it looking better I’m hired to fix up the house for sale, this is a job of mine and not my house. This job is located in Coburg

I'm moving out of a rental and would like the parquet floor looking its best for the final inspection. It's about 30m² in one main room. The floor has gone dull over time and has a few superficial scratches in the finish — no deep gouges, no water damage. What I'm after: A proper clean first, then a machine buff with a rotary polisher Water-based floor refresher (Bona or equivalent) — no wax, the floor is sealed polyurethane and wax doesn't suit it No sanding — this is a cosmetic refresh, not a restoration I understand a buff won't remove the light scratches, just make them less noticeable — that's fine, I'm after an overall improvement rather than a perfect floor. Please bring your own polisher and products. The place will be empty, so there's clear access and nothing to move. [Add: ground floor / Nth floor with lift / parking situation.] Ideally tomorrow morning so it has time to dry before the inspection.

Older ground floor apartment, 2 bedrooms, lounge, kitchen, hallway to be re-sanded and polished with polyurethane finish. Current condition is above average. Approx 60-62sqm.

I’m looking for an experienced floor sanding and polishing professional to restore the original timber floors in my period home in Clifton Hill. Scope of works: * Approx. 40m² total. * 2 bedrooms and a hallway. * Believed to be original Baltic Pine flooring (old Victorian/period home). * Existing floor covering has already been removed. * There are old nails/staples protruding from the floor that will need to be punched down or removed prior to sanding. * Looking for a high-quality satin or matte finish (happy to discuss recommendations). I’ve attached photos showing the current condition. Timing: * Works need to be completed between 21–26 July. When quoting, could you please let me know: * Your total price (including materials). * How many coats of finish are included. * Estimated duration of the job. * How long I’ll need to stay off the floors before they can be walked on and furniture returned. * Whether you can replace any damaged boards if required (if discovered during sanding). Please include examples of previous floor restoration work if available. Thanks!

Looking to freshen up our pine floorboards that are due for a sand and polish in our kitchen. Area is approximately 14 square metres.

Hi there, I have about 45sqm of flooring that needs polishing only. With Bona floor refresher. And cleaned . Thank you

Timber Floor Colour Matching & Full Floor Polish – Office (80–100m²) Looking for an experienced timber flooring specialist to repair and refinish our office timber floor. Scope of work: A wall has recently been removed, leaving a visible colour difference in the timber flooring where the wall previously stood. Need the exposed section colour-matched and blended with the existing floor. polish the entire office floor area (approximately 80–100m²) to achieve a consistent finish throughout. Requirements: Experience with timber floor sanding, staining and polishing. Ability to match existing timber floor colour and blend repaired areas seamlessly. Supply all necessary equipment and materials.

Sand 280sqm floorboards in one large room, fill a few gaps, clear varnish. Doesn’t need to be perfect, just needs to be done. commercial space. Building on the 2nd floor in fitzroy.

12.6m2 Current = 2nd photo. Colour preference = 1st photo. Ground floor. Easy access. Minor repairs as needed.

I have about stairs and flooring that needs coating and polish.

Sand and polish floors 34m2. Hoping to have it completed any day over Easter weekend so I can reopen on Tuesday

Approx 20m2 of polished baltic pine needs another going over as it's looking a bit weathered and worn. Kitchen, hallway and study area that are all linked and easily accessible. Boards are in good condition. Straightforward job.

We need the floorboards of our apartment sanded and polished. Our place will be vacant. It is an art deco apt in St Kilda. Floorboards are in good condition; some spots will need some attention. Floor space is approx 70 m2.

Need someone to re-sand polish and install new floorboards for a property in Brunswick. I’m getting it underpinned so have had to rip up the boards in the hallway. Looking to replace boards in hallway and re-sand and polish boards in the rest of the house. I believe it is Baltic pine

Sand back and restain in a black Japan (or similar) clear coat existing hardwood timber floor for a semi gloss finish. There are three rooms (total of 40m2) - living (4.5x4) - hallway (1.05x10) -study (3.2x3.8) To be completed.

Polish full apartment floors

Looking to have our stairs sanded and polished and the edges repainted white.

Requiring a professional and reliable tradesperson for existing wood floor - cleaning, sanding and polishing. Dust controlled please. I am very flexible with time. Must be insured. Approx measurements: 72m2 Lounge Kitchen Hallway A few images attached Thanks in advance for your quote.

We need an experienced polished concrete grinding or exposed-aggregate flooring specialist to repair the unfinished areas around the door and blend it with the surrounding polished exposed-aggregate floor. The finished area should match the existing colour, aggregate exposure, level and polish as closely as possible, creating a flush and consistent finish. See attached photo Crucial Timing & Door Installation (Monday Aug 31): Our new entryway door (fluted glass design) is scheduled for installation this coming Monday, August 31st. We are flexible and require coordination. Please state your preference in your offer and availability: - BEFORE (Aug 29-30): If the repair can be completed properly while the existing door and frame are still in place.. - ON THE DAY (Aug 31): Work immediately after the existing door is removed and before the new door is installed. Coordination with the door installer will be required. - AFTER (Sep 1+): If this will produce the best result. Careful masking and protection of the new door and frame will be essential. Please include the following in your offer: - Your recommended repair method and timing - Examples of similar concrete or exposed-aggregate floor repairs - Confirmation that you can achieve a flush, continuous finish - Confirmation that your quote includes all labour, materials and specialised equipment

4x4 room (16sqm) 1.8x2.2 laundry (4msq) 2.3x2.3 walk way (6sqm) 3.7x3 kitchen (11sqm)

The deck that came with our house was poorly finished. It needs the old finish stripped and a new finnish applied.

Want a slightly darker/less orange colour that will not show as much dirt and not scratch so easily. The treatment on the floor currently is not enough for the foot traffic we get in the store. Scratching in one room but minimal scratching in the other. Both about 6x4 rooms

Open plan Living Kitchen Hallway -- wood flooring - needs sanding back and then varnished again

We’re moving into a new office space that has 110m2 of existing engineered timber flooring. The current finish is too dark so we would like the floor sanded back to oak and then re-stained in a light lime wash finish. All existing furniture items in the space will be removed prior to works commencing.

Require sand refinish with satin varnish 80sqm of timber flooring

Urgent time sensitive. Need asap start. Just bought house, have 10 days before need to move in. Floors need work. Description of task: EXISTING FLOOR: - have 46 square meters of chevron timber floor in apartment. Don’t like the colour - need floor sanded and refinished to match lighter Color of timber flooring in bedroom Install New Timber Floors in Bedrooms - have all materials purchased - would like to remove carpet in each bedroom (each room is 10 square meters) and install new timber flooring (materials provided) - the living room refinishing of floor should match the new floors for the bedroom as close as possible - plank installation concrete stick - linear pattern (not chevron) Whoever can start first is who I will book Cost being offered based on what I have been quoted by a company but they can’t start until later New floor installation: 50 per square meter - 20 square meters = approx 1000 AUD Existing floor sand and refinish 34 per square meter - 46 square meters = approx 1,500 Happy to negotiate Need someone who can start asap

25sqm living room area timber floor. There are stains soaked in so it needs sanding + staining + coating. Maybe just half of the area as the rest are covered by sofa and carpet.

Recently entered into contract for 2 bed apartment and preparing for the impending renovations/touch ups required before I can move in. Currently tenant in place for next 45 days so trying to secure everything in advance. Would like to have the carpet in the bedrooms removed and replaced with chevron engineered timber flooring (to match the living room). Also need to have the entire floor refinished. Its currently a dark brown/wood colour and I would like to change it to be like a grey frost. - Due date: Before Thursday, 2 May 2024

We require ~65sqm of vic-ash floorboards to sanded in a 2-bedroom house (with vic-ash stairs also needing refinishing). The wood has discoloured orange so we'd like to use a water-based finish eg. Bona traffic HD I have calculated floor areas (excluding bathroom & balcony and kitchen joinery) as follows; Ground Floor: 31m2 Upper Floor: 30m2 Stairs: 4.5m2 Total: 65.5m2 Start date: 01 February 2023