Hire a reliable appliance service in Central London

The washing machine door latch needs to be replaced. Washing machine model: IWDE126. The door latch is faulty, and currently the machine door does not close properly.

After my last descale of my Sage Oracle, the steam boilers descale drainage valve no longer seals and water constantly drains into the drip tray from the steam boiler. It likely needs a new O-ring or a replacement of that valve. I put £150 as my budget, but I don't know what this will cost. Happy to chat about it. I look forward to hearing from you Balsasz. You have great reviews.

my washing machine keeps flashing everytime i press start and i’ve checked child lock and the doors and it still won’t wash

Weber bbq ignition repair Calor gas heater service and or repair and replacement gas bottle.

Washing machine needs fixing - won't spin, likely as water not draining properly. Done some initial investigation but now need a professional. Machine will need pulling out of its position which will be difficult. Machine: Indesit IWDD washer-dryer (7kg + 5kg) Symptoms • Won’t spin. Spin-only cycle: timer counts down but motor never engages - no sound, no attempt to turn. • Drum rotates freely by hand. • Door lock engages correctly (single click on cycle start). • No error codes displayed. Diagnostics performed so far 1. Pump filter cleared. Removed kickplate, drained via filter, found a significant plastic blockage inside. Removed it. Impeller inspected — looks intact, spins with magnetic detents (normal). 2. Spin re-tested after filter clean - still won’t spin. Empty drum, so not an imbalance issue. 3. Drain/rinse cycles confirmed pump runs - humming/whirring audible for ~30 seconds. 4. Tilt test revealed water still sloshing in drum despite pump running and filter being clear. 5. Rinse + spin cycle attempted - significant water came out via filter afterwards, confirming pump is not fully clearing the drum. Best Guess So Far Pump runs but flow is restricted. Spin is then inhibited by the pressure sensor detecting residual water (safety interlock), which explains why the motor never engages. Possible causes: 1. Blockage in the sump hose (corrugated rubber hose between drum and pump) - possibly secondary debris from the original plastic blockage. 2. Damaged impeller blades not visible from filter side. 3. Weak/failing drain pump. Not yet checked • Sump hose (would require tilting machine). • Pressure sensor / pressure chamber hose. • Motor carbon brushes

Repair of lawn mower bosch pro silence

My fitted oven door falls down to far and does not close fully also feels heavier than normal - could be alignment issue / hinge issue.

The recliner stopped working.

Electrician to install new Electric Cooker

Looking for a plumber to install a proper cold water feed valve for a washing machine. There is an existing cold water pipe in place, but it does not currently have a standard threaded outlet suitable for a washing machine hose. The job is to fit a suitable isolation valve with a 3/4" threaded connection. The waste pipe is already in place. Access is straightforward (see photo).

Washing machine belt recently replaced but moving out of position and causing a rubber smell, need someone to diagnose and fix.

Wall 5M wide x 2.4M - paper is high quality woven fabric so experience required

Washing machine drain requires unblocking by specialist (currently causing leak into downstairs flat ). Flat is in London bridge

Received a new washing machine in my new flat need help to install it.

My dog chewed the wire and plug of my home treadmill Need to repair plug and the wire

I need a section of the skirting board in the kitchen cut out to be able to remove the washing machine which is currently integrated so we can install a freestanding one. need the sides where it has been cut left neatly and not rough.

My integrated fridge freezer door is not closing properly. I think the runners have come loose or the fixing to the panel has come loose. I have a hinge repair kit in case it's the main door hinge that needs fixing - see pics.

Washing machine leaking, unsure why

Twin sinks blocked. Dishwasher not working

Hello, I've sprayed WD-40 but the pin isn't moving up and down and I think this is why the radiator doesn't work properly. It's slightly warm, but the rest of the radiators are very hot as they should be, so maybe just needs bleeding but I don't know how to do this.