Find a local electronics repairer in London Central London

headphones broken on one side

Change 3 lampshades which are hard-wired to the electrical

A section of the garden wall to my neighbour collapsed today. It was an old wall that was leaning, and today it fell over unexpectedly. The section that collapsed was older and taller than the other part. The other part still feels (fairly) solid. I need someone to come and rebuild this damaged section of the wall. I would like to re-use the same bricks, possibly with some additional reclaimed ones mixed in. It needs to be stable & secure long-term fix. You are welcome to come view the wall any time if you need to do so for a quote, or I can send/submit more photos or a video if needed. Just ask me if you have any questions. You should have excellent knowledge of garden walls / structural walls, with plenty of experience doing similar work. I would ask that you are able to provide at least 2-3 references of similar jobs you have completed in the past. Ideally you would start as soon as possible, but not before 22 April.

changing 3 lampshades which needs the wiring changed

I was preparing my ps5 controller and accidentally snapped off the potentiometer bracket. I need help to prep the board and replace the potentiometer with my spare part that I sourced. Will require soldering. Video guide(after 10min): https://youtu.be/Oo50NkEgiNA?si=FMRhQrZ1kUpxGKER Just lost my job and hoping to keep this as cheap as possible plz

I need a few things drilling and fixing. A key safe (see photo) an extension plug fitting to the wall and a cupboard door hinge fixing. It’s only an hours with so would suit someone local

Remove old taps and replace with new taps, no leak issues

The outside of our house needs sprucing up. This would involve painting the portico and sides of the steps.

Wooden kitchen worktop chipped

*the fee is a random figure I put, please provide your quote* Replace the two pictured bathroom taps with the new ones pictured here also. Not in congestion zone.

"Protect" indicator or LED Flashing Search Find the answer to your question Search... What does the "Protect" indicator or the On/Standby LED flashing mean? The "Protection" light comes on when the receiver’s sensing and thermal monitors detect unusual operating condition that, if left unchecked, might damage the amplifier. Some receivers you may see the word "Protect" on the receiver's display. Other receivers have a flashing red light on the Standby LED. This can happen if there’s a dead short in a speaker wire or if you’re using very low impedance loudspeakers at high volume for an extended length of time. In thermal cases, the circuitry will automatically reset after a few minutes of cool down and the protection indicator goes away, and normal

I need the carpet to be deep cleaned. 11 steps and landing, please see pics.

stuck on safe mode ( playstation 4 slim)

Please can I get a quote for installing paving slabs on a set of 7 outdoor steps? (we already have the slabs) This to cover old concrete steps which are cracked, chipped and a bit uneven. Step dimensions are: 90cm wide 380cm long total (incl horizontal & vertical surface)

They don’t switch on I think the fuse needs changing

I need retiling under bathroom sink and new taps put on, also repairing water damage on wooden floor if possible, see pics attached

I need to remove my current ceiling light and rewire a new one

I need someone who can sand and oil my danish worktops in my kitchen and also remove a bracket from a bathroom wall, put up some hooks, measure up for a wooden blind and hang some pictures up. Ideally they might be good at carpentry and fashion me a wooden shelf/windowsill - Due date: Flexible

Ikea Kleppstad bed to be assembled, everything in room already - Due date: Before Saturday, 20 January 2024

My curtain rail holder fell down and I need someone to fix it. The tasker needs to have a ladder since I don’t have one. Preferably own tools as well since mine are limited. - Due date: Before Sunday, 31 December 2023