Hire a reliable appliance service in Sutton

Hi I would like to replace my kitchen cooker hood extractor and duct pipe. I will be replacing it with the same model that I currently have so it will be a simple replacement. The tasks are below - Replace kitchen cooker hood extractor - Replace duct pipe and vent I will be buying the hood and ducting kit, so let me know the labour cost.

I have a webb petrol self propelled lawn mower and the starting string has gone inside machine ,would like a full service on it plz

Petrol mower string has gone inside

We need the rubber seal replaced on our Candy Ultra washing machine. We have removed the old seal, and have purchased the new seal but need it fitted.

Mechanical bathroom extractor required to be installed, parts will be supplied. This will be a fresh install.

The fridge is already outside my front door

Fit door of cabinet back in- original screw hole is now too big New dishwasher means that kickboard needs to be cut and resized slightly to fit flush

Sage the Barista Pro (BES878/SES878) stops when running extraction/hot water/steam and 3 beeps sound

Extractor fan clipped out when wiping it down, it’s secure to the wall but not secure at to the top piece of the extractor so it’s slightly loose. Fan itself isn’t working either but mainly want to secure it back and then quote to fix the fan itself.

Washing machine does not pump out water after spin Make of machine Maytag 200/450

The Bosch Aventrixx washing machine the display showing E21 error. the start/pause button not working and machine is unable to start

Installation of washing machine

Install an Electric Oven (single oven, CANDY FCT686NR). The current oven will be replaced by this new one. No disposal required. Just connect, test and handover. Oven already available. Flexible with installation date.

I 've been having issues with the steam wand on my Sage Oracle Touch machine periodically for around 3 months, with the machine saying it's heating up but nothing was coming out. Eventually a build up of steam would come out or sometimes it would start, stops & then starts again. Now for over 1 week it has stopped working all together, and I decided to descale the machine & now the machine won't heat up at all its just stuck on the heating icon. I 've tried doing a factory reset but that has not helped and it still won't heat up, so now I have 2 problems. I want an engineer to come to my place to fix as I don't want to post my machine. What would be your estimate to fix these issues, confirming that you familiar with the Sage Oracle Touch machine and that these are problems you've dealt with before.

I need to install Ventrue Dashcam front and rear camera, using hardwire kit which I have purchased separately. I need a neat and clean out of sight installation.

Require general service for my singer sewing machine

diplomat dishwasher - dishwasher cycle isn't starting. Likely a clogged pipe or drainage issue. Pipe (small) under sink. Stopped working a week ago, has worked recently. Machine is flashing red 10x and beeping. Tried resetting didn’t work

Washing Machine installation, it needs a hole installed on the pipe work I think, there’s no existing washing machine plumbing. Washing machine in place with pipe.

Fit electric cooker/ hob Extractor fan

Connect dishwasher A pipe needs to be installed that needs to go around the bottom of all the cupboards. In the picture you can see the red line shows the route. The fridge on the right will be the new dishwasher location. The skirt boards need to be removed to get the pipe around and reinstated once done. Approximate Linear meterage of pipe will be 8m. Availability is after 6pm or weekends