Hire a reliable appliance service in Stratford

Water was not draining out of the dishwasher. I have removed the water but still the dishwasher is not powering on.

Indesit iwdc6105 not spinning

i’ve got a code p0299 ( turbo charger 1 underboost condition) symptoms: accelerates fine up to 50mph and then EML comes on and goes into limp mode. resetting the codes gives back power. doesn’t accelerate beyond 50 mph diagnosis: i have checked the waste gate actuators, boost pressure transducer, waste gate transducer, MAP sensor. All of these are fine. So the only other option is an air leak. I have already removed Air filter housing, clean air lines, vacuum reservoir. ideally i’d like the vacuum leak to be located and fixed. Most likely i think it’s a vacuum hose which has fallen off but i don’t have a pressure test kit to test the system.

I have bought a new cooker hood I need the old one removing and replacing.

Fix coffee machine, water leaking into coffee grounds area. Excess steam is coming from the side. Very little coffee produced.

I was de-icing my fridge when I accidentally punctured a tiny hole in freezer

I have dish washer that I no longer want it needs a pump . Dish washer is already disconnected . I need this removed /recycled

My dishwasher does not heat up the water. It is A Bosch company if it matters

The dishwasher due to wear and tear is faulty, and not heating. Model: Smeg DIC4-1

Sage coffee machine broken. No water coming out. We think the pump is ok but we are not sure.

Washing machine was making a weird noise. Stopped the load and I can't spin the drum by hand with the door open. I have drained it and cleaned the filter but nothing blocking in there.

My old washing machine wire is connected directly to the wall, I will need a new socket so I can plug my new washing machine in. I will also need my new washing machine installed and fitted.

Not working Electricity is not coming through

My sage coffee machine stopped running water. I did the descale and no water came out

Not dripping water . I was trying to descale the coffee machine and the water stopped running.

I’ve a budget slimline, free standing dishwasher that needs to be connected to the water supply under the kitchen sink. I also need a hole made in the kick board to feed the pipes to through. Approx length will be 4 to 5 metres of piping.

The Dyson upright its 3 years old won't come on, the blue light is on which tells me its charged. I replaced the battery 1 year ago.

I need my inbuilt washing machine to be taken out; so that the electrical repairman can access it and repair it. It is quite heavy and might need a 2 person job to just take it out; but the job should be quite simple. Some attached carpentry might need to be removed in the interim. Pictures attached.

fit only - Laminate worktop with sink and hob cut out.

I have an integrated microwave that stopped working properly. It still spins but it doesn’t heat the food as it used to do. So it has to be fixed or replaced. Would it be possible to let me know your fees for either of the following cases: If you come, manage to identify the issue and then fix it at the same time, how much does that cost? If you come and identify the issue, but then you need to come a second time to bring some pieces to exchange, how much does it cost? If you come and find out that it needs to be exchanged, so I buy a new one and you fit it, how much does it cost?