Hire a reliable appliance service in Central London

I need a professional that can cap my gas cooker and give me proof its done by a professional please

Washing machine not draining

i have a dual fuel cooker, that needs a plug and cable to be fitted, so that it runs well. i can provider or i you have the supplies , fine .

Need help fixing a warmer display.

Replace the glass on an induction hob. I already have the replacement glass. The job involves removing the hob from the worktop, transferring the components to the new glass, reinstalling it, and testing that it works correctly. Model BOSH.

A cooker hood extractor needs to be replaced with a new one

Rebooking task between Kalad and Hakan

I need my sink, dishwasher and washing machine plumbed in. For some reason my builder couldn't do it, they couldn't figure out the waste pipe and another pipe was too short. Need someone who can get a 55cm pipe and figure out the waste.

Fishy smell from oven. Someone from Domex has come round to look at the oven. He said the oven works completely fine. He said he did note the fishy smell and said it could point to an issue with the main electrics but not the oven itself. He recommended for an electrician to come round and take a look at the electrics properly to make sure there isn’t a potentially dangerous fault.

Dishwasher is not draining propoerly, and control panel is glitchy. Sometimes it lets you choose a setting and runs normally, but most of the time it rejects and glitches when you choose a mode, and so it’s hard to get started

Hi, I need someone to remove a broken integrated washing machine and prepare the space for a replacement freestanding washing machine. The existing machine is an integrated Candy washing machine fitted under the kitchen worktop. Appliance installers have advised that they cannot remove the integrated unit themselves and have asked me to arrange this before they can install the new machine. The job would include: • Disconnecting and removing the existing integrated washing machine. • Checking the clearance under the worktop and removing or adjusting any trim, panel, bracket, or fitting above the machine if required to allow a standard freestanding washing machine to fit. • Taking away and disposing of the old machine. • Leaving the water, waste, and electrical connections ready for the new appliance installer. I can provide photos of the current setup below. Please let me know if this is something you can do and provide a quote if possible. Thank you.

We need to replace the rear wheel break side of the yoyo babyzen stroller, we've taken the old wheel off but can't attach the new wheel

My Hotpoint washing machine has f05 showing and it’s not draining. I need it fixed today is possible, please.

Electrician to install new Electric Cooker

Looking for a plumber to install a proper cold water feed valve for a washing machine. There is an existing cold water pipe in place, but it does not currently have a standard threaded outlet suitable for a washing machine hose. The job is to fit a suitable isolation valve with a 3/4" threaded connection. The waste pipe is already in place. Access is straightforward (see photo).

Washing machine belt recently replaced but moving out of position and causing a rubber smell, need someone to diagnose and fix.

Wall 5M wide x 2.4M - paper is high quality woven fabric so experience required

Washing machine drain requires unblocking by specialist (currently causing leak into downstairs flat ). Flat is in London bridge

Received a new washing machine in my new flat need help to install it.

My dog chewed the wire and plug of my home treadmill Need to repair plug and the wire