Hire a reliable appliance service in Forest Hill

Need a handyman to repair integrated dishwasher handle? Might be slightly harder job as previously had to use glue to fix the integrated door...

The washing machine leaking water everywhere

1. Remove current integrated dishwasher and remove front panel. 2. Install 3 end panels. They will have to be trimmed or cut to size and then attach to the worktop. Install at 3 x points in photo. 3. Install new integrated dishwasher and drill it to the installed end panels. The new dishwasher is the same as the current installed on so set up should be the same. 4. Reattach front panel of dishwasher.

Gas hob is being replaced with an electric hob and the gas pipe needs capping off

Our upstairs radiators all heat fine, but none of our downstairs radiators have any heat, I’ve bled them which hasn’t worked, so guess either the system might need repressurising or an airlock needs removing. As it’s an old system I’m unsure how to adjust the pressure correctly.

Need to use a large waste compactor for online content

Hello, in preparation for installing a dishwasher I need to: 1) create / adapt a new water inlet for the dishwasher. There is already a washing machine in the same location so should be easy. 2) create / adapt a new water outlet to the sink - perhaps with y-joint - approx 1m from the location where the dishwasher will go

Our SNOO bassinet has stopped moving completely with the light blue, clips / wings plugged in and the sound is working. The engine sounds like it is working but the actual bed is stationary (a few days ago when it was still working there was a loud creeky sound coming from the leg area). Having checked online forums it is likely some O rings/ rubber grommets need replacing. We need someone who has experience with fixing a SNOO to come and fix it.

Our delonghi coffee machine won't send water through. We've tried all of the troubleshooting tips from the website.

Hi there, I’ve just moved into an older flat and need help with a small kitchen plumbing project. Scope of Work: 1.Install a tabletop dishwasher next to kitchen sink -Connect cold water inlet to the mains (next to kitchen sink) -Connect waste outlet into the existing under-sink waste pipe -Drill two holes through the kitchen counter (next to the sink) to pass inlet and waste hoses 2.Replace existing kitchen tap -Remove current tap -Install a new modern swan-neck tap with a pull-out spray (tap will be supplied) Access Details: The dishwasher will be positioned directly next to the sink, and the plumbing junctions under the sink are fairly easy to reach — there is no issue with cutting away additional back board of the rear of cabinet to make access easier, the cupboard is fronted by removable drawers for easier access. Please bring any tools needed.

I think it's the bearings

I think it's the bearings quote with part

I think it could possibly be the bearings that are going. When it spins it is making a very loud noise

A handy man will meet you

I think my washing machine is potentially leaking which has led to the vinyl flooring bulging.

I need to mount a Bosch dryer on top of a Bosch washing machine. The washing machine needs to be pulled out, the dryer put on top, the mains connected, and both units pushed back in.

F01 error sign on the washing machine - hotpoint

Looking for someone to come and look at my washing machine. Rubber seal on the door came loose mid cycle and flooded the kitchen. Looking for someone to make sure it’s properly refitted, reattach the wire clamp, and make sure there’s no other reason the machine will flood again.

My washing machine is broken. I need to come and check what is happening with washing machine. Or still can repair, or not anymore to repair.

Hotpoint freezer showing red light, cooling function is not working