Find an experienced plumber in West Melbourne

Just need to hook up an existing under-bench commercial dishwasher to the hot water supply.

Looking for plumber to remove toilet set and bathtub with no any damage to the toilet. Wall tile and bathtub as we install back the same

Fix water pipe, this was earlier fixed (pic attached) , but now leaking again . Its on main street so may need permits

Kitchen sink leaking and stopper in bathroom sink is broken needs fixing see photos

Need someone to install this new water filter I bought for my tap

Licensed plumber required to inspect shower hot water service and shower head. Please: - measure shower flow rate (L/min) - assess whether shower head appears water-efficient - note any concerns regarding excessive flow - comment on hot water duration with 50L system - provide written report/invoice with findings after inspection Need independent written evidence.

I need help with installing my washing machine

Toilet is leaking , need to be fixed .

Need help to fix bidet in washroom in our apartment. The apartment is in west Melbourne.

Licensed plumber required to diagnose and repair hot water system. The water is warm only reaching 36 degrees in both the shower and all taps in the apartment. Must be able to provide a report and receipt.

Any one can help to install a commercial coffee machine I consider any offer thank you

Looking to replace my tap with a new one. The sink looks like it needs to be removed to access the faucet.

Persistent smell coming from bathroom, would like someone to come out and have a look and unclog p trap or repair wax ring on toilet if that’s the issue.

I am seeking a licensed plumber to install a Rinnai B26 continuous flow gas hot water system onto a steel fence located in an outdoor apartment courtyard. Scope of Works: Install new Rinnai B26 unit (**UNIT WILL BE SUPPLIED BY OWNER**). 240 volt Power Supply already available and located at installation point. Extend existing 32mm gas copper line approximately 10 metres from garage (ground floor basement) to new unit location in external courtyard (Level 1). Gas line to run from basement to courtyard via pre-prepared penetration hole. **Please note GAS FITTING work will be required** by a Certified Plumber. Plumber will be required to provide VBA LICENSE before job offer is approved. Seal penetration point with silicone to prevent water ingress into garage. Connect to existing 20mm PEX hot and cold water lines (already installed by previous plumber). Commission system and ensure correct operation. Additional Requirements: Licensed and insured plumber only Provide Compliance Certificate / Gas Safety Certificate suitable for Body Corporate All works to comply with relevant Australian Standards and regulations Please provide: Quote including labour and materials (excluding unit) Date of Installation If site needs to be inspected before commencement of works, I can arrange for this to occur. Thanks, Federico

We have a pipe (kitchen waste water) and water supply line that is blocking the installation of a dishwasher. We are looking to have both pipes moved to run along the back of the cupboard to allow a dishwasher to be installed. Optional additional task (please note if you are interested in this) We have a shower mixer tap we would appreciate help having swapped over.

Licensed plumber only who can provide report and receipt please. Moved in to a new apartment which has some water damage on the ceiling of the bedroom and bathroom that needs to be investigated.

complete install. of https://www.ikea.com/au/en/p/havbaeck-toernviken-wash-stnd-w-drawers-wash-basin-tap-white-white-marble-effect-s09525918/ to replace broken basin (original unit no longer made)

Bathroom renovation finishing off, original plumber not able to get back until after next week and I’m keen to get this finished and functioning ASAP! Toilet, shower with mixer tap, vanity sink (bench top not yet attached so can be moved out of the way) and mixer. All fixtures and fitting already placed behind walls in correct positions just need final fitting.

My Miele dishwasher is showing an F11 fault (think it has to do with the filter) so it’s creating a bad smell and not working. Also my kitchen sink has snapped and needs to be replaced. I think just the spout needs to be replaced not the entire tap set. Need this done ASAP

I have a leak in the toilet when I use half flush. Please price to Replace inlet valve, outlet valve including seating washer and tap