Find a local network troubleshooter near you

We are upgrading to NBN FTTP and require the following work to be completed: Install a power GPO next to the NBN fibre box to provide power to the fibre box. Run a network cable from the NBN fibre box to the modem at the back of the store approximately 20 metres away. The cable should be properly routed through a cable duct or concealed where possible. You may use a nearby existing data point to extend the network connection to the back of the store. Please refer to the photos for the existing data point locations.

I need my wifi installed in the house

Configure UniFi access point to network, configure Dahua intercom to connect to 2.4ghz

"I have two Ubiquiti ceiling access points, a 16-port UniFi PoE switch, and an Optus Gen 2 modem. The Ethernet cables are already installed to the ceiling. I need the APs mounted, the switch installed, everything configured in UniFi, firmware updated, Wi-Fi optimised, and tested." The upstairs AP is accessible with a small ladder. The downstairs installation need a large ladder as the ceiling height is 5m. All cables are in place

**UPDATE** Have updated the task budget to account for on-site inspection of the office. Will then post another job after we receive an official quote for the labour + parts. We need a knowledgeable IT / networking technician to help optimise the network and Wi-Fi coverage in our office. We are looking for a "good enough" cost-effective solution rather than a massive infrastructure overhaul, as we plan to move to a new facility in about 12 months. Ideally, we want a solution using equipment that we can easily pack up and take with us to the new facility, or hardware that is budget-friendly. Our Setup: - Staff & Devices: ~10 in-person staff with roughly 25–30 active devices at any time (laptops, phones, printers, security cameras, etc.). - Layout: The office is upstairs (warehouse is downstairs and does not need coverage). The upstairs office has two areas that both need strong coverage: the main office area (approx. 8m x 5m) and an outdoor mezzanine area (approx. 3m x 3m). - Existing Infrastructure: We already have Ethernet cabling running throughout the main office area and fed to our security cameras. Scope of Work: - Assess & Recommend: Look at our current modem/router setup and advise whether we should use wired access points (utilizing our existing cabling) or a simple Wi-Fi mesh/repeater system to cover the main room and the mezzanine. - Installation & Setup: Set up and configure the agreed-upon hardware (we can purchase the hardware based on your recommendation, or reimburse you if you supply it). - Testing: Ensure all 25–30 devices (including printers and security cameras) connect reliably with decent speed across both the main office and mezzanine. Requirements: - Proven experience with small business or advanced home networking setups. - Ability to recommend reliable, cost-effective hardware (e.g., Ubiquiti UniFi, TP-Link Omada, or a solid mesh system like Deco/Eero) that fits a temporary 12-month lease.

Task Description: I'm looking for an experienced home networking technician to configure and optimise my home network. The job includes: Configure and optimise my existing home network. Set up and test two home offices with reliable wired and wireless connections. Configure my TP-Link Archer router, switches, and mesh Wi-Fi system. Optimise internet coverage throughout the house using mesh access points. Ensure devices roam seamlessly between mesh nodes. Configure the network for maximum speed, stability, and reliability. Check and troubleshoot any existing network issues. Advise on the best placement of mesh units and whether any additional hardware is required. Ensure smart home devices, printers, and other network equipment remain connected and functioning correctly. If possible, assist with my NVR/security camera network configuration. Current Equipment: TP-Link Archer AX3000 Router TP-Link Deco E4 Mesh Wi-Fi (multiple units) TP-Link RE815XE Wi-Fi Extender Network switches NVR with PoE security cameras Wired Ethernet throughout the home I'm looking for someone with experience in: Home networking TP-Link products Mesh Wi-Fi systems Ethernet networking Security camera networking (preferred) Please let me know your experience with similar setups and your availability.

I’m unable to set up a mesh network with asus zen wifipro xt12 after factory reset

I’d like a data cabler to come and organise the messy household data cabling at my property

Check whether existing network cabling can be used and/or improve the effectiveness of a home WiFi network. Set up home working. Connect Surface laptop to docking station and then monitor plus peripherals.

We have a home network that has 4 switches, 10 node mesh system and has repeated drop outs. I need it fixed.

I’m looking for a registered data cabler to install wired Ethernet backhaul for my home mesh Wi-Fi system. The NBN modem and main mesh router are located in the lounge. I need two separate Cat6 Ethernet cable runs installed from the main router location: ~ One cable run to a mesh Wi-Fi point near the front door ~ Two connections to the study - one for the mesh Wi-Fi point and one for a desktop PC The job should include: ~ Three Cat6 Ethernet cable runs ~ Three Cat6 Ethernet outlets at the lounge/main-router location ~ One Cat6 Ethernet outlet near the front door ~ Two Cat6 Ethernet outlets in the study ~ Cat6-rated wall plates, outlets and terminations ~ Testing of all three cable runs after installation ~ Confirmation that the two mesh points are connected using wired Ethernet backhaul Please include all cabling, wall plates, connectors, labour and testing in your quote. I estimate it's probably 20 to 30-meter cable runs from the lounge/main-router location. Only registered or appropriately qualified data cablers, please. Location: Greenvale House type: Single-storey (medium-sized home) Roof access: Available

We have NBN network, with a google nest mesh system. We have issues getting the printer connected, and want to be able to print, scan, etc from desktop computers to desktop computers. Brother MFC unit.

Existing network need help to reset and set up on new computer and add one outdoor device. At the moment we have 3 access points Templestowe location

Setup ASUS ZenWiFi xd5 with home internet

Outlook only operates in safe mode, old emails are not fully synchronising, cannot add another account. Must be experienced with office outlook to resolve issue

Description: I have set up four Ethernet cables from my modem to a central distribution box to provide internet to different rooms. However, the LAN ports are not working, and the corresponding lights on the modem do not illuminate when connections are made. ​I need an experienced network technician or troubleshooter to come over, inspect the central patch panel/wiring, test the connections, and resolve the issue so all the LAN ports in the house become fully functional.

We require an onsite technician to troubleshoot and resolve an external access issue for a VBox device at our Rockhampton site. Current Situation: - VBox is accessible internally via LAN - External access via public IP is not working - Router port forwarding has been configured, but may be incorrect - Device setup was previously incomplete but has now been finalised Scope of Work: - Verify VBox configuration and ensure setup is complete - Assign a static IP and disable DHCP - Confirm the correct LAN interface connection on the router - Review and correct port forwarding: Verify WAN/public IP and rule out ISP-related issues (e.g., CG-NAT), test external access using mobile data and provide a brief summary of the fix Requirements: - Experience with routers, NAT, and port forwarding - Ability to troubleshoot network access issues on-site - Must bring own laptop/tools Goal: Enable reliable external access to the VBox via a public IP address. Location: Rockhampton site (details provided upon assignment)

Have a cafe with wifi network require IT support from time to time no urgency come on weekends or nights earn extra big is per hour

I have a number of devices for my newborn which require certain network settings to operate. I’ve gotten some working (ie I’ve turned off band steering, moved to 2.4Ghz, amended SSID) - but it seems to have now caused issues with my printer and home (smart) doorbell. My Owlet sock (oxygen sock for baby) isn’t able to connect at all. Need someone to come and troubleshoot/configure my network settings and ensure everything is working.

Attend site to switch over existing networking gear (new Meraki security device and access points). Switch over internet connection at NTD. Ensure staff are connected to new network connection correctly. Update HP printers to new IP address (supplied). Merakis are setup by our IT team in the UK. You will need to also load Subnet Mast, Gateway and DNS1/2 when on site. Property has two separate internet connections. If for some reason, connection does not work, will refer to UK team and request follow up support to be negotiated with person assisting with this job. Expect overall job to take 2-4 hours max (assuming works smoothly).