Find a local software expert near you

Looking for an experienced microsoldering technician to install a Picofly modchip in my Nintendo Switch Lite. Task includes: - Safely disassemble the Switch Lite - Install the supplied Picofly-compatible modchip - Complete all required microsoldering on the motherboard - Correctly connect the required installation points - Inspect solder joints for bridges, shorts or damage - Properly insulate and secure the chip/wiring - Reassemble the console - Power-on and boot test after installation - Confirm the Picofly installation is functioning correctly - Confirm basic console functions still work I will provide the Switch Lite and Picofly chip. Please advise if any additional materials are required. Important: I would like the entire installation to be completed in person and in front of me while I wait. I’m not looking to leave or send the console away for the work. This is a fine microsoldering job, so previous Switch Lite/Picofly installation experience is strongly preferred. Proper microsoldering equipment and microscope/magnification are expected. Please mention your relevant experience, whether you’ve completed this installation before, and whether you provide a workmanship warranty. Hardware installation only; no games or copyrighted software required.

I want a person who can update me on the new MYOB account right system for a Mac Laptop. I need explanation of monthly reconciliations and balancing

I need a professional Cat6 Ethernet cable installation in Melton: - Option 1: Kitchen (Deco router) → Living room TV — approx. 10m ​ - Option 2: Garage (main Leaptel modem) → Living room TV — approx. 25m Routing preference: Prefer via roof/ceiling cavity if accessible; if not, surface trunking/skirting conduit as clean alternative. Please quote fully: solid-copper Cat6 cable, wall plates at both ends. Let me know which option you recommend for reliability/cost. Thanks Sasha

Identification required before task begins ie drivers licence or passport. The required dates are 16 September through to 22 September, with working hours of 9:00 am to 5:00 pm each day. Task required is as follows: 1. Remove small piece of equipment (weight approx 50g)) from packaging; 2. Install new software update; 3. Verify update completed successfully; 4. Remove from the programming equipment, reassemble equipment and return to normal configuration and packaging; 5. Estimated time per unit approximately 5 minutes; 6. Training will be provided on site before task begins; Required from 16-22 September, 9 am to 5 pm, 30 minutes lunch break (task minimum 5 days - extendable daily). Rate: $30 per hour.

Ethernet Cable Installation & Internet Setup Looking for someone experienced with home networking to run an Ethernet cable from one end of our house to the other and get our internet properly connected and working. The job will involve: * Running an Ethernet cable through/around the house as neatly as possible * Connecting it to our internet/NBN setup * Setting up the connection at the other end of the house * Testing everything to make sure the internet is working correctly Happy for you to advise on the best way to run the cable and what equipment/cable is needed. Ideally looking for someone who has experience with Ethernet/network cabling and can supply the required cable/materials if needed. Located in Ipswich. Please let me know your experience and whether your quote includes materials.

Looking for an experienced IT technician to install and configure a Synology NAS system in our office, including full automated backup setup for all office devices. NAS Model: Synology DiskStation DS925+ (4-Bay, Diskless, AMD Quad Core, 4GB RAM, 2x 2.5GbE) Scope of work: * Unbox and physically install the NAS unit * Install and connect the compatible hard drive(s) into the 4 bays * Connect NAS to office network (ethernet/router) * Power on and complete initial setup/configuration via Synology DSM software * Set up automated, continuous backup for all office devices (MacBooks/Mac mini’s ) to the NAS — no manual intervention required * Test and confirm backups are running correctly across all devices * Confirm the NAS is fully functioning and accessible on the network before you leave * Basic troubleshooting if anything doesn’t work first go Requirements: * Must have hands-on IT/technical support experience (networking, hardware installation) * Experience with Synology NAS and DSM software specifically required * Experience setting up automated backup software/tools * Own basic tools if required * Punctual and able to complete the job in one visit Location: Robina, QLD 4226 When: Preferred ASAP - by Thursday Budget: negotiable Please message with your relevant experience — especially with Synology DSM setup and backup automation — before accepting the task. Can schedule a brief call/zoom for scope discussion

Price negotiable!!! Windows 11 pro installation. Currently I have windows 11 home edition. Want a few more software installed will discuss. Brand new desktop

CAT6 data cabling installation to 8 locations on our existing 2 storey home. They should run to our room under the stairs and terminate onto wall plates

Looking for someone to attend site and install the Wi-Fi dongle/antenna for a Fox ESS inverter, then assist the customer with configuring the inverter to connect to their home Wi-Fi network. The Wi-Fi dongle/antenna has already been delivered to site. Technical assistance can be provided remotely while the installer is on site, if required.

Looking for someone to install a dual monitor arm (XCD Gas Bracket Dual Arm - from JBHIFI) onto a desk in Melbourne CBD (Bourke Street, near Southern Cross Station) The job involves clamp mounting the base, attaching two arms, and mounting two monitors - one 34" ultrawide (~8.5kg) and one smaller secondary. Basic cable tidy up after. Photo of the desk attached. Including the BACK of the desk where the clamp will attach. No drilling because clamp method is preferred. Ideally this coming week, most days are available - just needs to be scheduled ahead of time 🗓️

I need a Cat6a data cable installed in my house. Around 30 - 40 metres in distance. It needs to run from the front bedroom when the NBN box is to the back of the house which is the living room. Access to the roof is a trap door and you will need a ladder to access it. The front part of the house was built approxiamately in the 1880's and back part of the house is a renovation from about 15 years ago.

Summary of job - Please see image. 1. Current NBN NTD box is located in a bedroom in the house. Right outside house is the NBN pit (Outside bedroom window) 2. Existing ethernet port in living room but is connected to old NBN not NBN Fibre 3. Need the living room to be upgraded so I can put wifi modem in living room 4. Need a new ethernet port that will allow PC to plug in. This is located in the garage which is now a study room. Additional: Would also require a PowerPoint to be installed in the garage for PC plug in etc...

Cable modem and TV points next to existing power points in both bedrooms, duplicating/extending existing cabling in the dining room.

Description: I have set up four Ethernet cables from my modem to a central distribution box to provide internet to different rooms. However, the LAN ports are not working, and the corresponding lights on the modem do not illuminate when connections are made. ​I need an experienced network technician or troubleshooter to come over, inspect the central patch panel/wiring, test the connections, and resolve the issue so all the LAN ports in the house become fully functional.

Hi there, I borrowed a friends MacBook Pro. 2015, to use for study, but…in resetting and trying to upgrade to the most recent and available operating system, I managed to completely wipe the hard drive / operating system. I don’t need to recover any files or cloud or ye olde Time Machine but I do need to have more than a blank screen. The task needs to be done in person. Thank you.

Job Task: IT Professional Needed for On-Site Software Installation (Perth - North of the River) Date & Time Required: Saturday 16 May 2026, between 8:00 AM and 1:00 PM (flexible within this window, approx. 1 hour job). Location: Private residence in Perth, north of the river (exact address provided upon booking/confirmation). Job Description: I need a reliable and experienced IT professional (or competent technician) to visit my home and install practice software on my laptop. The company provides full step-by-step instructions for the installation. You will follow their guide to complete the setup. If any issues arise during installation, you may need to contact the company’s helpline for support

Hi guys, we put some security onto my computer and it’s locked us out :/

Hi Need to upgrade wifi system to install wifi Mesh. Thank you

Hi, I need someone to help me set up a photobooth software called breeze booth. Need someone who has either used this before or is amazing with windows and IT. Must help fully create the interface. THANKYOU

2 network cables to support 2000/200 or slightly more fibre speeds. Router is in kitchen and I need 2 access points installed (have the ap's). First location will be a general room/area and the second will be a bedroom. Single story home, tile roof, cable to run in walls and nothing external. > Rough estimate cable lengths required: > Cable 1 - 10-20m > Cable 2 - 30m cable