Find a trusted local electrician in West London

We need a central AC fitted in an office. It has one outside unit and 2 inside unit.

We need an experienced AC Technician / HVAC Engineer to conduct **6 urgent site surveys ASAP** on a white-label basis for our company. You will attend customer sites representing our brand, assess the air conditioning requirements, advise the customer professionally, and report clear details back to us so we can quote accurately. **Scope includes:** * Inspect existing AC units and setup * Identify unit type, make/model where possible, condition, and age * Check indoor/outdoor unit locations * Review pipework routes, drainage, power supply, isolators, and access * Advise on servicing, repair, replacement, or new installation requirements * Highlight any safety, compliance, access, or installation issues * Take clear photos and notes at each site * Provide recommendations, estimated labour time, and likely materials needed **Requirements:** * Strong practical AC/HVAC experience * Confident with split systems, multi-splits, condensers, drainage, and pipe runs * Able to speak professionally with customers * Reliable, punctual, and available at short notice * Own transport/tools preferred * F-Gas certification preferred Must be able to work discreetly on a **white-label basis**, with the customer receiving advice as if directly from our company.

Air con window seal installer

Power sockets tripping. Dont believe its an appliance.

Trotech air con appliance. One day old and fan has stopped working. Alternative to repair is shipping back to Germany so would like to get it looked at.

Air conditioning unit installation in room

Take old oven out replace it with another one

Cooker installation needed, wall has similar 3 phase wiring setup

1- Isolate ring 2- Install 1x Hagar amp MCB 3- Remove bunched radial from the ring 4- Test label and certify

Hi I need a quote for: Drain down heating system. Replace 2 x Drayton zone valves with Honeywell. Replace circulating pump and pump isolation valves. This is a domestic property.

Need someone to install new home gas cooker

Submetre change place , putting electrical shawer and electrical heater, sights fitted and exhaust fan checked.

Fix wall socket in kitchen

Gas certificate and boiler service Electricity certificate

I’m planning to get a small sauna + hot tub in the garden and would like to get a quote for the electric works. Sauna: Likely heater requirement around 4.5kW (to be confirmed by supplier). I'll likely require: •⁠ ⁠Dedicated outdoor supply for sauna •⁠ ⁠SWA armoured cable to rear garden •⁠ ⁠Outdoor rotary isolator switch •⁠ ⁠Hardwired sauna connection preferred Also installing: •⁠ ⁠Lay-Z-Spa hot tub (plug & play) •⁠ ⁠Weatherproof outdoor socket required nearby •⁠ ⁠Optional low-level garden lighting What I require: •⁠ ⁠whether the current consumer unit can support this •⁠ ⁠recommended cable route •⁠ ⁠whether trenching is required •⁠ ⁠estimated cost - assumed based on visit SWA needs to run from the consumer unit out to the garden. The cost offered is just an Airtasker placeholder and final cost to be determined upon site visit. When you put your offer in please apply with your standard day rate.

RCD tripped and not sure why. Just moved into new property so not certain about everything.

I believe my loop in circuit is now broken and I need an electrician to fix it. A bonus would be to replace 4 light fittings.

We have a wall switch that needs fixing as the plate and switch have come off. and a lamp on the ceiling has now exposed wires

Hi, I have an unsatisfactory EICR that requires a consumer unit upgrade. The report explicitly recommends the following to clear the C2/C3 codes: ​Supply and install an 11-way Metal Consumer Unit including SPD and Arc Fault Detection (AFDD) protection. ​Supply and install a separate 2-4 way Metal Consumer Unit with SPD for the Off-Peak supply. ​Please include the necessary Electrical Installation Certificate (EIC) in your quote or mention if you can't provide.

Just to install a new SPD for the distribution board, 2- replace 40am MCB with 32amp MCB , and to install grommet strip to the entry point of cables (fuse box)