Find a trusted local electrician in Clapham

I have an old flat with some areas missing plug sockets and some sockets badly installed (crooked)

I need help moving an Elektra 3-seat power recliner sofa from the top floor of my home down two floors. The sofa needs to be carefully dismantled first so that it can be safely moved downstairs. As it is an electric power recliner, there are electrical cables/wiring that will need to be disconnected and safely reconnected. The job involves: * Dismantling the 3-seat electric recliner sofa * Disconnecting the electrical connections/wiring safely * Carrying the dismantled sections down two flights of stairs * Moving the sofa to the new location downstairs * Reconnecting the electrical wiring * Reassembling the sofa * Checking that the power recliner functions correctly after assembly

Need 10 minutes of electronics soldering for LED strip - black and red strip have come loose from LED wire on back of LED bathroom mirror.

To move hanging light to min 650mm from back of wall and change for spot light not hanging light and make good. Put dimmer switch on x1 and quote tonsils put dimmer switch on x4 other switches (optional).

Emptying the bath last night tripped the electrics. The mains-powered smoke alarm would not switch off. There is not a separate fuse for the smoke alarm. We need to isolate the smoke alarm to prevent electric fire. Will also need a plumber to check for leaks.

I am looking to mount this tv (https://amzn.eu/d/0bhRC9oz) above a faux fireplace. Im pretty sure the wall is brick. We have a motorized tv mount (https://amzn.eu/d/04oPuOLL). I’m interested in cable trunking as well

i have a dual fuel cooker, that needs a plug and cable to be fitted, so that it runs well. i can provider or i you have the supplies , fine .

Need an electrician to please replace my heat alarms (2) as they are beeping

We have taken over a commercial building and need an old by pass cable removed , plus need electrics switched back on after replacing fuses

Bathroom The bathroom has an extractor that turns on and off with the lights. This means that it is not removing the moisture caused by showering from the room. Adjust the extractor to run on for at least ten minutes after the lights are extinguished. Kitchen There is a cooker hood fitted but it does not vent to the outside. It is hard to vent the cooker hood so fit an extractor to the external wall. Use a unit that is operated by a humidistatic switch. This will turn on automatically when the levels of moisture in the air reach too high a level. It should

The switch turns on the light but the dimmer doesn’t work. Normally by turning it either left or right the lights gets brighter or darker.

Hot water pipe and coupling to be installed on electrical water heater. New plastic Leakage Firewall needed to be installed and the old one removed

I need to change my standard toilet to a floating toilet and also change my bathroom sink to a floating sink. Need to change the radiators in the bathroom to towel rail and standard radiator in living from middle to side of the wall to a tall radiator. Need to change and install a new shower set and increase water pressure of the shower. Additionally need to change my lighting in living room, hallway and bedroom as they are all electrical ceiling lights not your standard bulb ones

Finish my media wall, electrics need to be added (lights and plugs), plasterboard needs to be finished and then skimming on the plasterboard so I can paint + put tv up

We have a fairly tall kitchen ceiling (see photo). We need someone with a tall ladder to change 3 of the ceiling lights and also fit a smoke alarm battery.

My electrical cooker needs to be installed properly

Currently no socket in the bathroom. Need to install a shaver/toothbrush charger in the bathroom.

The blind fell out from the holder in bloc blind (electric version)

H! Are you available for the fix of electric (motorolised) blinds by blocblinds? When we get the platform / tubus with the roller inside out of ceiling, unscrewed it to stick the white blind to the black, the roller was working and taking the blind. But when the platform is being hung on the top of window and we press the button at remote controller to roll it in back, the blind doesn’t come in. So it seems something is in the roller’s way when the platform is being hung, like squeezing the roller. Can you confirm you’re able to pick this task based in your experience with the motorolised / electric blinds? And if you’re available tomorrow 28/11 from 11:30 to 2:00 pm to come at SW2 5TA Or on 29/11 (Sat)

I have a 240 volt kiln which needs installing and connecting to the power in my residence. You will need to verify my power supply, ensure compliance, and properly connect. This has been done before at my precious address and I have disconnected to move