Find a trusted local electrician in Islington

I need an electrical mixer grinder to be checked and repaired. The appliance is giving a burning smell and last time it stopped working. I reset it but when I start a burning smell comes.

I need help removing the smoke alarm from the ceiling. It is very high so require a tall ladder.

Replace kithen tops by sourcing and installing new tops Replace sink with new. Replace gas hob with electrical hob. Lay kitchen floor either with tile or other. Will need base.

Replace around 50 GU10 bulbs in celling woth new bulbs (i have these here).

I had some recent work on my door panel and it was taken off but when the work was done and the panel was put back on,I relized later on that the electric window had stopped working and only worked if I held the button down untill window was fully open/close

Replace and upgrade an existing single electrical socket, with a new double switched socket units and waterproof / sealed unit. Electricity already wired. Only an upgrade required. Access to local electrical switchboard for turnoff/isolation available. Supply of the new double switched socket is also required in the job.

Selection of small tasks 1) 3xlights under kitchen cabinet repair/replace 2) Bathroom ventilation not working 3) 5 x ceiling spot lights have come out (see pic) 4) Dimmer switch not working 5) Move power socket behind wall so washing machine is flush with cabinet

Most of lights in the house and sockets not working. We used the oven and it all tripped i need someone asap

Two rooms shutter needs putting up , 1 small wardrobe together 1 blind up 3 electrical lights

New electric double oven cooker installation

We have a new light switch and black box that need installing including making good the plaster after installation

Electrician needed – socket circuit tripping / breaker won’t reset (older property). I’m looking for a qualified electrician to investigate and fix a socket circuit fault.

To hard wire electric oven and hob. Oven will need extra wire and potentially the hob. The hob is being installed into worktop tomorrow.

Cooker hood touch panel not responding, Falmec lumen wall mounted cooker hood, 3 years old.

wall mount cooker hood installation

Light circuit in one room has failed. Light bulb blew first, Fuse box switch for lighting circuit has NOT TRIPPED. I think problem is three gang dimmer switch (?). All other circuits are working including other lighting circuits. I'm in Islington short walk from Angel tube. Metered parking immediately outside. please quote hourly rate.

Replacement of 6 lights in my kitchen with: https://www.downlightsdirect.co.uk/halers-h2-lite-4-4w-fire-rated-adjustable-led-downlight-ip65.html. And then I have a LED strip that keeps crackling out so would think about that replacement.

Spotlights need updating and replacing in my flat. 23 in total

A review of how to fix the heat pump (Nibe)

I’ve just moved into a mid-19th-century house (N1). A number of sockets aren’t working and I’m unsure of the overall condition of the wiring. I’m looking for a proper inspection first, then quotes for any essential repairs. Scope: • Carry out a full EICR • Fault-find and diagnose several dead sockets (across multiple floors) Check: • consumer unit / fuse board and RCD protection • earthing & bonding (gas/water) • ring continuity on socket circuits • lighting circuits (including bathroom/kitchen safety) • any older/legacy wiring that needs attention What I need: • Registered electrician (NICEIC / NAPIT or equivalent) • Copy of the full written EICR + test results • A quote that separates: 1. essential safety fixes (C1/C2), 2. recommended (C3), 3. optional upgrades Please include: • your accreditation, • rough estimate for the EICR, • call-out availability, • typical rates for remedial work if needed. House is approx. 1200 sq ft over multiple floors. Flexible on timing within the next couple of weeks. Thanks!