Find a trusted local electrician in West London

Gas certificate and boiler service Electricity certificate

I need someone (or two people) to move an air conditioning unit from a second floor bedroom of a house to a first floor flat. The distance between the flats is a 10min drive. The unit doesn’t have a box and is 30-33kgs.

My electric scootet back wheel flat need replacing new tube. Im using pure air 5 ultra suspension

Re has our portable air conditioner

I have a split ac unit at home.its a Chigo AC unit. Need a trained person to service ac and outlet to and ensure there is no water leakage when I use it.

I need a dedicated 16A supply installed for a split air conditioning system. The supply needs to terminate at a weatherproof rotary isolator adjacent to the outdoor unit. Please provide a quote including testing and certification.

Check 3 ac units as the air isn’t blowing enough and isn’t cool enough

No power to air con unit, might be a fuse inside

How much to take this up two flights of stairs and install it

I bought a Bush 9k Air conditioner unit. I need installation today in my room. I also bought the window kit.

Installation of already purchased wall unit required

The unit is a Olsen and Smith 12000 btu portable air con. It turns on. Switches to the compressor after about 20mins, then 20mins later it goes off and just pumps out air like a fan. It will then turn on again 30mins later and cycle through. Barely cools the room down as it keeps turning on and off.

Split AC system in my 3 bed flat - needs repairs Parking provided Outdoor Unit floor mounted on balcony – Easy access Indoor Units accessible but can be removed from wall System Make: Samsung (2019) Refrigerant: R410A Piping: Liquid Pipe 6.35 mm / Gas Pipe 9.52 mm Indoor Unit (4): AR09RXWSAURNEU Outdoor Unit (1): AJ070MCJ4EH/EU All Units power up and system functions. After 10 - 20 mins the Indoor Units will stop and will display the following Error Codes: Error E2 01 - Issue with one or more of the Communication Cables that run between the Indoor and Outdoor Units (F1 F2 ports) Error E5 59 - Thermistor on the Outdoor Unit may be faulty and requires replacement TASK 1 - Resolve E201 (Communication Error) Voltage test all 8 (2 cables per unit) cables at both ends (Indoor & Outdoor) to try and identify the damaged cable(s) If necessary, run new cable between the Indoor & Outdoor Units to identify the damaged cable(s) Once the damaged cable(s) have been identified, you will need to run new cable between the Indoor & Outdoor units and hide this cable as is practical. This may involve cutting holes into the suspended ceiling in order to run the cable Any Making Good is outside of scope I will provide a 50m Drum of 3183Y Cable TASK 2 - Resolve Error E5 59 (Replace Thermistor) Replace the (Supplied part DB95-05268A) Thermistor on the Outdoor Unit TASK 3 - Re-Mounting the Indoor Units I‘ve now had fitted Wardrobes installed in 3 Bedrooms Much of the air now hits the tops of the wardrobes so less effective Need to re-position these 3 Wall Units so they are 550mm from the walls We can agree brackets and materials Prep for disconnecting Indoor Units (coolant back to Outdoor Unit) Remove Wall Units from the wall Disconnect pipework and cables from Wall Units Extend pipework and cables by as needed Install wall brackets Check / Maintain each Wall Unit (Air Clean / Coil Straightening) Mount Wall Units onto brackets Re-connect pipework and cables Test system

I have a wall mount AC which needs to be installed with all pipework etc

I’m planning to get a small sauna + hot tub in the garden and would like to get a quote for the electric works. Sauna: Likely heater requirement around 4.5kW (to be confirmed by supplier). I'll likely require: •⁠ ⁠Dedicated outdoor supply for sauna •⁠ ⁠SWA armoured cable to rear garden •⁠ ⁠Outdoor rotary isolator switch •⁠ ⁠Hardwired sauna connection preferred Also installing: •⁠ ⁠Lay-Z-Spa hot tub (plug & play) •⁠ ⁠Weatherproof outdoor socket required nearby •⁠ ⁠Optional low-level garden lighting What I require: •⁠ ⁠whether the current consumer unit can support this •⁠ ⁠recommended cable route •⁠ ⁠whether trenching is required •⁠ ⁠estimated cost - assumed based on visit SWA needs to run from the consumer unit out to the garden. The cost offered is just an Airtasker placeholder and final cost to be determined upon site visit. When you put your offer in please apply with your standard day rate.

RCD tripped and not sure why. Just moved into new property so not certain about everything.

I believe my loop in circuit is now broken and I need an electrician to fix it. A bonus would be to replace 4 light fittings.

We have a wall switch that needs fixing as the plate and switch have come off. and a lamp on the ceiling has now exposed wires

Hi, I have an unsatisfactory EICR that requires a consumer unit upgrade. The report explicitly recommends the following to clear the C2/C3 codes: ​Supply and install an 11-way Metal Consumer Unit including SPD and Arc Fault Detection (AFDD) protection. ​Supply and install a separate 2-4 way Metal Consumer Unit with SPD for the Off-Peak supply. ​Please include the necessary Electrical Installation Certificate (EIC) in your quote or mention if you can't provide.

Just to install a new SPD for the distribution board, 2- replace 40am MCB with 32amp MCB , and to install grommet strip to the entry point of cables (fuse box)