Find a trusted local electrician in West London

I need someone to remove our existing gas fireplace (photo 1) and fit an electric modern fireplace into the wall instead (see mock up). Then cover the wall in reeded panelling (I will provide this) and re-attach the TV. The wall is a brick wall.

I’m looking for a qualified electrician to carry out some electrical work at my property. There is an existing mains supply/meter arrangement with Henley blocks, as shown in the photos. I would like a new small consumer unit installed and connected to the main supply, with three separate 6mm² cables connected/protected from the new board. Work required: Fit a suitable new consumer unit, Connect the new consumer unit into the existing supply/Henley block arrangement. 6mm cable 1: connect supply to an existing consumer unit/fuse board in the garage. 6mm cable 2: supply an 8.5kW electric shower in the garage, including fitting a suitable shower isolator. 6mm cable 3: connect as a separate circuit/feed from the new consumer unit. Check earthing/bonding and confirm the existing 6mm cables are suitable for their intended loads and installation method. Test all new circuits and provide the appropriate Electrical Installation Certificate and Building Regulations/Part P notification where required. The 6mm cables have largely already been run, so this is mainly the consumer unit, terminations, protective devices, isolator and testing. Photos show the existing meter, main supply/Henley arrangement, proposed consumer unit location, garage consumer unit and external cable route.

My small electric lawn mower has stopped working. I think I may have mown over something hard e.g a stick or a stone

I am attempting a science project where I am creating a zip wire model to convert kinetic energy to electrical energy i.e light an LED. Need someone to help me set up the circuit and make the LED light up.

Hi, I need a qualified electrician to fit a new cooker connection unit and connect my cooker. ✅ Job details: - Cooker cable ALREADY in place (brown/live, blue/neutral, green-yellow/earth) - Existing open terminal box to be replaced with manufacturer-supplied connection unit + 32A MCB — ALL PARTS PROVIDED - Cooker just needs wiring into the new unit and tested - Standard UK kitchen, straightforward job ✅ Requirements: - Must be NICEIC / NAPIT registered - Must issue Building Regulations Compliance Certificate on completion - Please confirm price is ALL-INCLUSIVE: labour, test cert, VAT 📍 Location: [sw19 6TG] 📅 When: [03/10/2026] Please give me your fixed price quote. Thanks!

I need 8 or so sockets fitted

1. Extractor fan stopped working.. no idea if electrical or otherwise but need a new unit I expect and uninstall old and install new 2. Bathroom ceiling lights are a horrible bright white light like you’re in the dentist, anyway, tried to remove the bulb and it looks like it’s a connected unit to a wire ‘integral LED’ want these removed potentially and replaced with replaceable bulbs ( or maybe a dimmer on the wall if these can be dimmed, either or) 3. Want to box in the copper piping around the flat, also boxing in some exposed piping below the sink 4. We’re fitting a few bookcases, want to box them in

Need to install a cooker hood by replacing the existing one

Got a Bosch NBS533BBOB Electric Double Oven delievered. Needs a dedicated switch on the MCB and then connected and installed. Refer to the attached images.

Looking for a qualified battery-storage installer in the area to put in a myenergi libbi 5kWh system with the 5kW integrated inverter and have it installed as a battery-only system — there will be no solar. Details: Property is a second-floor/top-floor flat Proposed location is inside a large living room, against an internal wall Good ventilation and plenty of space around the proposed location Libbi weighs approximately 54kg I already have an approved DNO connection and can provide the relevant documentation Could you please confirm whether you: Are qualified and experienced in domestic battery/EESS installations Have experience installing myenergi libbi Are comfortable assessing/installing a battery in a second-floor flat under the current BS 7671 / PAS 63100 requirements

The table is 160cm glass with an electrical component to rise or lower table

I need a qualified electrician today (Tuesday 29 September) to prepare the electrical supply for a new Daikin air-conditioning unit being installed tomorrow, Wednesday 30 September. The AC installer has specified the following: • Install a dedicated electrical supply from the fuse board • 16 amp circuit/fuse as specified by the AC installer • Supply to terminate at an outdoor rotary isolator • Rotary isolator must be positioned within 1 metre of the outdoor AC unit • Outdoor unit: Daikin Sensira 2.5 kW single system • Please supply the appropriate weatherproof rotary isolator and other required electrical materials, unless agreed otherwise • Work should be tested and completed to the appropriate UK electrical standards Location: TW20 8AB, Egham area When: TODAY – Tuesday 29 September The air-conditioning installation is booked for tomorrow, so this needs to be completed today. I have attached the AC company's reference photograph showing the type and location of the rotary isolator required. Please only offer if you are a qualified electrician, can attend today, and can complete the job safely. Please state your total labour price, whether materials are included, and approximately what time you can attend.

Experienced bicycle/e-bike mechanic required in Abbots Langley, Hertfordshire to service and repair a large Alpine electric fat-tyre trike. I am looking for a comprehensive service, not just a basic safety check. Work required: • Front tyre has an active leak — inflates to 30 PSI but goes completely flat again within hours. Diagnose and properly repair the cause. • Rear tyre has a slow leak and also needs diagnosing/repairing. • Full hydraulic brake service/bleed and brake pad inspection. • Wheels, spokes and wheel alignment checked. • Headset, steering and bearings checked and adjusted/regreased where required. • Drivetrain checked, cleaned and lubricated. • All important bolts/fixings checked and tightened. • General inspection of the electric-bike connections. • Full clean/service of the trike. The trike has fat tyres and an electric hub-motor wheel. You MUST have genuine experience servicing bicycles/e-bikes, including hydraulic brakes. Experience with electric trikes, cargo bikes or fat bikes is strongly preferred. Please tell me what bicycle/e-bike repair experience you have when making an offer and whether you can complete the work at my home. Parts such as inner tubes, tyres or brake pads can be paid for separately if required, but please agree any additional costs with me before fitting them.

Wire in electric cooker. I tried myself but it isn’t turning on. Moved house so I know it works

Install my electric heater today

The fan has three wires and the wiring is not very clear in our house where the fan will be fitted. The wiring seems to be non standard so we need an electrician that can properly test the wiring so that the fan is installed correctly and safely. This is not just the usual two wires for a light fitting otherwise I would have done it myself. I just don't want to risk it being installed incorrectly! This is the fan: https://www.amazon.co.uk/dp/B0CQJZ1RPJ?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

I need a qualified electrician to safely reconnect a disconnected circuit for the dressing table lights in a bedroom. You just need to open the switch box beneath the dressing table, connect the broken circuit and ensure that the job is done perfectly.

Electrician required to install socket for the cooker

We have lots of wires (both old colours and new colours) where previous fittings were and are not experienced enough to know what should go where - so easier if we have an electrician fit the fittings (4 fittings total) We have fittings and bulbs they just need connecting

I’m planning to get a small sauna + hot tub in the garden and would like to get a quote for the electric works. Sauna: Likely heater requirement around 4.5kW (to be confirmed by supplier). I'll likely require: •⁠ ⁠Dedicated outdoor supply for sauna •⁠ ⁠SWA armoured cable to rear garden •⁠ ⁠Outdoor rotary isolator switch •⁠ ⁠Hardwired sauna connection preferred Also installing: •⁠ ⁠Lay-Z-Spa hot tub (plug & play) •⁠ ⁠Weatherproof outdoor socket required nearby •⁠ ⁠Optional low-level garden lighting What I require: •⁠ ⁠whether the current consumer unit can support this •⁠ ⁠recommended cable route •⁠ ⁠whether trenching is required •⁠ ⁠estimated cost - assumed based on visit SWA needs to run from the consumer unit out to the garden. The cost offered is just an Airtasker placeholder and final cost to be determined upon site visit. When you put your offer in please apply with your standard day rate.