Find an experienced plumber in Reservoir VIC

Replace an existing gas hot water system that is 85 L in size with a 135 L unit. In the same location the house is a two bedroom unit on the ground floor. Easy access to the unit.

Remove previous under-mount basin and refit new one

Hello, looking to have a Washing Machine picked up from Reservoir delivered to South Yarra and install installed please. No stairs.

Replace old gas cooktop with a new one

The toilet is leaking from the pipe behind it when I flush. Some water also comes out from the bottom of the toilet.

Need help with replacing my garden tap as it's stiff and leaking.

Need washers replaced in garden and a shower unit

Repost Replace old toilet with new back to wall toilet

Needing a plumber to just check our pipes behind reception desk wall with wire camera. Just for realestate peice of mind to transfer a lease ownership

Leak in bathroom/shower recess. Seeking quote for temporary waterproofing and potential for a larger bathroom renovation Visit to quote can be done from 07/02; must be available the job before 14/02

Installation of kaboodle countertops in an l-shaped kitchen. Removal of old farmhouse sink and installation of new top-down one. Materials are available, they will need some minor cuts.

I need my toilet replaced as it leaks and has had a few other issues in the past. Could you please let me know how much you will charge to replace and install the new toilet? I would like to install the Caroma Luna toilet

Help to unblock drain at car wash in reservoir

Replace old tap in the kitchen sink with a new tap. The tap will be provided

Toilet bowl does not flush properly, and shower gurgles when flushed (seems like air is trapped). Toilet is clogged now but nothing apparently blocking it.

Repair leaking kitchen sink tap- may need to be replaced. Then sand back and reseal the wooden bench surrounding the kitchen sink.

Change the tap in the kitchen to a retractable dual spray mixer. Change 2 bathroom taps and mixers. (3 sets) Change the bath sets. All have been purchased.

The The metal plug/strainer assembly (the part that sits in the sink hole and acts as both a filter and a push-down stopper) has detached from the drain pipe beneath the sink. It appears the issue is a missing nut or fastener. I can see the thread/bolt from the plug assembly hanging down below the sink, and I can see the pipe with the corresponding hole, but the piece that secures them together is gone. How to Fix It (As I See It) This should be a straightforward job for someone with basic tools and confidence: Obtain a suitable nut/fastener to fit the existing bolt/thread. Unscrew/detach the immediate section of the drain pipe below the sink Properly seat and secure the metal plug assembly onto the sink hole from above. Fasten it securely to the pipe thread from below using the new nut. Reattach the rest of the drain pipe and ensure everything is tight and sealed (a quick water test would be ideal). I believe this is a simple handyman or maintenance fix and does not require a licensed plumber. I just want someone confident to do the job properly so I don't have leaks.

Toilet flushes fine but accumulates water. The drainage is very slow and seems like there's a partial blockage down the line

Replacement of Kitchen Tap (Mixer) materials supplied.