Find an experienced handyman in Zetland

Replace 2x bathroom doors which are swollen at the bottom due to being improperly sealed. Two-stage job, same tasker for both visits please. Stage 1 (measure, book ASAP): measure the 2 bathroom door openings and check what weight the existing hinges can safely carry (hinges are fixed to a metal jamb and can't be replaced/relocated) — I'll order the correct replacement doors based on your advice, choosing between hollow core or solid/semi-solid based on weight and trim required. Existing doors are 1975x720mm though new doors may have a smaller gap below. Stage 2 (install, once doors arrive — I'll message when ready): Pick up the 2 new doors from the supplier and install into the existing frames/hinges (35mm thick, 720mm wide, height trimmed to the confirmed measurement — currently 1975mm, expected ~1990mm) Fit new lever hardware on 6 doors total: 1× entrance (master bedroom), 1× passage (guest bedroom), 2× privacy (the 2 new bathroom doors), 2× dummy (laundry, single-sided) Fit 4 door stops: 2× skirting-mounted (bedrooms), 2× half-moon (bathrooms) Seal all raw/cut edges on the new doors with a primer coat (a separate painter handles the full paint job afterwards) Fit 2x skirting doorstops on bedroom doors & replace 2x half-moon door stops in bathrooms. I'll supply the doors, all hardware, all door stops, and fixings. Please bring your own tools & screws if required. Free 4h street parking and a balcony to work from if required. Disposal of old doors not required - I'll book a council pick-up.

I need someone to install roller blinds - 3 blind 120cm wide

Please - remove 3 roller blinds from windows in one unit. - Remove one set of vertical blinds in 2nd unit - Install one of these roller blinds in another unit (same building) Install a sheer curtain at another window in same unit.

Simple hanging job of two internal doors. Doors and hinges already supplied. Doors are already sized to fit. Need someone to help mark and chisel/router the hinge recesses in the door jambs so the hinges sit flush, then hang and align both doors. Shouldn't take more than 1 hour. Details: - The hinges are already attached to the doorframe, I am hoping to leave them as is. - The doors will need to be rebated/chiselled out for the hinges so the hinges sit flush. - I already have the two new doors. I have kept old doors to copy spacing for the hinges, just in case. - I have a chisel, hammer, measuring tape and if needed I kept original screws. - I mainly need an extra pair of hands to accurately position, fit and hang the doors. Looking for someone with basic carpentry/door-hanging experience who can complete the job neatly. Photos of the previous doors in place are attached. Would like to find someone on Wed 12, Sat 15 or Sun 16th August.

Looking for someone to help remove, clean and reinstall 4 fly screens. The job includes: * Remove 4 fly screens from the windows * Give them a thorough clean * Clean the window frames/tracks if needed * Reinstall all 4 fly screens securely You’ll need to bring your own tools required to remove/reinstall them. Should be a fairly straightforward job for someone experienced with fly screens. Please let me know your availability and quote. Thanks!

Please find attached pictures of the 2 walls I would like to soundproof. Ceiling height is 2.7m. wall width are 4.5m and 3.3m. Curious to have a ballpark number both? Also curious about soundproofing solutions for doors.

Rebooking task between Burilda and Henning

I’m looking for an experienced painter/handyman to complete the finishing work in my kitchen following some renovation works. Scope of work: * Paint the kitchen bulkhead/headboard above the overhead cabinets (currently brown MDF). * Paint the new cornice once it has been installed. * Patch, sand and repair the damaged sections of the ceiling around the bulkhead where the old cornice was removed. * Prime and paint the repaired ceiling so it blends with the existing finish. * Ensure clean, straight paint lines and a professional finish. * Leave the area clean and tidy when complete. Please see the attached photos showing the current condition. Quote to include labour and materials. Location: Zetland, NSW

my current bathroom only has half shower screen, which makes it hard for people who shower and water splashing outside on the floor. So i need to install the other part of shower screen, including getting someone to buy it

I need curtain rod installed in the living area so I can hang curtains. It is a 1 br apartment with floor to ceiling windows

We need a full height Luna pet door (pictured) installed against a sliding glass door, and new hole/s dilled for an existing dropbolt.

Looking for someone to repair roller blind cord/chain that has detached. Please see photo.

Looking for a licensed electrician to install a ceiling fan in a room with a plaster drop-down ceiling. The job will involve: * Locating secure structural support (e.g. ceiling joists or cross beams above the drop ceiling) * Ensuring the fan is properly supported and safely mounted * Wiring the ceiling fan correctly (including any wall switch connection if required) * Supplying and using appropriate tools (e.g. stud finder or similar to locate supports) * Ensuring all work complies with Australian electrical safety standards Requirements: * Must be a qualified and licensed electrician * Must have experience installing ceiling fans (especially in drop ceilings) * Must bring all necessary tools and equipment * Must ensure safe and secure installation (fan-rated support if required) Additional Info: * Ceiling is a plaster drop ceiling (not solid concrete)

Shower screen literally just shattered, wasn't in shower at time juts randomly broke been fine for 5 years, need someone to replace it and clear out the glass urgently as have guests checking in tomorrow can do anytime today or tomorrow am preferably

I want to install a transparent pet door inside the balcony door (window). I have attached the image of the same pet door installed on another balcony door of my apartment as a sample.

2 ceiling fans need to be fitted into exisiting light fittings

The roller blind chain was broken, so it needs a replacement

I am needing an electrician to install 2 x ceiling fans to my apartment. 1 in living room and 1 in bedroom. These will need to be wired as not being installed into existing light fittings. The fans will need to be mounted for support also. I'll provide the fans, but will need the electrician to provide the mount / support mechanism.

Build or source and install awning for rear courtyard similar to the attached photo. Size should be roughly 360 cm wide x 65 cm deep. Roofing material should be clear polycarbonate and frame should be aluminium in grey monument colour if available.

Ceiling fan installed. Can be done on an existing light fitting as has a light on bottom.