Find professional cornice repairs near you

Cornice fell off. Still have the peice. Would like it put back on

Price to Install new cornice in bathroom aprox 1.85m x 90cm. I will supply cornice. Tiler will tile to ceiling and need new cornice over.

Replace 10-12m of cornice. I have already purchased the cornice (55 Cove cornice) just need someone to supply the adhesive and install it. Please let me know if you need anymore detail.

Install cornice in Bathroom Old cornice already removed Preferably able to pick up 90mm cornice from Bunnings Room size 2.7mtr X 1.8

I need the cornices to be done in the kitchen professionally. I have not bought cornices.

I need 7 meters of cornice fitted to a bulkhead

Cornice at my Alfresco has fallen down and loose from couple of places. Need to get it fixed.

Seeking a skilled plasterer to repair a ceiling, cornice and wall following the removal of old strip lighting. Scope of Work: Patching: Fill and flush all holes and wire entry points in the ceiling and wall resulting from strip light removal. Cornice Repair: Restore notched sections of curved cornice to match the existing profile. Restoration: Fix any surface damage caused during the detachment of old fixtures. Finishing: Skim coat and sand all repaired areas to a smooth, seamless, paint-ready finish.

I need coving done on both sides of a new stud wall. The wall is 3.3m long so about 7 linear metres of cornice/coving (the round white plaster that join wall and ceiling) or just under. Please include as materials/equipment and labour thanks. Final photo shows style that is already there. Thanks

Plaster 16sqm of fyrecheck and install 10m of cornice. Only requiring setting of the fyrecheck. Will be ongoing work at different locations. Send your sqm rate.

Cracks in my ceiling and along the cornice in my living area

- Painting the ceilings and cornice only in entire house with ceiling white flat paint. - Looking for someone who has painting licensing and insurance and can show proof - House floor size is 130 square metres (see attached Floor Plan) - Ceiling height is 2.4m - Located in Strathpine, North Brisbane, QLD Scope: - Two top coats in lounge, dining, office, hallway, bedrooms, wardrobes - Mould killer/blocker primer coat then two mould resistant top coats in toilet and bathroom - Two mould resistant top coats in kitchen Condition & prep: - Ceilings are in good condition and cleaned. Minimal prep should be required - Floors will already be covered with plastic sheeting and taped down to skirting (happy for you to adjust if needed) - Fans, lights and AC will already be covered with plastic - Minor overlap onto walls is fine as walls will be repainted later Other: - Painting walls, frames, doors etc NOT needed (will be done afterwards) - You will provide your own tools - Happy to discuss paint/primer brands. Prefer trade pricing if supplying, or I can provide paint—please advise preference when quoting - I can provide more photos, Airtasker limited me to 5 Timing: - Ideally this weekend or next week/weekend, but flexible Please include: - Proof of licence and insurance - Quote and availability

Includes labour and paint,

Supply and install gyprock sheets to garage ceiling and supply and install cornice around. Must make it ready for painting Size of garage is 2750x8500mm and about 2100mm high

Looking for a plasterer or handyman to repair a corner section of cornice in a bedroom. The Job: > * Remove damaged section and install new 90mm Cove Cornice. One side is approx 18cm, the other is 27cm. Tasker to supply the small length of cornice and adhesive. Need the joins set and finished so they are ready for me to paint later. I have attached a photo showing the damage and the 90mm profile. Please let me know if you have any questions!

Install approx 18LM of 90mm cove cornice. internal corners = 7 External corners = 6 End infill = 3 Material supply and install to be agreed on Note walls and ceilings may not be flat, level or plumb.

Bathroom walls and ceiling lining

We had a door installed and gap in the wall that has been patched. Guy moved away before he could finish so we just need the gaps in the giprock boards filled and levelled with the wall and cornice installed and prepped for painting. Shouldn’t take more than a couple of hours, just haven’t had the time to get it done. We have most of the materials including the cornice, cornice adhesive etc. but feel free to look through what we have and see what you might still need. Also have about 3-4 holes in our ceiling from fan installation and removing the old light fixture that we’d love to have patched as well.

Cornice has bubbled up. As pic. One cornice is smaller than the other

Need someone to set and cornice 250sqm worth of Gyprock. Cornice supplied. Happy to negotiate price. Send me your offers.