Find a professional Villaboard contractor near you

A carpenter has just finished putting in a couple of walls for a new bathroom in my granny flat and now I need someone to plaster the board gaps. The walls will be painted over and not tiled over and the walls are villaboard not gyprock as it is a wet area. I have hardies joining compound base coat and top coat plus a couple rolls of joining tape if needed. If you want to use your own materials that is completely fine as well.

Renovating the bathroom, needing someone to line the walls and ceiling with new villaboard. All materials supplied.

Need Villaboard on walls and aqua check on ceilings. The dimensions will be on the photo posted also the pictures of the bathroom and laundry. Laundry needs partial Villaboard installed. Quote supply & install

Repaint villa boards front at house that has faded from the Sun Colour: Monument grey We will supply paint if you can supply all other equipment. It’s 2nd story Front face and right hand side face Approx 40 sq m

Need 2x 1.2 nib walls sheeted Either villaboard or aqua check Gyprock works Tasked must supply and install

A price for a carpenter, remove sheets, and sections highlighted only, with mould shown, and replace with Villaboard or similar waterproof product.

Hi, I need two sections of villaboard replaced in my laundry. Roughly, 500x600 and 600x600. Note; the taps you can see in this picture won't be there when you do the job. Also, Im tiling over the top so you don't need to give it a complete finish - Im just looking to basically repair this area but I wanted villaboard there as the area is located behind the laundry sink.

im sheeting this carport roof over the next week or 2 with villaboard, just looking for a young bloke to give me a hand or 2, someone experienced on a day rate might have a lot more future work here and there as well.

**Experienced Gyprocker / Plasterer Required – Outdoor Villaboard Pavilion** **Location:** St Ives, NSW 2075 I am looking for an experienced gyprocker/plasterer to complete the finishing work on two newly constructed outdoor Villaboard pavilion screens before painting. **Work Required** * Tape, bed and finish **2 vertical Villaboard joints** (each approximately 1.8 m high) * Sheets have been installed with an **approximately 5 mm gap** between boards to allow for proper tape and setting compound * Fill approximately **90 countersunk screw heads** (around 45 per screen) * Sand and feather all work * Leave ready for primer and paint **Materials Supplied** * Villaboard joint tape supplied * Large tub of filler / compound supplied * Structure fully built and ready to work on **Important** This is a feature structure within a recently renovated pool and garden area. I am looking for a **high-quality paint-ready finish** where the joints and screw heads are not visible after painting. Please only quote if you have experience with: * Villaboard / fibre cement sheeting * Joint setting and finishing * Achieving a professional paint-ready finish I am not looking for the cheapest quote. I am looking for an experienced tradesman who takes pride in their work and can deliver a quality result. Please Provide Phots of your work. Thanks Stephen

Bathroom renovation needs villaboard resheeting 48sqm including around inset bath, shower nook and lower edge of skylight. Square set for floor to ceiling tiling. Villaboard supplied needs fasters etc.

Need sheets installed i will supply everything

I need to patch my wall in my bathroom with Villaboard plus paint the wall

Plasterer needed to set joints in villaboard of approximately 32 meters of recessed joints in walls and ceiling and one external corner 2ms high and 4 internal joints.

Supply and install 6mm villaboard to shower area to cover existing plasterboard. Cut holes for mixer and shower head and position approx 2mm above shower tray.

Cover existing glass splashback with villaboard then tile over with Kit Kat style tiles. Splashback is 690mm x 2190mm.

I have 3 bedroom , 2 bathroom and kitchen which needs villaboard fixing and use of acoustic clips in ceiling . Would prefer a fixed quote but happy to discuss day rate as well . Old sheeting has been removed and its ready to work on. Happy to work with apprentice as well.

Need to replace a villa board sheet which was damaged

Looking for an experienced plasterer/handyman to install Villaboard on my bathroom walls. Approximately 10 square metres. I can supply the Villaboard. Ideally would happen this Wednesday but can be flexible for the right person.

- make 1 x cut into one of the wooden wedges to complete the total wedging strip along the 4.35 m wall. - Supply & apply appropriate glue to append 60 deg wedge to top of wall - Supply & cut villaboard strip to run along wooden wedge and back up to the lourve on a 60+ deg angle - fix villa board to wooden wedge this is all in preparation for villaboard wall prime and waterproof tomorrow tiling is set to run along the villaboard wedge & wall below Must be done today. location : Kedron

Description: I need an experienced handyman/plasterer to tape and set a joint between Villaboard (fibre cement sheet) and plasterboard in my bathroom. Scope of work includes: - Preparing the joint between Villaboard and plasterboard - Applying joint tape - Setting the joint compound suitable for a bathroom/wet area - Sanding to a smooth finish ready for painting or tiling Details: - Small job, single wall joint - Materials can be supplied by you or I can provide (please specify in your offer) - Must have experience working with Villaboard and wet area finishes Location: East Maitland Timing: Flexible, ideally within the next couple of weeks Please include: - Your experience with similar jobs - Whether materials are included - Estimated time to complete