Find a professional roller shutter repair near you

My roller shutter for the back door is down. The remote buttons are making the motor noises to open it, but I think the shutter is no longer attached. So it makes the right noises, but the shutter stays down. I have a restraining order out, so need this fixed as soon as possible please.

My roller shutter is not working , power is ok and motor is ok but inside wiring to be checked

Roller shutter handle is coming out the wall, need it reattached and patched up.

I have electric secure roller shutters throughout my house, however one of the shutters has stopped responding to the remote control to go up or down I need this fixed ASAP.

Motor works fine, roller shutter is not coming down onto tracks and is stuck in the unit.

Manual window shutter not working. Purchased new winder box but still not going up easily. Keeps pulling winder box from wall as it’s really hard to wind.

One shutter jammed others maybe 10 in all need servicing

One shutter is jammed but all shutters maybe 10 in all need a service

Remove x2 roller shutters from the outside of our bedroom window. We will discard blinds no need to take it away. Just want them off.

Hi, we have a roller shutter that is letting light in. Due to the nature of the install the only way to prevent this is to caulk the side of the shutter. See photo. This is on a second story so a ladder is required. There is a roof to walk on so its easy once up there. See second photo. Colour: Monument. Must be done this Friday afternoon (22 November. Potential for another 1 or 2 shutters to require caulking on the day. Will increase the price if that is the case.

Need large electric roller shutter repaired I believe it’s come off the tracks inside

The roller shutter is getting stuck when trying to open and close it

Broken manual winder strap for roller shutter

The shutter for our window in front of the house would not go down, feels and sounds like it’s stuck at the top of its roller

Shutters are down and unable to open.need to replace the strings.

Put back in roller shutter which fell off. It is a bit heavy so i need help. Is approx 3.3m wide. Flexible with pricing and time. Someone with experience would be good as it was a bit tricky to roll back. I can help out as well.

Looking to have someone remove and dispose of 6 crank handled roller shutter blinds on the outside of my apartment on level 2. They’re crank handle controlled from the inside by a wire. 2 are on the front of the building, 4 are on the sides with part of them under the eves. It looks like part of the concrete board might need to be removed to access the roller mechanisms on those 4. 1 of the four is on the balcony which should be easier to access. Please ask me any questions you might have. I have circled the roller shutters in each photo to show you where they are.

We have two outdoor roller shutters on the second floor, both controlled by a single wall switch. One shutter works fine, but the other doesn't, although the motor still makes noise when the switch is pressed. A technician previously raised a concern about both shutters being controlled by a single switch, which could have caused the motor failure, though other factors like water ingress, faulty components, improper installation, or an incorrect motor may also be to blame. We need someone to inspect and fix the issue. Please note this is on the second floor, and a standard ladder may not be tall enough.

Motor is working but not rolling blinds up.

Install 3 x external roller shutters onto brick