Find a professional cement sheeting contractor near you

Source water proof timber cladding Attach to cement sheeting above garage

Replace two cement sheets outside above garage doors

I have one broken sheet that needs to be fixed in the roof of my front poarch. Size of panel 1200x1200mm Budget set to receive accurate quotes.

Posting it again as task expired but not possible to complete while we have all the rain. I have a chipped corner in outside cement sheeting which causes water leaks inside. I applied flashing and silicone but it didn't help. I spoke to a builder who suggests this cement sheet corner needs to be replaced and all the waterproofing applied. I need a skilled carpenter. As this is right on the corner it proves to be a tricky job and I'm prepared to pay extra.

MURRAY BRIDGE 5253: Our house was recently flooded. We need to REPLACE original flooring. 2 rooms are cement sheeting. 4 rooms are floor boards. To future flood resist our floors we are thinking to LEVEL floors with cement sheeting. Then paint or seal. advice appreciated and can meet on site. Need to compare quotes to give price estimate so below is not valid....

I need a piece of broken cement sheet from the ceiling of my front verandah replaced.

Replace and dispose of 1 asbestos sheet on garage wall, Meas 2060 x 900.

Cement sheet stud wall, need sheets replaced in both sides as it has been kicked and cracked

At Unit 14 / 50 Riverside Drive Mayfield West NSW 2304 The fibre cement sheet of the external facade of the warehouse has a roughly 15 to 20cm chip which will require it to be patched up and painted.

Please refer to attached pics of my deck. The deck dimensions are 6800 (L) x 3800 (W). The deck needs to be prepared for ceramic tiling onto blueboard so that under deck storage is dry. This is what is required for this job: (1) punch down all lifted deck nails (refer pic). (2) lay Blueboard only on deck surface using silicon adhesive and blueboard sheet tacs, NOTE: The blueboard needs to be raised at house brick wall and laid with a small tilt towards wire balustrade to ensure water runoff (refer pic). You will need to supply blueboard. I will supply silicon adhesive and deck nails.

Cement sheet installation for first floor external wall, roughly 110 square meters

Supply and install cement sheet ready for render 2500 x500

The plaster on the granny house in the backyard is broken due to kicking a soccer ball on it, i would like new plaster installed please

Repair and replace broken cement sheet under eave

Needing a handy man carpenter or chippy that can put cladding around my elevated deck 1. Side one - 3.2 meters by 1.4meters 2. Side 2 - 2 meters by 1.4 meters We are using 4.5mls thick cement sheet from bunning to make for an easier job, lighter. We will supply screws and what is needed. Location eltgam - Due date: Before Saturday, 9 March 2024

Wanting 2 cement sheets cut to fit inside the window frame shown to block the light from the window. Cement Sheets x 2 - 2400 x 1200 Need to be cut 2x - 1500x1200 Window frame - 1500x2400 - Due date: Flexible

Installation of 7 sheets of cladding. You do not need to nail. Just lift and hold in position. There is scaffolding on site and you will be working with two other carpenters - Due date: Needs to be done on Wednesday, 10 January 2024

Looking for a plasterer to stop up, square set, base coat cement sheet & sand our new bathroom renovation. The bathroom is half painted plaster & half tiled. See attached photos & floor plan (red indicates tiled area). I’ve attached photos, any questions please ask! - Due date: Needs to be done on Friday, 5 January 2024

Hi I need a few guys to hang sheets of cement sheeting on walls and ceiling in a 4x2 m space. Sheets, glue and fixings already supplied. I am happy to help measure and cut if needed - Due date: Needs to be done on Thursday, 23 November 2023

- Remove broken sheet and replace with approx 62 bricks (4x 13 rows). - Make it neat, remove bottom row of 10x header bricks and also lay the top row with 10x header bricks to match rest of the fence. - This is a body corp job so I will need an invoice. - It's approx 900W x 1100H. See photos - Due date: Flexible