Find an experienced door installer near you

Someone to install 3 interior doors in my house

Installation of new internal door

5 internal doors to be installed and old doors removed. Hinges and handles included.

Installed a used roller door

Need to install a door with a frame to the master bedroom bathroom

Need a door installed on a bathroom, including sizing, handle and hinges

Sliding door provided, remove the current door and install this as per pictures

Need doors replaced with existing hinge and door handle

Install barn door in the Master's ensuite. Door and hardware are ready. Door size is 2300mm x 1020mm x 40mm.

4 x mirrors to hang up - gyprock wall with timber frame behind it. 1 x door closer to be installed.

Hi, I'm looking for a handyman or locksmith to help with my front door roller latch. The current latch (EVARA brand) is protruding slightly and preventing the door from closing smoothly. I need assistance in assessing the latch and adjust or replace it.

Install existing old door handle and lock on already painted and fitted new door. Need to drill holes in collect location etc to get the job done.

You need to supply the half moon door stopper from Bunnings, it's $5/unit. I need 3-4 units

Need a reliable airtasker to supply and install a door closer for my basement fire door.

Install a door on a laundry room

We have all the knobs and bits for the door etc but don't have the equipment do drill through the door easily for a new whole or into the architraves without ruining them. Wanted 4x doorknobs and catches installed

Installation of a new front door with dimensions 820 x 2040. It is replacing the old door so the old one will need to be removed also.

Hi, I require either a carpenter, door installer, or locksmith to make an alteration to allow a latch to fit inside the strike hole again. The lock itself appears to work in that the key locks and unlocks the handle and latch of the lock, but the gate door won't ever lock. Looking closely, the latch doesn't sit inside the hole anymore and hits above it, due to a misalingment. When it was installed a couple years ago, it was working fine, however the door may have recenty shifted or warped, causing this, although I'm not sure. I am seeking someone to correct this, ideally by first checking the hinges and alingment of the door, etc. If this doesn't work, then perhaps remounting the strike plate higher or trimming off a bit of the metal at the top of the strke hole, or whatever you suggest. Best Regards, Mike

Need someone to trim and install a new solid door (2180x1200mm) to replace an old one (2040x1140mm with window). I have the door, locks (digital + manual), and hinges. Please include fitting, jamb if needed, extra materials, and removal/disposal of the old door in your quote. Looking for a clean, professional job.

I need a door knob replacing. Will require new door handle