Find experienced local tradies in St Kilda East

I need someone to repair damaged areas of plaster and install cement sheets in shower areas as a part of a bathroom renovation. I will be doing DIY demo of tiling, and need someone to assist with repairing areas of damaged plaster following this and ensuring the shower wall is prepped prior to waterproofing, likely involving installation of cement sheeting.

Damage brickwork requires patching and wall rendered. Render colour matched with other wall, must be somewhat accurate. Clean finish required as it's for a customer at there front door entrance.

Installation of two outdoor awnings, 3m x 2.5m, and 4m x 3m. Requires electrical wiring and installation into facade and brick, and second, facade and timber.

Drill into a brick wall so I can hang a canvas painting.

Dry wall installation to studs

Need a dual power point installed in a garage (brick wall)

Some walls in our house have some cracks. Problems have been fixed but I need the resulting cracks patched up and painted over.

I have purchased an outdoor awning that needs to be installed over our rear deck - and also an outdoor roller blind over our kitchen window. Dimensions and install locations in the photos. The house is made of Hebel so I imagine it’s just a matter of ensuring the awning brackets are secured to the door/window framing. Thanks!

I need 2x new double GPO’s in my bedroom

I’m trying to install wardrobes and the power point is in the way. I’m wanting it removed as soon as possible please (desperate for wardrobes!). Ideally just to make it safe and allow my wardrobe to sit flush, then one day in the future we can relocate it. Brick walls. The wardrobe in the picture can be moved out of your way to do the job. Must provide proof of electrician license before I assign the job 🙏🏻 Many thanks

Move 2 powerpoints from skirting board to wall above. Will need to be extended and surface mounted most likely. Install isolation switch for new induction cooktop, will probably also need to be surface mounted. Oven is not needed, so 20A circuit + cable from oven would be used as new dedicated circuit for the 4.7kW cooktop. Plenty of slack on it. New cooktop is ready to be wired in and go. Needs to be done by qualified electrician with COES issued for work.

I pulled out my old built in robes and there was no ceiling above them. I have two pieces of plaster that have been cut to size ready to go. I think I have all of the equipment (I’ll confirm with you before booking), including: - 3 lengths 42x19mm of premium pine for support - 50mm plasterboard screws - 60mm countersunk treated pine screws - joining tape - multi-filler - ladder and step ladder - drill driver and screw driver - multi filler. It doesn’t need to be pretty because I’m putting new wardrobes back in the space, so it won’t be seen. Please tell me your experience with installing plasterboard and your availability for today :) I can assist holding it up while you drill it in. Thanks!

I have a large and heavy picture that needs to be hung on a plasterboard wall. the dimensions are 215cm h x 166cm w. I need it to be done by Friday please

Need wall plastered. Have removed cupboards and exposed brick. Wall is 2.3m x 2.5m approx.

Outdoor awnings need adjusting and servicing.

A small platering job to repair holes left in plaster board after removal of air conditioner

Replace x2 balcony balustrade (one each side of the balcony) with new aluminium balustrades. Measurements: H 88cm, W 81cm The front facing part of the balcony is concrete

I’ve had a gas heater removed that has left a hole on the outside of my wall. Needs to be patched up and rendered as close to surrounding wall as possible.

Remove the existing kitchen tiles Replace the damaged plasterboard Delete/replace the window with plasterboard Approximate window size 2mx1200mm wooden house

We have a small hole in our bathroom ceiling that requires plastering. It’s where our shower head will go, area is about 25 cm x 25cm.