Find experienced local fencing contractors in St Kilda East

We need our fence to be straightened (if possible) and new thick sturdy plinth placed at the bottom to ensure it doesn’t slant again. I’m not keen on getting a new fence so anything to save this fence is preferred. Once done, I will paint it.

I need a 30M long section of 1.8M high wooden fencing replaced. I'm sorry. I realized that we only need 30M of fencing, not the original 45M I may want to increase it's height, or add extra bits of fencing to it. But for now this quote l was the fence replaced and and the old fence taken away. Very easy access to fence area. Must have all insurances.

Supply and Install new pedestrian entry gate section. Complete with paint finish, letterbox, house numbers, intercom etc. architect drawings and planning approval complete

Need someone who has experience doing picket fences (please do not comment if you are not experienced in these) to: 1. Remove and dispose my current existing picket fence which is old and falling apart 2. Supply and Install new Windsor style picket fence (hardwood) the same height with front pedestrian gate and swing gate for my car (I am wanting a motorised swing gate however if this is not something you can do, I can source this separately) - small spacing between pickets at 15mm for privacy due to main road - height: pickets all to be the same height at 1800mm, posts 2000mm - I will be getting Angelina capitols to go on the top of each post but will do this myself (similar to attached photo) Flexible on date

The gate needs to match the existing horizontal slat fence (see photos). I’ll be reusing the current slats, so the job involves building a new timber frame and attaching the slats to it. What’s required: * Build a sturdy timber gate frame (materials provided) * Install diagonal bracing to prevent sagging * Reattach existing horizontal timber slats to match fence spacing * Install and align hinges onto existing metal posts * Install gate latch/handle * Ensure gate opens/closes smoothly and is properly aligned Materials provided: * Timber for frame * Screws * Hinges * Gate latch You will need to bring: * Tools (drill, level, saw, etc.) * Any additional fixings required for mounting to metal posts Notes: * Gate width approx: 900mm * Height approx: 1600mm * Posts are metal, so experience fixing into metal is important * Want a clean, professional finish so it blends with the existing fence Attached is a mock up of the design we are looking for

We need to extent 9 existing fence posts so they are at least 180cm high for pool fence compliance. Thinking something similar to the photo #4. You will probably have to attach blocks to the existing posts which are about 18-20cm too short. Alternatively can the existing posts at a 60 degree angle for VIC pool compliance. We are located in St Kilda East / Balaclava

Remove the pool gate door only (fence to remain in place) on 20 February 2026 and reinstall on 22 February 2026. Photos are attached.

Need paling fence panels picked up and taken away from site They are cut into about 1m sections and was 4.4m long x 1.8m high Pick up st Kilda

After a quote for a timber fence approx 1.8m height x 11-12m length, see picture attached (maroon fence), put in arbitrary number in the following - so please leave your experience, rate and availability

Remove rails above fence

Need the back fence only replaced my fence is 3 metres in length

Need help supplying and installing horizontal tension wires to our colourbond fence to allow us to plant jasmine climbers. Dimensions: Approximately 7m width (3 fence panels) and likely need 5 lengths of wire approx 30cm apart (fence height is 1.8m). To ensure there is no damage to the fence, we think it should be attached to the 4 fence posts either side of the panels.

Looking for brick work repair and repointing. Crack in front fence, veranda needs attention (Repointing, loose bricks at the top reset and attention required for above the entrance under the plaster (Bricks sagging)) See pics

full height fence approx 2m long Abolish existing pine log posts & boards Install new posts and clad my side, leaving other side to neighbours garden ready for them to do what they want. A painted colour masonite board behind vertical timber battens on my side.

Some of my fence panels are rotten at the bottom and need replacing. Also the bottom plinth.

Need to make good existing front fence, reinstate broken sections, approx 5 areas. Needs to be made presentable and complete but doesn’t need to be fully repaired 100%.

Burnt 3.5 m of timber fencing requires removal and replacement including associated lattice and post caps

I am about to take down a backyard fence that is falling down. I would like some quotes for building a new fence, about ten meters long, two point four meters high. All materials will be provided.

Car Gate needs to be replaced with the same material same colour 3 m length. removal of all Car Gate,supply and installation of a new one. need a breakdown of the material and lead time for the job Thanks

Hello I need a new steel/aluminium style fence for approximately 18m around my back yard. Circa 1-8-2m high. Black or grey in colour.