Find experienced local fencing contractors in Carnegie

Build pine treated fence for front (~11m) and side (~15m) - 1.8 to 2m and sliding gate for car. At the front of the property there are brick pillars. I would be interested in having these raised by 30-50cm and rendered. Additional handyman work needs to be done at the property.

5M Bamboo Fencing need to be removed and reinstalled with new one with Eden Natural Bamboo Premium Screening

pls see attached photos for the property we are planning to build on, can you please give me a quote to repair the Fence at the left side and Replace the one at the back and slashing the grass coverage completely so the site is ready to build.

The pickets in the frame of the gate are loose and a couple came out. I have all the pieces but possibly the picket area also needs framing to strengthen them once they’re all back in.

Looking for an experienced installer to complete the installation of a DIY aluminium slat fence. Scope of Works: * Install approximately 14 metres of aluminium slat fencing. * Install 2 custom-made gates (already fabricated and on site). * All materials are supplied and available on site. * Installation only – no material supply required. * Ensure the work area is left clean and tidy upon completion. Please provide your experience with aluminium slat fencing and gate installations.

Quote Remove low broken fence , build a higher one 12/13 long steps (rough metres)

Provide a quote for fence extensions? $10 is not installation fee. I need someone to extend fence by mirror existing fence pattern. Requirement: 1. extend fence 1590mm from existing post to a new post 2.install gate with handle 3. extend fence 900mm from existing post to the house wall the existing gate - i or you can remove and you can re-purpose as new gate. i can uninstall picket from the gate frame another gate frame -- i have previouly 900mm gate frame which was installed. you can use it as gate frame. I will purchase material below and paint them. Cypress Pine picket [email protected] Cypress Post [email protected] Treated Pine Plinth [email protected] Treated Pine rail [email protected]

I need someone to extend fence by mirror existing fence pattern. Requirement: 1. extend fence 1590mm from existing post to a new post 2.install gate with handle 3. extend fence 900mm from existing post to the house wall the existing gate - i or you can remove and you can re-purpose as new gate. i can uninstall picket from the gate frame another gate frame -- i have previouly 900mm gate frame which was installed. you can use it as gate frame. I will purchase material below and paint them. Cypress Pine picket [email protected] Cypress Post [email protected] Treated Pine Plinth [email protected] Treated Pine rail [email protected]

Remove current wooden fence approximately 32 metres and install/build a new wooden panel fence that separates two houses. Also replace a small section. Of a second wooden fence at one of the properties

Front Fence Installation – Vertical Slat (aluminum)(10mm gap) + 2 Pedestrian Gates Looking for an experienced fencing contractor to supply and install a front fence for my client. Scope of Work: * New vertical slat fence * Approx. height: 1.5m * Slat spacing: 10mm gap * Finish: White (powder-coated preferred) * Include 2 pedestrian gates (one at each end of the fence) * Full installation required (posts, framing, alignment, etc.) Site Conditions: * No existing fence (clean install) * Easy access Measurements 1500w (gate) 1300w 950w 1270w 805w 1550w 3130w 1000w (gate) 3000w Important: * Do NOT include locks – electric locks will be installed separately * Gates must be prepared/compatible for future electric lock installation Requirements: * Must supply all materials and labour * Proven experience with vertical slat fencing * High-quality, clean finish required Quote must include: * Full breakdown (materials + labour) * Estimated timeline * Gate hardware details (hinges, latch provision only – no locks) This job is for a client, so I’m looking for a reliable subcontractor. Clear quotes and proven experience will be prioritized. The most qualified contractor will be awarded the job.

We need a garage door repaired to close all the way. The situation is that the door closes and hits the side will which causes it to not fully close. The motor is brand new and working well. We also need half a fence extension added. Materials ready to go.

Have purchased a giants solar fence energiser and fence wire and require to instal on fence

I have a rear timber fence with 4 rotten fence posts,I need them replaced with 4 galvanised steel ones

1. Replace the section that has fallen over and the part of the fence that remains (Photo 1).Total fence length is approx. 9 m length along driveway. Dispose of old fence . 2. Provide a 2nd quote to replace the 2nd part of the boundary run of approx. 17m (photo 2) Include allowance for removal and disposal. Driveway access as shown in photos.

Fix & repair boundary fence , roughly 3.5 m in length.

Need supply and install of double gate on the side of the property. 2.5m wide * 1.8m high.

Need to install an automatic fence. Include cost of motor, posts, rails and other accessories. Need full turnkey offer. Fence opening - 3.1m long * 1.8m high. Can connect to existing fixed fence

Option 1: New timber or colour bond fence Option 2: Use existing timber fence and reposition by 30cm

Need supply and install of brick fence in the backyard. There is an existing brick fence so this new bricks need to be installed in continuation to the existing bricks fence. See photos for reference.

Need to supply and install the sliding gate in the front. Existing fixed panels will remain, only need the sliding section of the fence including motor, rails and one post