Find a professional bricklayer in St Kilda East

We need to repair a hole in the wall in the exterior and interior wall of the house. Need to fill hole with bricks and mortar, we have the bricks. The exterior and interior doesn’t need to be painted

I’m looking for an experienced handyman or tradesperson to restore a hollow brick wall after a failed installation attempt. The wall currently has 10 M10 chemical anchor studs (Ramset ChemSet) installed. I need these removed and the wall repaired to a clean, paint-ready finish. Scope of work: - Cut back/remove 10 steel anchor studs (flush or slightly recessed) - Clean out drilled holes (~14 mm diameter, hollow brick) - Properly fill/repair holes using appropriate masonry repair materials - Sand and finish surface flush with surrounding wall - Leave surface ready for painting (painting not required unless discussed) Important: - Wall is hollow brick (not concrete) - I’m after a neat, professional finish – ideally as unobtrusive as possible - No structural work required, but quality of finish matters Please only apply if you have: - Experience with masonry repair / patching - The right tools (grinder, fillers, sanding, etc.) .

Need bricklayer to cover the holes about 50-60 bricks

Vintage clay bricks need to be cut horizontally (not I half). And cemented to wall. Approx 70 bricks

Repair work to front brick pillar. Repair gap that joins the pillar to the wall. Experienced bricklayer preferred. Measurements of pillar: Height 1320mm Width 469mm Depth 350mm Gap approximately 10-15mm Photos attached depict the pillar that requires repair (highlighted in yellow) and the front and back image of where the pillar has come away from the brick fence.

We have an old wall where the mortar has turned to sand. Looking for an experienced brickie to remove the old mortar and repoint bricks Approx 10lineal meters and only bottom few rows of bricks