Find an experienced handyman in Malvern East

I have a couple of lamps I would like converted to cordless touch lamps

Hang 1x large art frame (175cm x 137cm) Hang 5x smaller art frames (A3-A4 size) Screw in 4x Arlo security cameras to various parts of house.

Someone has thrown an egg or a piece of fruit at my house on the front render. I don’t know how to clean off the stain. Need someone to come over and do it with the right chemical cleaner or tool. Very accessible. I have a ladder that easily reaches.

Bunch of nails and random stuff around the house I need to remove. Photo are just examples

Handy man needed today in East Malvern to attach a freestanding vanity to wall. Will also need to cut a hole in the back of the unit for plumbing.

Hello, I need two flyscreens fixed. One has come off the railing(?) Keeping it in place and the other has been pushed out by my cat trying to escape. The dimensions are: Bedroom l: 79cm h: 39cm Bathroom : l: 59cm x 67cm There's also a blind that my cat has chewed through the cords that I wanted looked at to see if it can be fixed or needed to be replaced.Blind: l: 237cm h: 211cm. Ideally I would like these fixed next Thursday (9/10) between 3pm and 5:30pm.

Built in Miele microwave oven has something wrong with latch - hard to open and close and now won’t stay on unless we press on door.

Rotten part of window wood needs replaced / repaired

Hi, A little bit of the timber door frame has gone bad as pictured. Looking to replace that little section with fresh wood. Materials not supplied. Thanks

Movement in outdoor tiles has resulted in a gap between tiles before a ledge. Approx 5-6m long. Need someone to gap fill / re caulk to close the gap. Black if possible.

Supply and install weatherseal for our tilt garage door to stop leaves and debris from being blown inside. Garage door is 4810mm wide. We prefer a door mounted seal.

I am fitting out a store in Chadstone shopping centre. I’m looking for an experienced handyman / builder to do a few jobs for me, listed below. 1) Purchase, cut to size & install concrete sheeting (from Bunnings) to POS counter (3 sides, right angles, flat surface) with necessary adhesive. 2) Assemble & install clothing racks (made up of galvanised piping rods & attachments that are provided & screw into one another) and affix to the floor & wall via the mounting plates (3.7m each rack, 2 racks) 3) Affix custom sign to concrete sheeting (that is affixed to POS counter) using provided template & nuts & bolts (v easy) Looking for an all inclusive job, just want my mind taken off it. You will need to fill out a form to be inducted as an ‘approved contractor’ at Chadstone, so even better if you’ve already done so. Please drop your quotes.

Our gate isn’t closing properly, I think it needs a new piece of wood and nails to hold it in place.

Urgent decking board removal for access point creating for plumbing and digging hole. And create a trap door/access in deck.

Looking to have someone supply and install a seal on our garage door to stop debris from being blown into the garage. Prefer for the seal to be installed on the garage door, not floor. Please provide details of the proposed seal in your offer.

We need two security doors installed. Front door measuring 2050 x 820 mm and back door 2050 x 720 mm

Install 4 internal ceiling-mounted roller blinds, 1 double S-fold ceiling-mounted curtain and 1 S-fold ceiling-mounted curtain from Tuiss Blinds Online. The height of the ceiling is 3 metres. We want the job done by someone who has previously installed Tuiss blinds and curtains.

Description: One of the side protective bars (runs along the lower edge of the car body) on my 2016 Honda HR-V has come slightly loose — one of the fixings is broken, causing it to sit slightly ajar. I need someone to securely reattach it so it looks flush with the body again. I’m not particular about how it’s done — zip ties, screws, washers, adhesive, etc. — as long as it’s safe, looks clean, and holds up over time. Photos attached for reference. Ideal for: • Mobile mechanics • DIY car fixers • Anyone handy with car bodywork

I have a Heat n Glo Mezzo 1300 AUB fireplace. It has a RC300 remote. The remote has always worked but this morning it has somehow un-paired itself from the fireplace. The remote is still fully functional, just not communicating with the fireplace anymore. Need help finding the control module for the fireplace, and putting it in pair mode again so that the remote will work again. Fireplace is a 2-sided see through fireplace that's built into a floating wall. I've removed the front panels but haven't been able to obviously see the control module.

I pulled my blind too hard and it fell! I need this roller blind rehung please.