Find an experienced handyman in Hughesdale

The roller door to the garage isn’t closing properly, it comes down but then immediately goes back up and then just stays open.

Timber Window frame is water damaged and is rotting. Needs to be repaired

Hi, I need to get the window frame repair wooden window frame that has extensive water damage.

The strings are tangled on two wooden blinds. Need to be untangled or strings replaced.

Replace the old water faucet with a new set. The new faucet is provided.

I have got three split ac units throughout my house and got one condenser unit at the roof. all needed to be maintained.

I need someone to help with two quick tasks. One is to install a simple bike mount to the wall in the entrance way of my apartment. It's two pieces. It will need a stud finder. The other task is to affix a mirror to the wall of my apartment with screws.

i bought a boxing bag off rebel and i can’t screw the bolt on they just keep spinning

Need to get garage door fixed as picture show the current status

Cut to size and install 3x Delaco accoustic panels in the master bedroom.

Looking to fix the old roof from inside as there are gaps between wall and plaster on ceiling. If you want to consider to quote in this job happy to go that way

Need to fix the bottom fabric of the couch. It is currently lagged so it needs to be tightened or to replace to fix it. Please provide me with a quote.

I have a large teak mirror 1500 by 950 weighs around 25kgs I need hung - solid brick walls Also looking for a handy person to install a flat pack cupboard / pantry. See pics for measurements

Assembly and anchoring of an Easyshed onto an existing concrete block

I have 2 windows that the bottom corners have rotted away. The timber has rotted right through so don’t think bog would fix? Someone suggested I would need to cut the rotted section out and replace with new timber

Repair front lhs panel. Headlight not damaged

Remove 5 door fixed fridge, compressor still work.

Loose wire and it keeps turning g off when using it

I have an Ikea customised PAX unit I need assembled and installed, with some slight tweaks to make it fit the space. I designed it to fit a tight space so the installation/affixing needs are: - I don't want to remove the carpet under it but I do need to have the skirting board removed cleanly to make it fit flush against the wall at the back. - I need a small opening at the back near the bottom so a powerpoint can peep through, then a small hole at the same height but on the left side of the unit (close to the back) so a power cord can pop through. I.e. the plug and cord will run through the back of the unit on the inside just behind the drawers in the lower half of the unit. Not sure what tools you'd need. - It needs to be affixed to the wall near the top. Photos attached. It needs to go in the corner right near the sliding door wardrobe. Skirting board behind it should be removed. It should touch up against the skirting board on the right but the skirting board doesn't need to be removed there. I don't need packaging removed.

The frame around the kitchen window behind the sink has water damage and needs repairs. The job includes removing and replacing the damaged section, prepping the surface, and applying fresh paint. Looking for an experienced carpenter or handyman to complete the task. Please provide a quote for the job.