Find a trusted local electrician in Central London

Just got a new electric cooker needs to disconnect the old one and connect the new one

https://www.argos.co.uk/product/7958454 I purchased this bush ftc60b twin capacity electric cooker from Argos it is arriving Tuesday morning. I need assistance with installation.

fit a dimmer switch on wall lights and hook ups speakers to our sound system

I am looking for an electrician to inspect two chandeliers in my home, one in the living room and the other on the hallway. Both have stopped working following bulb failures. In both chandeliers, one or two bulbs burst, and one of the incidents produced a burning smell. I have since removed all the bulbs from both chandeliers. The other electrical sockets in the living room and corridor are working normally, so I would like an electrician to investigate the issue specifically with the two chandelier fittings. Work required: 1. Inspect both chandeliers and their E12 bulb holders. 2. Check the wiring, connections and bulb holders for any signs of damage, overheating or electrical faults. 3. Establish whether the problem was caused by the previous bulbs or whether there is an underlying electrical fault. 4. Repair any faults identified and advise on suitable replacement LED bulbs. The chandeliers require E12 screw fitting bulbs, suitable for UK mains electricity. Please provide a quotation for the inspection and repair work.

Looking for a qualified, experienced electrician to remove existing ceiling track lighting and install two pendant lights, which I will supply. The kitchen has a **3.4m-high concrete ceiling**, with no access from above. Suitable access equipment will be required The wiring should be neatly concealed in slim, discreet white surface-mounted trunking, with the route agreed before work begins The job includes: - Removal of existing track lighting - Installation of both pendant lights - All necessary wiring, trunking, fixings and materials - Suitable access equipment - Electrical testing

Boiler stopped working yesterday, repressurised it and now it's causing my electronics to trip

Install 3 chandelier ceiling lights. Looking for a qualified electrician to remove 3 existing single-bulb ceiling light fittings and replace them with 3 new 6-bulb chandeliers. All three lights will be supplied. Existing ceiling wiring and light points are already in place. Work includes removing the existing fittings, installing and securely mounting the new chandeliers, connecting the wiring and testing all lights. Please quote for labour and bring any necessary installation tools and fixings.

Isolate mains Cut wire and back box chases Replace wiring as required Fit back box, switch plate and test Fill chases Client will sand prime and paint

Hello, Hope all is well. In our 2-bed flat, the fridge seems to be causing the consumer unit to trip the fuse. We cannot work out if the fuse board is faulty or the fridge, and we would like to get it fixed as the fridge is currently not working. Any questions, please ask. Let me know if you can attend tomorrow, please. Thank you, Dominik

Cooker needs pulljng out. Proper mice wesh wire needed to plug any gaps

Qualified electrician required for lighting alterations in a three-storey house. All existing lights/switches are live and working. Hallway/stairwell switches Replace/reconfigure 4 switch plates using Click MiniGrid + Quinetic for a consistent look, retaining wired switching where practical and adding RF only where needed. Final controls: • GF front door: outside light + GF hallway • GF bottom of stairs: GF hallway + 1F landing • 1F landing: GF hallway + 1F landing + 2F landing • 2F landing: 1F landing + 2F landing GF hallway already has 3-point 2-way/intermediate switching. 2F landing light already has 2-way switching. For the 1F landing light, retain the existing wired 1F switch and add 2 Quinetic RF controls at GF bottom of stairs and 2F landing via a QURWM3 hybrid receiver. Proposed switch kit is NOT YET ORDERED. Please confirm compatibility/quantities before I buy. Work includes: • Confirm existing hallway switching so correct 2-way/intermediate modules are fitted • Install 4 matching faceplates/modules • Install/connect QURWM3 receiver and existing wired 1F switch • Pair/test the 2 RF switches and all lighting No new chased switch wiring between floors. Stairwell wall light Replace existing working fitting with supplied Alabaster Stone Diffuser Wall Light. Allow for drilling/new fixings if needed. Ground-floor hallway light Remove existing working track lighting and install supplied Interiors 1900 Fargo 3-Light Large Inverted Pendant. Requires cable routing approx. 3m across ceiling using cable/wire fishing, with a few strategic access holes if needed. Please minimise ceiling damage. Making good/plastering/painting not required. I supply both light fittings and, once confirmed, switch kit. Please supply normal sundries/cable/fixings. Ladder available onsite. Please confirm experience with 2-way/intermediate circuits, Quinetic/Click MiniGrid, and cable fishing.

Lightbulb was changed and it tripped the lights So no lights now Fuse box is ok

need to have my new electric cooker installed, locally only please as this would be a quick job. there is no recycling old cookers. just a simple installation of this electric cooker. your travel costs is not covered so its ideal for somebody who is local - this is what i have: https://www.currys.co.uk/products/beko-pro-aeroperfect-airfry-fdca6732cm-60-cm-electric-ceramic-cooker-silver-10287516.html?srcid=198&cmpid=ppc~gg~0102+(Shopping+Ads)+MDA+-+Cooking+Free+Standing+-+Generic+All+-+PMAX~~Exact~21823835212~&mctag=gg_goog_7904&kwid=GOOGLE&device=c&ds_kids=&tgtid=0102+(Shopping+Ads)+MDA+-+Cooking+Free+Standing+-+Generic+All+-+PMAX&gclsrc=aw.ds&&gad_source=1&gad_campaignid=21813533499&gbraid=0AAAAAD7JKSKR6mSc8is2OMRSsV8LoIcwc&gclid=EAIaIQobChMIrrm7ra3ulgMVKotQBh0u3ADEEAQYBSABEgIHJ_D_BwE

to attend a property and inspect/fix a bedroom light switch. Issue: The bedroom light switch is not turning the light off. The light remains on, so the switch and wiring need to be checked and repaired.

We need an electrician to reinstall a Zanussi induction hob.

We need someone to disconnect an electric and gas cooker to connect another electric and gas cooker

To change over 5 existing light sockets to new 5 light sockets.

The bathroom fan comes on with the light but switches off again after about 2 seconds. I have removed fluff from it but it did not fix the problem. It is a ceiling mounted Vent-Axia fan.

Fuse box switch caused a minor power cut in my flat. I flipped the switch back on and everything works fine, except my electric oven. The stove works and the oven comes on but its not heating up at all. I tried to reset the timer like what I read online but no changes Brand: Montpellier Model: MDOC60FS

Aircon isn’t working and I assume the filter just needs cleaning. I have a ladder but feel free to provide your own tools