Find a trusted local electrician in London

Kitchen light not working Changed Bulbs They cary between not working, partially working or flickering Availablity as soon as possible Potentially the wiring

I need two jobs done one is to fit a Chandelier in my living room and the second job is to fit new light switches one for living room and for one bedroom. Qualified and years of experienced fitters needed for this job

Have 2 roof solar panels that need to be lined with pigeon netting all around, they're on an accessible 1st floor roof side above a ground floorextension

I need to just connect my new cooker

Hi, I need a BG Electrical WP22RCD-01 Double Weatherproof Outdoor Switched Power Socket installed at my home. Requirements: Location: rmt 4pt Purpose: For charging electric cars using my existing Mode 2 cables Socket details: IP66 rated, 13 A, built-in latching RCD, 2‑gang Safety: Must be installed by a qualified electrician Please provide a quote including socket installation and any minor wiring adjustments Notes: I already have the BG WP22RCD-01 socket, electrician only needs to install it safely. Looking for a budget-friendly installation.

The fuse on my ceramic cooker has blown, and therefore the cooker and the oven are not working

remove broken Ikea hob from counter. The glass top has been broken in the front right corner so just need it replacing with the new one. already purchased. also if you can discard the old for us that would be really helpful.

We need to change a light fixture from dimmer to normal switches

My dishwasher is causing the kitchen circuit breaker to trip. When the dishwasher is turned on, the circuit trips almost immediately. After switching off the dishwasher at the wall, the circuit breaker can be reset and works normally. This suggests there may be an electrical fault within the dishwasher (possibly heating element, wiring, or internal component). I need a qualified appliance technician or electrician to: • Diagnose the cause of the fault • Confirm whether it can be repaired safely • Provide repair if possible, or advise if replacement is required

I am looking for a fully certified electrician to disconnect and safely terminate existing 2 electrical points at our retail store on Carnaby Street, ahead of closure works. Scope of Work: Isolate, disconnect, and terminate all electrical points Ensure compliance with UK electrical safety regulations Provide confirmation of completed work if required Requirements: Must be fully qualified and certified Valid insurance Proven commercial/retail experience preferred Important: Only certified electricians will be considered Thanks

Hi, I have an unsatisfactory EICR that requires a consumer unit upgrade. The report explicitly recommends the following to clear the C2/C3 codes: ​Supply and install an 11-way Metal Consumer Unit including SPD and Arc Fault Detection (AFDD) protection. ​Supply and install a separate 2-4 way Metal Consumer Unit with SPD for the Off-Peak supply. ​Please include the necessary Electrical Installation Certificate (EIC) in your quote or mention if you can't provide.

Fix electrics in bedroom (outlet is 'hot' and zaps me when touched) and two bulbs out in the bedroom which need to be fixed / changed. Also need help hanging a small/mediumish sized mirror and a small/mediumish sized disco ball, neither super heavy. We have a ladder but our ceilings are very low so might not even be needed. Please don't offer if your price ask is going to be wildly different than what my budget is. I have not gotten the electrics fixed for 1.5 years because I have never been able to afford it as I have been out of work for 6 years and now I have this amount I have saved up which I want to use for it if possible. If not it will have to stay as is. Happy to give a glowing reference for you.

I’m looking for a qualified and experienced electrician to complete the following jobs in my flat: Scope of work: - Replace/install bathroom light fitting (photo labelled 1) - Replace/install hallway light fitting (photo labelled 2) - Replace one faulty wire in an existing living room cable run The cable route already exists (photo labelled 3) One wire in the cable has a fault We temporarily ran a wire externally and it works perfectly The task is to re-run that working wire properly within the existing cable route - Install a new light fitting in the living room (after the wire is re-run) - Install an electric towel rail in the bathroom (photo labelled 4) Important details: - Property located in WC1N 1BL (Central London) - Tube access is very close and convenient - No parking provided – if you choose to come by car, you must cover congestion charge and parking costs yourself - Please bring all necessary tools - Light fittings and towel rail will be provided All work must comply with current UK electrical regulations When responding, please include: - Confirmation you are a qualified electrician - Your availability - Estimated time to complete Any questions before starting Thanks!

Kitchen heat alarm is beeping, Has reached end of life and needs to be replaced. It is on the mains with a backup battery. Should take around 20-25 min to do tops.

The flexible duct between my extractor fan exhaust and the exhaust pipe has become disconnected and needs reaffixing Not sure if the existing flexible ducting is still good or needs to be outright replaced

electrician needed to install light fitting in master bedroom. Install is over a bed. Ideally either today Sunday 18th before 2PM or Monday 19th available all day

Disconnect old electric cooker and connect a new one up

Just to install a new SPD for the distribution board, 2- replace 40am MCB with 32amp MCB , and to install grommet strip to the entry point of cables (fuse box)

I have a flourescent bathroom ceiling light which I want swapped for another one which I have purchased (the whole fixing)

Replace the 8 Panel Switch Board and fix the cables.