Find local downlights installers in London

Supply and Replace 4 downlighters in bedroom - currently one is working, three not working and bulbs have been replaced.

Hi! We moved into a new flat yesterday- and We need to change the downlights in the kitchen- on the ceiling, as well as below the top cabinets. They’re a bright white- we need them to be warm white, and bright. Some of them are not working, and will need a complete replacement. Thanks!

Hi! I Need to replace 2-3 recessed downlight bulbs in the bathroom ceiling, they are motion-sensor activated. It looks like it may be a GU10 fitting, but not 100% sure as it’s fixed into a base. I have a small stepladder available. No rewiring or new installation needed, just a bulb replacement — happy for you to confirm the exact type on site

Work required: * Fault-find the non-working downlights and establish why they have stopped working. * Check the electrical supply and connections to the affected fittings. * Refit/repair the hanging GU10 downlight and retaining mechanism. * Check that the existing connectors and wiring are safe and correctly terminated. * Replace any simple fittings/components if necessary. * Test all affected lights and leave everything safe and working.

There are 4 light fittings in the ceiling of the bathroom. Only one works and the rest do not. New bulbs don't fix it. prepared to pay for New transformers or new fittings plus airtasker labour

I would like to replace 2 burnt out down lights in the bathroom.

Installing 3 new down lighters in bathroom. Need an electrician to wire each one as a bit more fiddly than the ones I'm replacing. Replacing white lights (one of which has blown) with black ones. Needs a bit of fiddling with wires from connecting junction, but shouldn't be too difficult

Replace 4 downlights with new ones

Door frame fit, Dow light with casing replaced and the shower door fixed

A recessed LED downlight has dropped from the ceiling. The spring retention clip isn't holding the fitting in place, and the fixture needs to be re-secured or the clip replaced

Changing of bathroom LED downlight. The current light installed is Firestay LED downlight

Changing LED downlight, specifically an older Ansell integrated LED fire-rated downlight — model AORBLED/WW (warm white). The label suggests it’s part of the “Orbio” range. There’s 7 that need changing.

Need a qualified electrician to replace an old broken bathroom ceiling light fitting. The current fitting is an old recessed compact fluorescent downlight. The cover/diffuser is broken and missing, leaving the bulb/ballast/wiring area exposed. The light is on the same circuit/switch as other lights, so I would like the faulty fitting safely replaced rather than just disconnected if possible. Job required: Remove old recessed fluorescent fitting Supply and install a suitable modern LED replacement (warm light bulb) Replacement must be appropriate for a bathroom/shower-room environment. Check wiring/connection is safe Make sure the other lights on the same circuit continue working properly Location: N7 9RE Timing: ASAP preferred Thank you very much!

I need to replace the ground floor ceiling lights, a total of 25, in a mid-terrace house in south west London.

Replace around 50 GU10 bulbs in celling woth new bulbs (i have these here).

Replace 4x bathroom downlights. Lights already purchased and fit in holes. Some rewiring required. Attached photos of old light connectors and new ones.

My whole flat has spotlights and one lightbulb needs changing, I tried but I couldn’t, it looks like an integrated LED downlight.

3 downlights need changing and I’m struggling to remove them from the ceiling myself. Also not sure which replacement is needed as I can’t check

Hi, I’m looking for help replacing a ceiling downlight that’s no longer working. What needs doing: - Inspect the downlight and identify the correct bulb type (I’m not sure what it requires) - Source a suitable replacement bulb - Install the new bulb and ensure the light is working properly

14 old transformer spotlights in kitchen to be changed over to mains powered GU10 adjustable spotlights. No access above ceiling due to tiled bathroom floor, so wiring needs to be fished through existing lighting holes. All lighting fixtures and cable will be purchased separately so quoted price is just for labour.