Find a trusted local electrician in London

Kitchen light install and Dimmer switch Shed light install and Dimmer switch x 2 Spur for electrical fire Install new extractor fan

Electrician - 6 Electric sockets need to be replaced as some have come away from the wall or have stopped working. Hall stairs light fixture requires replacement and ring doorbell needs to be wired in. Replacement and set up of Phillips Hue bulbs.

I need to replace my current light fixture with an electrical ceiling fan with light. The fan needs to be installed in the living room on the ground floor.

Ac unit not working - was working fine. Samsung brand

Measure the door opening/gap accurately Supply or advise on a clear acrylic/polycarbonate panel Cut a circular hole for the AC exhaust hose adapter Fit the panel securely with a good seal around the edges Make it removable, as this is a rented flat Avoid drilling into the door/frame if possible

I need an split air conditioning unit to be installed in my flat. Around 3 meter of pipes also needed. We are flexible with installation date. Please share your qoute. Thanks

Fix wall socket in kitchen

Remedial electrical work required along with EICR cert. I do not require assessment as all remedial work is already listed in the electrical report attached. Please give quote for work with EICR cert included after completion of work. Property is a 2 bedroom maisonette The installation is unsatisfactory for continued safe operation. Service head is secured and free from mechanical damage with no sign of deterioration. Main earthing and bonding are in place with low continuity measurements taken. The DB enclosure is constructed of combustible material. No circuits are protected with additional protection via 30mA RCD modules. Connection between conductor and overload protective devices is satisfactory. PVC/PVC cabling is satisfactory for continued use. Accessories show no signs of significant damage or deterioration. It will require a 10 way CCU consumer unit. Full report details can be shared if required as unable to load to the platform.

You must be a plumber or a heating engineer. Boiler diagnosis completed as follows below and need someone to replace both parts. Parts to be ordered separately and not included in price here. - system pressure was low. I topped up the pressure and reset the boiler; however, the boiler still failed to fire. The appliance was displaying the fault code shown in the photographs provided. I referred to the manufacturer's instructions, which identify this fault as relating to the gas valve. I then contacted the manufacturer directly to confirm, and they advised that the fault is associated with the gas valve and ignition electrodes, with replacement of these components being the recommended course of action. The active fault codes displayed on the front of the boiler provide a clear indication of the fault condition being detected by the appliance, and the manufacturer has confirmed that these codes relate to the gas valve and ignition electrodes.

My dog peed on the floor sockets, that caused electricity shortages in my flat. Looking for an electrician to help me find out what part is broken and replace them.

One of the switches in the fuse box keeps tripping

I’m planning to get a small sauna + hot tub in the garden and would like to get a quote for the electric works. Sauna: Likely heater requirement around 4.5kW (to be confirmed by supplier). I'll likely require: •⁠ ⁠Dedicated outdoor supply for sauna •⁠ ⁠SWA armoured cable to rear garden •⁠ ⁠Outdoor rotary isolator switch •⁠ ⁠Hardwired sauna connection preferred Also installing: •⁠ ⁠Lay-Z-Spa hot tub (plug & play) •⁠ ⁠Weatherproof outdoor socket required nearby •⁠ ⁠Optional low-level garden lighting What I require: •⁠ ⁠whether the current consumer unit can support this •⁠ ⁠recommended cable route •⁠ ⁠whether trenching is required •⁠ ⁠estimated cost - assumed based on visit SWA needs to run from the consumer unit out to the garden. The cost offered is just an Airtasker placeholder and final cost to be determined upon site visit. When you put your offer in please apply with your standard day rate.

Hi, I need a registered electrician to inspect, test, and sign off on two recent installations for Building Control compliance. ​The items to be certified are: ​A newly installed bathroom extractor fan ​Interlinked, mains-powered smoke/heat alarms. ​The work is already physically done, but I need a qualified professional who can test the installations, issue the Minor Electrical Installation Works Certificates. Thank you!

Need a qualified electrician to replace an old broken bathroom ceiling light fitting. The current fitting is an old recessed compact fluorescent downlight. The cover/diffuser is broken and missing, leaving the bulb/ballast/wiring area exposed. The light is on the same circuit/switch as other lights, so I would like the faulty fitting safely replaced rather than just disconnected if possible. Job required: Remove old recessed fluorescent fitting Supply and install a suitable modern LED replacement (warm light bulb) Replacement must be appropriate for a bathroom/shower-room environment. Check wiring/connection is safe Make sure the other lights on the same circuit continue working properly Location: N7 9RE Timing: ASAP preferred Thank you very much!

I’m looking for a qualified electrician who is able to do emergency lighting in 2 storage building. I will need about 6 emergency lights in the stairs .

Replace 4x double switches for double dimmers

There is a specific switch on the circuit that is tripping the electricity. Need someone to come have a look and identify the issue, advise and fix.

Electrician to install new Electric Cooker

Secondhand bed frame, largely assembled, but some of the larger screws won't go in further using hand screwdriver; power tool needed to get them fixed properly

Heya, I would like someone to install my new electrical cooker I have received today. I do not have any new parts or tools for it as it is a new built properly.