Find experienced local tradies in Inner South Melbourne

Supply and install 2 x dble PowerPoints and 1 x Fluro light in factory kitchen

Please install my awning onto my roof racks of ford transit van. Weighs approximately 20kgs. Has all brackets required.

Photos will probably describe better than I can The heater needs “a 15A plug and 15A cable” It would be good if there could also be a 10A plug put in for the sauna light It’s within my garage and just next to the switchboard so hopefully very easy access

New 4mx3 m outside Awning Motorised ( no power connection required). Mostly assembled

Need walls and ceiling lined in laundry

Brick fireplace outer needs rendering. Squared off / made good all edges so everything is neat and clean. Inside to be left as is. Surrounded by carpet, need someone very detail oriented and careful.

Scope of work: -Supply and install a 15A weatherproof outdoor GPO (IP-rated, suitable for outdoor use) -Switchboard is located internally and less than 5m from proposed location of GPO (on opposite side of meter in photo) -Install on external wall under verandah (protected but still exposed to elements) -Ensure circuit is suitable for continuous EV charging load -Upgrade circuit/breaker if required (please advise if additional costs apply) -Test and ensure safe operation Requirements: -Must be a qualified and licensed electrician (VIC) -Must provide a Certificate of Electrical Safety (Compliance Certificate) upon completion -All work must comply with Australian standards

Install a power Point for TV Install a TV wall mount Bracket & TV I need you to supply power point please must be an electrician to do all please

Install power point on wall by dining table - available point behind microwave or around corner in euro laundry. Flat roof/ lack of access I think. May need two more after first installed and complexity confirmed

Secure two mounting brackets for outdoor security cameras to concrete rendered wall on the exterior of a house - one is on a hollow rendered facade and the other on rendered brick

Two areas to plaster. Fridge area (it’s sheeted I just don’t have a photo) just needs to be finished ready to paint. The other wall need to be finished both sides but needs tear off stopping bead for the edges as the wall may eventually be removed in the future. Also the ladder in the photo will be available for you to use for the high sections.

They did a quick touch up on some skuff. Marks door scratches have the paint.Don't have any equipment.needs to be a quick job. Must be completed before 5 pm

Need two holes fill in drywall and spot paint front door.

Looking for a neat plasterer to patch and make good areas where building retrofits took place. Entire house, a bunch of small repairs to be patched and skimmed/ sanded near for paint finish. Materials to be supplied, won’t need much. Happy to discuss further but need someone to work near unsupervised Need dome asap. Quiet ready site with water and toilet

4 small welds required to secure the Wrout iron balustrade. Photos attached.

I have 2 sections of my internal walls which need to be repaired. One section needs new framing, installation of plasterboard and skirting board. The other just needs installation of skirting board. I have purchased plasterboard, skirting and timber required.

Looking for a experienced plasterer to complete house Reno. Happy to agree on a hourly rate and will supply all materials. Labourer onsite to help hang plaster too.

Hi I need help to take apart, move it from the garage to the bedroom, and re-assemble my Sunlighten infra-red sauna

I need a small plastering job done in the next few weeks. A gas heater has been removed and capped off, and I now need a plasterer to patch and plaster the area where the heater was. The area to be plastered is approximately 180cm tall x 50cm wide. Looking for a neat, professional finish ready for painting. Standard residential unit with easy access.

*Edit: changed scope of work to include switchboard replacement* I am looking for a licensed electrician to: - Replace switchboard - Re-terminate all circuits - Install a dedicated 15A weatherproof outdoor power point that will be used for regular overnight EV charging - Investigate and fix an issue with one bedroom light that appears to be related to the circuit (light not working reliably / suspected wiring or circuit fault). Property details: - Single-storey weatherboard house - Outdoor installation location near driveway / parking area - There is already an existing light switch near the proposed power point location, which may help with access to the circuit or cable routing Scope of work: - Replace switchboard - Outdoor power point - Supply and install 1 × 15A outdoor-rated weatherproof socket (IP55 or similar) - Run new dedicated circuit from switchboard - Install appropriate RCD / RCBO protection - Secure cabling in conduit suitable for external wall - Test and certify installation Bedroom light - Diagnose fault (light fitting, switch, wiring, or circuit) - Repair or replace faulty components as required Please include your licence number in your response